Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
70 results
Search Results
Item Corrosion behavior of composition modulated multilayer Zn-Co electrodeposits produced using a single-bath technique(2009) Thangaraj, V.; Eliaz, N.; Hegde, A.Composition modulated alloy (CMA) electrodeposits of Zn-Co were produced from acid chloride baths by the single-bath technique. Their corrosion behavior was evaluated as a function of the switched cathode current densities and the number of layers. The process was optimized with respect to the highest corrosion resistance. Enhanced corrosion resistance was obtained when the outer layer was slightly richer with cobalt. At the optimum switched current densities 40/55 mA cm-2, a coating with 600 layers showed ~6 times higher corrosion resistance than monolithic Zn-Co electrodeposit having the same thickness. The CMA coating exhibited red rust only after 1,130 h in a salt-spray test. The increased corrosion resistance of the multilayer alloys was related to their inherent barrier properties, as revealed by Electrochemical Impedance Spectroscopy. The corrosion resistance was explained in terms of n-type semiconductor films at the interface as supported by Mott-Schottky plots. © 2008 Springer Science+Business Media B.V.Item Electrodeposition and characterization Zn-Co alloy(2009) Hegde, A.; Thangaraj, V.The present work details optimization of a stable acid chloride bath for electroplating of bright Zn-Co alloy on mild steel using gelatin and glycine as additives. It was found that the addition of gelatin along with glycine changed the deposition pattern markedly. A suitable bath has been formulated using conventional Hull cell experiments. The bath under plating conditions were found to exhibit anomalous codeposition with preferential deposition of less noble (zinc) over more noble (cobalt) as characterized by Zn-Fe group metal alloys. Investigation revealed that the current density (c.d.), temperature, and pH of the bath have strong effect on the composition of the deposit. Influence of bath constituents and operating parameters on appearance and composition of deposits were studied as measure of their performance against corrosion. A variety of deposits were obtained and their corrosion resistances were measured by Tafel method with/without chrome passivation. Experimental results demonstrated the fact that the corrosion resistances of Zn-Co alloys increased with percent of Co in the deposit except at very high c.d. This is due to the fact at very high c.d. the deposit becomes very porous and thick as evidenced by SEM image. The formation of Zn-Co alloy is confirmed by EDAX analysis. A stable chloride bath for Zn-Co alloy deposition has been proposed and discussed. The formation of passive film on chromatization is indicated by almost same E corr value of all Zn-Co electroplates irrespective of the current densities at which they have been deposited. © 2009 Pleiades Publishing, Ltd.Item The effect of substrate temperature on the structural, optical and electrical properties of vacuum deposited ZnTe thin films(2009) Rao, G.K.; Bangera, K.V.; Shivakumar, G.K.The present paper reports the effect of substrate temperature on the structural, optical and electrical properties of vacuum deposited zinc telluride (ZnTe) thin films. X-ray diffraction (XRD) analysis of the films, deposited on glass substrates, revealed that they have cubic structure with strong (111) texture. Room temperature deposits are tellurium rich and an increase in the substrate temperature up to 553 °K results in stoichiometric films. Electrical conductivity has been observed to increase with the increase in substrate temperature, accompanied by increase in the carrier concentration and the mobility of the carriers. The optical bandgap energy and the thermal activation energy of the films have also been evaluated. © 2009 Elsevier Ltd. All rights reserved.Item Preparation and characterization of CdxZn1-xS thin films by spray pyrolysis technique for photovoltaic applications(2009) Raviprakash, Y.; Bangera, K.V.; Shivakumar, G.K.CdxZn(1-x)S (x = 0, 0.2, 0.4, 0.6, 0.8, and 1) thin films were deposited by the chemical spray pyrolysis technique using a less used combination of chemicals. Depositions were done at 573 K on cleaned glass substrates. The composition, surface morphology and structural properties of deposited films were studied using EDAX, SEM and X-ray diffraction technique. XRD studies reveal that all the films are crystalline with hexagonal (wurtzite) structure and inclusion of Cd into the structure of ZnS improved the crystallinity of the films. In the entire compositions, the (0 0 2) diffraction peak is prominent which gives lattice matching to the chalcogenide semiconductor such as CuInxGa1-xSe2 and CuIn (s1-xSex)2, which are used in photovoltaic devices. The value of lattice constant 'a' and 'c' have been observed to vary with composition from 0.382 to 0.415 nm and 0.625 to 0.675 nm, respectively. The band gap of the thin films varied from 3.32 to 2.41 eV as composition varied from x = 0.0 to 1.0. It was observed that presence of small amount of cadmium results in marked changes in the optical band gap of ZnS. © 2009 Elsevier Ltd. All rights reserved.Item Growth, structural and optical properties of CdxZn1-xS thin films deposited using spray pyrolysis technique(2010) Raviprakash, Y.; Bangera, K.V.; Shivakumar, G.K.CdxZn(1-x)S (x = 0, 0.2, 0.4, 0.6, 0.8, and 1) thin films were deposited by the chemical spray pyrolysis technique using a less used combination of chemicals. Depositions were done at 573 K on cleaned glass substrates. The composition, surface morphology and structural properties of deposited films were studied using EDAX, SEM and X-ray diffraction technique. XRD studies reveal that all the films are crystalline with hexagonal (wurtzite) structure and inclusion of Cd into the structure of ZnS improved the crystallinity of the films. The value of lattice constant 'a' and 'c' have been observed to vary with composition from 0.382 to 0.415 nm and 0.625 to 0.675 nm, respectively. The band gap of the thin films varied from 3.32 to 2.41 eV as composition varied from x = 0.0-1.0. It was observed that presence of small amount of cadmium results in marked changes in the optical band gap of ZnS. © 2009 Elsevier B.V. All rights reserved.Item Studies on the effect of pH, temperature and metal ions on the production of pectinase from tamarind kernel powder by submerged fermentation using Aspergillus foetidus (NCIM 505)(2010) JagadeeshBabu, P.E.; Viswanathan, R.Filamentous fungi Aspergillus foetidus NCIM 505 was studied for its capacity to produce exo-pectinase in submerged fermentation (SMF) from a new substrate of tamarind kernel powder (TKP). The process was further studied to optimize the initial operating variables like pH, time and temperature. Maximum pectinolytic activity was reached at 72 h of growth and the best fungal strain was found to be A. foetidus NCIM 505. Further, to increase the production rate of pectinase, the effects of metal ions were studied. Metal ions like Cu ++, Mg++, Fe++, Co++ and Zn ++ at different concentrations were used. © 2009 Curtin University of Technology and John Wiley & Sons, Ltd.Item Nano ZnO-activated carbon composite electrodes for supercapacitors(2010) Muthu, M.S.; Bhat, D.K.; Aggarwal, A.; Prahladh Iyer, S.; Sravani, G.A symmetrical (p/p) supercapacitor has been fabricated by making use of nanostructured zinc oxide (ZnO)-activated carbon (AC) composite electrodes for the first time. The composites have been characterized by field emission scanning electron microscopy (FESEM) and X-ray diffraction analysis (XRD). Electrochemical properties of the prepared nanocomposite electrodes and the supercapacitor have been studied using cyclic voltammetry (CV) and AC impedance spectroscopy in 0.1 M Na2SO4 as electrolyte. The ZnO-AC nanocomposite electrode showed a specific capacitance of 160 F/g for 1:1 composition. The specific capacitance of the electrodes decreased with increase in zinc oxide content. Galvanostatic charge-discharge measurements have been done at various current densities, namely 2, 4, 6 and 7 mA/cm2. It has been found that the cells have excellent electrochemical reversibility and capacitive characteristics in 0.1 M Na2SO4 electrolyte. It has also been observed that the specific capacitance is constant up to 500 cycles at all current densities. © 2010 Elsevier B.V. All rights reserved.Item Synthesis, characterization of N, N?-bis(2-hydroxynaphthalidene) phenylene- 1,2-diamine with M(II)(M = Ni, Zn and Fe) Schiff-base complexes and their non-linear optical studies by z-scan technique(Elsevier B.V., 2010) Kumar, H.C.S.; Badekai Ramachandra, B.; Rudresha, B.J.; Ravindra, R.; Philip, R.Schiff-base complexes of N,N?-bis(2-hydroxynaphthalidene)phenylene-1, 2-diamine ligand with metal M (M = Ni(II), Zn(II) and Fe(II)) have been synthesized and characterized by their UV, FT-IR, NMR, elemental analysis and magnetic susceptibility measurements. Non-linear optical measurements carried out using nanosecond laser pulses at 532 nm show that these complexes can be used for optical limiting applications. © 2010 Elsevier B.V. All rights reserved.Item Studies on the photoconductivity of vacuum deposited ZnTe thin films(2010) Rao, K.G.; Bangera, K.V.; Shivakumar, G.K.The present paper reports the analysis of photoconductivity of vacuum deposited zinc telluride (ZnTe) thin films as a function of substrate temperature and post-deposition annealing. Detailed analyses were first carried out to understand the effect of substrate temperature and annealing on the structure, composition, optical and electrical properties of the films. The films deposited at elevated substrate temperatures showed faster and improved photoresponse. Post-deposition annealing was found to further enhance the photoresponse of the films. Attempts have been made to explain the improvement in the photoresponse on the basis of structural and compositional changes, taking place in the films, due to the substrate temperature and annealing. © 2010 Elsevier Ltd. All rights reserved.Item Electrolytic preparation of cyclic multilayer Zn-Ni alloy coating using switching cathode current densities(2010) Venkatakrishna, K.; Hegde, A.C.Cyclic multilayer alloy (CMA) coating of Zn-Ni was developed on mild steel using single bath technique, by proper manipulation of cathode current densities. The thickness and composition of the individual layers were altered precisely and conveniently by cyclic modulation of cathode current densities. Multilayer coatings, having sharp change in compositions were developed using square current pulses. Gelatin and sulphanilic acid (SA) acid were used as additives. Laminar deposits with different configurations were produced, and their corrosion behaviors were studied, in 5% NaCl solution by electrochemical methods. It was observed that the corrosion resistance of CMA coating increased progressively with number of layers (up to certain optimal numbers) and then decreased. Cyclic voltammetry study demonstrated the role of gelatin and SA in multilayer coating. The coating configuration has been optimized for the peak performance against corrosion. The substantial decrease of corrosion rate, in the case of multilayer coatings was attributed to the changed intrinsic electric properties, evidenced by Electrochemical Impedance Spectroscopy (EIS) study. The surface morphology and its roughness were examined by Atomic Force Microscopy (AFM). The surface and cross-sectional view of coatings were examined, using Scanning Electron Microscopy (SEM). X-ray photoelectron spectrum (XPS) study was carried out for surface analysis. The relative performance of pure Zn, monolithic and CMA coatings were compared and discussed. © 2010 Springer Science+Business Media B.V.