Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
11 results
Search Results
Item Effect of substrate temperature on the structural and electrical properties of spray deposited lead sulfide thin films(Elsevier Ltd, 2016) Veena, E.; Bangera, K.V.; Shivakumar, G.K.Lead sulfide (PbS) thin films were prepared by chemical spray pyrolysis method using lead acetate and thiourea as precursors of Pb+2 and S-2 ions. X-ray diffraction (XRD) technique, scanning electron microscope (SEM) and EDAX analysis were used for structural, morphological and compositional characterization. XRD analysis shows that the films are cubic in nature with a preferred orientation along (2 0 0). EDAX analysis shows that films deposited at 150°C are sulfur rich. An increase in the substrate temperature results in a decrease in the sulfur content of the prepared film. It has been observed that thin films deposited at or above 225°C are smooth & uniform morphologically. Beyond a substrate temperature of 275°C, the films become discontinuous and non-uniform. However, the films are sulfur rich, even at 275°C. Electrical conductivity of prepared thin films have been measured using silver contacts in coplanar geometry. Films are n - type as confirmed by hot probe technique. The electrical conductivity at room temperature (25°C) was in the order of 10-4 Ω-1cm-1 and was found to increase with increase in temperature showing the semiconducting nature of the films with the band gap of 0.39 eV. © 2016 Elsevier Ltd.Item The effect of substrate temperature on the structural, optical and electrical properties of vacuum deposited ZnTe thin films(2009) Rao, G.K.; Bangera, K.V.; Shivakumar, G.K.The present paper reports the effect of substrate temperature on the structural, optical and electrical properties of vacuum deposited zinc telluride (ZnTe) thin films. X-ray diffraction (XRD) analysis of the films, deposited on glass substrates, revealed that they have cubic structure with strong (111) texture. Room temperature deposits are tellurium rich and an increase in the substrate temperature up to 553 °K results in stoichiometric films. Electrical conductivity has been observed to increase with the increase in substrate temperature, accompanied by increase in the carrier concentration and the mobility of the carriers. The optical bandgap energy and the thermal activation energy of the films have also been evaluated. © 2009 Elsevier Ltd. All rights reserved.Item Study of the aluminium oxide doped zinc oxide thin films prepared by thermal evaporation technique(2012) Palimar, S.; Banger, K.V.; Shivakumar, G.K.The present study reports the observations made on investigations carried out to study structural, optical and electrical properties of aluminium oxide doped ZnO thin films obtained by thermal evaporation technique. Films obtained are found to be amorphous in nature with smooth and continuous surface. Room temperature conductivity of the film is found to be 5x10 3 U -1 cm -1 with visible region transmittance of above 95%. The optical energy gap of the film is found to be 3.25 eV. From the calculations of activation energy, it is observed that the doped ZnO film has two donor levels, one at 142 meV and other at 43 meV. A detailed analysis of the result is reported. © 2012 Asian Network for Scientific Information.Item Properties of ZnO:Bi thin films prepared by spray pyrolysis technique(Elsevier Ltd, 2013) Sadananda Kumar, N.; Bangera, K.V.; Anandan, C.; Shivakumar, G.K.Undoped and Bi doped zinc oxide thin films were deposited on glass substrate at 450 °C using spray pyrolysis technique. The X-ray diffraction studies shows that Bi doped ZnO films are polycrystalline hexagonal structure with a preferred orientation along (101) direction. Crystallites size of the films decreases with increasing doping concentration. Scanning electron microscope image shows change in the surface morphology. The composition of Zn, O and Bi elements in the undoped and Bi doped ZnO films were investigated by X-ray photoelectron spectroscopy. Bi doped ZnO thin films show a transparency nearly 75% in the visible region. The optical band gap of ZnO thin films reduces from 3.25 eV to 3.12 eV with an increase in Bi concentration from 0 to 5at.% respectively. Electrical conductivity of ZnO thin films increased from 0.156 to 6.02S/cm with increasing Bi dopant concentration from 0% to 5% respectively. © 2013 Elsevier B.V. All rights reserved.Item Effect of annealing on the properties of Bi doped ZnO thin films grown by spray pyrolysis technique(Academic Press, 2014) Sadananda Kumar, N.; Bangera, K.V.; Shivakumar, G.K.The effect of annealing temperature on the structural, optical and electrical properties of transparent and conducting Bi doped ZnO (BZO) films deposited on glass substrate by spray pyrolysis technique was investigated. The BZO thin films were annealed in the temperature range from 450 °C to 550°C for 4 h in air atmosphere. The grain size of the BZO films increased with increasing annealing temperature. The annealed BZO films were electrically stable and there was a drastic change in the electrical conductivity after annealing. The films annealed at 500°C showed better conductivity and optical transmittance. © 2014 Elsevier Ltd. All rights reserved.Item Effect of annealing on the properties of zinc oxide nanofiber thin films grown by spray pyrolysis technique(Springer Nature, 2014) Sadananda Kumar, N.; Bangera, K.V.; Shivakumar, G.K.Zinc oxide nanofiber thin films have been deposited on glass substrate by spray pyrolysis technique. The X-ray diffraction studies revealed that the films are polycrystalline with the hexagonal structure and a preferred orientation along (002) direction for films annealed for 1 h at 450 °C. Further increase in annealing time changes the preferred orientation to (100) direction. The scanning electron microscopic analysis showed the formation of ZnO nanofiber with an average diameter of approximately 800 nm for annealed films. The compositional analysis of nanofiber ZnO thin films were studied by time of flight secondary ion mass spectroscopy, which indicated oxygen deficiency in the films. The optical properties of annealed films have shown a variation in the band gap between 3.29 and 3.20 eV. The electrical conductivity of the as grown and annealed films showed an increase in the conductivity by two orders of magnitude with increase in annealing duration. © 2013, The Author(s).Item Properties of CdxZn1-xO thin films and their enhanced gas sensing performance(Elsevier Ltd, 2017) Bharath, S.P.; Bangera, K.V.; Shivakumar, G.K.CdxZn1-xO(0 ? x ? 0.20) thin films with different Cd concentrations were successfully deposited on glass substrate using spray pyrolysis technique. X-ray diffraction (XRD), scanning electron microscope (SEM) and energy dispersive X-ray analysis (EDAX) were used for structural, surface morphological and compositional characterization. The XRD analysis revealed that the synthesized films were hexagonal in structure with (002) orientation. The SEM studies confirm the formation of homogeneous and uniform films. Optical transmittance and electrical conductivity of the films were evaluated using UV–Visible spectroscopy and two probe method respectively. The optical studies showed that the CdxZn1-xO thin films have optical transmittance in entire visible region. The resistivity of undoped films were very high and it decreases with addition of cadmium. The gas sensing properties were investigated at optimal temperature of 350 °C for various volatile organic compounds like acetone, ethanol and methanol. The CdxZn1-xO thin films with 10 at. % cadmium concentration showed the sensitivity of 50% for 1 ppm ethanol. © 2017 Elsevier B.V.Item Effect of annealing on the properties of spray-pyrolysed lead sulphide thin films for solar cell application(Springer Verlag service@springer.de, 2017) Veena, E.; Bangera, K.V.; Shivakumar, G.K.Annealing is the most important processing parameter perhaps as it directly affects the properties of the thin films. In the present article, lead sulphide thin films composed of (2 0 0) plane-oriented nano-rods were successfully synthesized on glass substrates using spray pyrolysis technique at annealing temperature 350 °C. Films were characterized using X-ray diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive analysis by X-ray (EDAX), UV–VIS–NIR spectrometry and two-probe experiments. The X-ray diffraction study confirmed that films exhibiting face-centred cubic structure with a preferred orientation along (2 0 0) plane were independent of annealing temperature. SEM photographs revealed the formation of nano-rods. The possible formation of nano-rods and its dependency on optical and electrical properties were discussed. Chemical composition in terms of atomic ratio of the constituents is determined from EDAX studies. The optical band gap of the lead sulphide thin films was found to decrease from 1.22 to 0.98 eV with an increase in annealing temperature. The electrical conductivity of the films at room temperature was of the order of 10?2 ??1 cm?1 with the low activation energy. Results prove that lead sulphide films grown by chemical method appeal its adoptability for potential solar cell applications. © 2017, Springer-Verlag Berlin Heidelberg.Item Effect of indium content on the characteristics of indium tin oxide thin films(Institute of Physics Publishing helen.craven@iop.org, 2018) Navya, K.; Bharath, S.P.; Bangera, K.V.; Shivakumar, G.K.Transparent IxT1-xO (x = 0 to 1) alloyed thin films were deposited by spray pyrolysis technique at a substrate temperature of 400 °C. The effect of incorporation of indium on structural, optical and electrical properties of tin oxide thin films were studied. Characterization of thin films was carried out using x-ray diffraction (XRD), scanning electron microscopy (SEM), energy dispersive x-ray spectroscopy (EDAX), UV-Visible absorption spectroscopy. XRD results revealed that IxT1-xO thin films were polycrystalline in nature with good crystallinity. Incorporation of indium effectively modifies the surface morphology of the films. The band gap was varied from 3.7 eV to 3 eV. Maximum electrical conductivity of 44.52 × 103 ?-1 m-1 and transmittance of 90% is obtained for I0.5T0.5O films, hence can be used as highly transparent and conducting electrodes. © 2018 IOP Publishing Ltd.Item Enhanced gas sensing properties of indium doped ZnO thin films(Academic Press, 2018) Bharath, S.P.; Bangera, K.V.; Shivakumar, G.K.Indium doped ZnO (InxZn1-xO, 0 ? x ? 0.05) thin films were deposited on to soda lime glass substrate by employing spray pyrolysis as deposition technique. Effect of doping concentration on characteristics of thin films were examined by XRD, SEM, UV-Visible spectroscopy, electrical and gas sensing measurements. XRD analysis demonstrates polycrystalline nature of thin films and also shows the shift in orientation from (002) to (101) crystal plane with increase in indium doping concentration. Surface morphological analysis shows the formation of homogeneous particle like nanostructures. Optical transmittance determined from UV-Visible spectroscopy was in the range of 80–95%, which was decreasing with increase in indium doping concentration. Maximum electrical conductivity was achieved at an optimal indium doping concentration of 3 at.%. The gas sensing properties were examined for different concentration of volatile organic compounds like acetone, ethanol and methanol for different doping levels. In0.03Zn0.97O thin films showed good sensitivity towards ethanol, with sensitivity of 30% towards 25 ppm of ethanol. © 2018 Elsevier Ltd