Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
12 results
Search Results
Item The effect of substrate temperature on the structural, optical and electrical properties of vacuum deposited ZnTe thin films(2009) Rao, G.K.; Bangera, K.V.; Shivakumar, G.K.The present paper reports the effect of substrate temperature on the structural, optical and electrical properties of vacuum deposited zinc telluride (ZnTe) thin films. X-ray diffraction (XRD) analysis of the films, deposited on glass substrates, revealed that they have cubic structure with strong (111) texture. Room temperature deposits are tellurium rich and an increase in the substrate temperature up to 553 °K results in stoichiometric films. Electrical conductivity has been observed to increase with the increase in substrate temperature, accompanied by increase in the carrier concentration and the mobility of the carriers. The optical bandgap energy and the thermal activation energy of the films have also been evaluated. © 2009 Elsevier Ltd. All rights reserved.Item Growth, structural and optical properties of CdxZn1-xS thin films deposited using spray pyrolysis technique(2010) Raviprakash, Y.; Bangera, K.V.; Shivakumar, G.K.CdxZn(1-x)S (x = 0, 0.2, 0.4, 0.6, 0.8, and 1) thin films were deposited by the chemical spray pyrolysis technique using a less used combination of chemicals. Depositions were done at 573 K on cleaned glass substrates. The composition, surface morphology and structural properties of deposited films were studied using EDAX, SEM and X-ray diffraction technique. XRD studies reveal that all the films are crystalline with hexagonal (wurtzite) structure and inclusion of Cd into the structure of ZnS improved the crystallinity of the films. The value of lattice constant 'a' and 'c' have been observed to vary with composition from 0.382 to 0.415 nm and 0.625 to 0.675 nm, respectively. The band gap of the thin films varied from 3.32 to 2.41 eV as composition varied from x = 0.0-1.0. It was observed that presence of small amount of cadmium results in marked changes in the optical band gap of ZnS. © 2009 Elsevier B.V. All rights reserved.Item Studies on the photoconductivity of vacuum deposited ZnTe thin films(2010) Rao, K.G.; Bangera, K.V.; Shivakumar, G.K.The present paper reports the analysis of photoconductivity of vacuum deposited zinc telluride (ZnTe) thin films as a function of substrate temperature and post-deposition annealing. Detailed analyses were first carried out to understand the effect of substrate temperature and annealing on the structure, composition, optical and electrical properties of the films. The films deposited at elevated substrate temperatures showed faster and improved photoresponse. Post-deposition annealing was found to further enhance the photoresponse of the films. Attempts have been made to explain the improvement in the photoresponse on the basis of structural and compositional changes, taking place in the films, due to the substrate temperature and annealing. © 2010 Elsevier Ltd. All rights reserved.Item Properties of ZnO:Bi thin films prepared by spray pyrolysis technique(Elsevier Ltd, 2013) Sadananda Kumar, N.; Bangera, K.V.; Anandan, C.; Shivakumar, G.K.Undoped and Bi doped zinc oxide thin films were deposited on glass substrate at 450 °C using spray pyrolysis technique. The X-ray diffraction studies shows that Bi doped ZnO films are polycrystalline hexagonal structure with a preferred orientation along (101) direction. Crystallites size of the films decreases with increasing doping concentration. Scanning electron microscope image shows change in the surface morphology. The composition of Zn, O and Bi elements in the undoped and Bi doped ZnO films were investigated by X-ray photoelectron spectroscopy. Bi doped ZnO thin films show a transparency nearly 75% in the visible region. The optical band gap of ZnO thin films reduces from 3.25 eV to 3.12 eV with an increase in Bi concentration from 0 to 5at.% respectively. Electrical conductivity of ZnO thin films increased from 0.156 to 6.02S/cm with increasing Bi dopant concentration from 0% to 5% respectively. © 2013 Elsevier B.V. All rights reserved.Item Influence of substrate temperature and post deposition annealing on the properties of vacuum deposited ZnSe thin films(2013) Rao, K.; Bangera, K.V.; Shivakumar, G.K.The effects of substrate temperature and post deposition annealing on the structural, optical and electrical properties of vacuum deposited ZnSe thin films are presented here. The chemical composition of the films varied drastically with substrate temperature which in turn caused changes in various properties of the films. The grain size of the films increased with substrate temperature and also after annealing. The electrical properties of the films were found to be varying as a function of chemical composition and grain size. © 2012 Elsevier Ltd.Item Effect of annealing on the properties of Bi doped ZnO thin films grown by spray pyrolysis technique(Academic Press, 2014) Sadananda Kumar, N.; Bangera, K.V.; Shivakumar, G.K.The effect of annealing temperature on the structural, optical and electrical properties of transparent and conducting Bi doped ZnO (BZO) films deposited on glass substrate by spray pyrolysis technique was investigated. The BZO thin films were annealed in the temperature range from 450 °C to 550°C for 4 h in air atmosphere. The grain size of the BZO films increased with increasing annealing temperature. The annealed BZO films were electrically stable and there was a drastic change in the electrical conductivity after annealing. The films annealed at 500°C showed better conductivity and optical transmittance. © 2014 Elsevier Ltd. All rights reserved.Item Effect of annealing on the properties of zinc oxide nanofiber thin films grown by spray pyrolysis technique(Springer Nature, 2014) Sadananda Kumar, N.; Bangera, K.V.; Shivakumar, G.K.Zinc oxide nanofiber thin films have been deposited on glass substrate by spray pyrolysis technique. The X-ray diffraction studies revealed that the films are polycrystalline with the hexagonal structure and a preferred orientation along (002) direction for films annealed for 1 h at 450 °C. Further increase in annealing time changes the preferred orientation to (100) direction. The scanning electron microscopic analysis showed the formation of ZnO nanofiber with an average diameter of approximately 800 nm for annealed films. The compositional analysis of nanofiber ZnO thin films were studied by time of flight secondary ion mass spectroscopy, which indicated oxygen deficiency in the films. The optical properties of annealed films have shown a variation in the band gap between 3.29 and 3.20 eV. The electrical conductivity of the as grown and annealed films showed an increase in the conductivity by two orders of magnitude with increase in annealing duration. © 2013, The Author(s).Item Band gap engineering of mixed Cd(1?x)Zn(x)Se thin films(Elsevier Ltd, 2017) Santhosh, T.C.M.; Bangera, K.V.; Shivakumar, G.K.This paper deals with band gap engineering in CdZnSe thin films. This was achieved by adding different amounts of zinc selenide (ZnSe) to cadmium selenide (CdSe). The weight percentage of ZnSe (x) was varied from 0 to 1 in steps of 0.2. The films were prepared using thermal evaporation technique. The structural analysis was carried out using X-ray diffraction. Surface morphology and elemental composition of the grown films was investigated using scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDS) respectively. As deposited cadmium selenide thin films were dark reddish in color, changes to lemon-yellow with increase in ZnSe concentration. Electrical transport studies have been carried out using two probe method. Resistivity of the mixed films increased with increase in ZnSe concentration and it shows semiconducting behavior. It is observed that activation energy for conduction increases from 0.39 eV to 0.85 eV with increase in ZnSe concentration. Optical properties of the films were analyzed from absorption and transmittance studies. It is observed that the optical band gap increases gradually from 1.67 eV to 2.60 eV as ‘x’ varied from 0 to 1. © 2017 Elsevier B.V.Item Structural, electrical and optical properties of stoichiometric In2Te3 thin films(Elsevier Ltd, 2017) Vallem, V.; Bangera, K.V.; Shivakumar, G.K.In2Te3 thin films were grown by thermal evaporation technique. The annealing of films played a major role to obtain stoichiometry, regardless of substrate temperature. Annealing at 300 ?C resulted in well oriented, mono-phased and nearly stoichiometric In2Te3 thin films. The variation in grain size of In2Te3 films associated with the substrate temperatures provides a significant control over the resistivity of the films, and the resistivity decreased with an increase in the grain size. The activation energy and optical band gap of stoichiometric In2Te3 films were found to be 0.01±0.005 eV and 0.99±0.02 eV, respectively. The absorption co-efficient of these films was found to be of the order of 105 cm?1. © 2016 Elsevier Ltd and Techna Group S.r.l.Item Effective role of thickness on structural, electrical and optical properties of lead sulphide thin films for photovoltaic applications(Elsevier Ltd, 2017) Veena, E.; Bangera, K.V.; Shivakumar, G.K.The n-type lead sulphide thin films were deposited at 350 °C substrate temperature on glass substrates using advanced spray pyrolysis technique. The thickness of the thin films played an important role to improve the properties of lead sulphide and to use in device fabrication apart from various deposition parameters. The films deposited at thickness of 520 nm resulted in a well oriented polycrystalline with face-centered cubic structure. An enhancement in the crystallite size with increase in film thickness was evidenced by XRD and SEM. The variation in crystallite size of films associated with different thickness provides a significant control over optical and electrical properties. The resistivity of the thin films decreased with an increase in thickness was of the order of 102 ? cm. The activation energy and optical band gap of the films deposited at optimized condition were found to be 0.20 eV and 1.22 eV, respectively. The absorption coefficient of the films was found to be 106 cm?1. Results prove that the lead sulphide films synthesized using spray technique appeal its adaptability for potential photovoltaic applications in solar cells. © 2017