Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Kumar, G.N.Subject: search.filters.subject.Carbon monoxide

Search Results

Now showing 1 - 8 of 8
  • No Thumbnail Available
    Item
    Effect of exhaust gas recirculation (EGR) on diesel engine using Simarouba glauca biodiesel blends
    (Regional Energy Resources Information Center (RERIC) enreric@ait.ac.th, 2015) Bedar, P.; Pandey, J.K.; Kumar, G.N.
    This article deals with the usage of non-edible Simarouba glauca (paradise) oil as a biodiesel for single cylinder diesel engine with application of exhaust gas recirculation (EGR) rates. Biodiesel blends B10, B20 with EGR rates of 10%, 15%, and 20% are used for different load conditions. Parameters like brake thermal efficiency (BTE), nitrogen oxides (NOx), carbon monoxide (CO), hydrocarbons (HC) and smoke opacity were evaluated from the experimental study. The results show that Simarouba glauca biodiesel usage decreases HC, CO and smoke emissions with slight increase of NOx, also an improvement in the performance was observed for B10 blend. EGR rates 10% and 15% are beneficiated in terms of performance and emission but negative trend is observed for 20% EGR rate. On the whole it is concluded that a better trade-off between NOx and other emissions is attained with simultaneous application of EGR (15%) and biodiesel blend (B10) without compromising engine performance.
  • No Thumbnail Available
    Item
    Experimental Investigation of Variations in Spark Timing using a Spark-Ignition Engine with Hydrogen-Blended Gasoline
    (Wiley-VCH Verlag info@wiley-vch.de, 2015) Shivaprasad, K.V.; Chitragar, P.R.; Kumar, G.N.
    This study describes an experiment conducted using an electronically controllable single-cylinder high-speed gasoline engine to analyze the performance and emissions characteristics of various hydrogen-gasoline blends. The experiments have been conducted for various engine speeds and spark timings at the wide open throttle position. The experimental results revealed that the engine brake thermal efficiency and brake mean effective pressure first increase and then decrease with the increase engine speed at all spark timings. The minimum amount of brake specific energy consumption was observed for 20% hydrogen addition in the total fuel blend at 3000rpm engine speed and 14°crank angle (CA) before top dead center (BTDC) spark timing. Hydrocarbon and carbon monoxide emissions were reduced with the retardation of spark timings. Nitrogen oxide emissions were continuously increased with the addition of hydrogen in the fuel blend as well as spark timing advance. © 2015 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.
  • No Thumbnail Available
    Item
    Performance and emission analysis of a single cylinder CI engine using Simarouba glauca biodiesel
    (Springer Heidelberg, 2017) Bedar, P.; Chitragar, P.R.; Shivaprasad, K.V.; Kumar, G.N.
    It is well known fact that diesel engines are commonly used for transportation and power generation due to their high efficiency, low fuel consumption and durability. On contrary these engines churn out harmful and hazardous emissions like particulate matter (PM) and nitrogen oxides (NOx). Recently Bio-origin renewable fuels have taken center stage of discussion because of their ability to replace depleting fossil fuels and capacity to reduce hazardous engine exhausts emissions when used in diesel engines. In the present experimental study Simarouba glauca biodiesel is used in a naturally aspirated four stroke single cylinder air cooled direct injection kirloskar DA10 engine. The main objective is to investigate the effect of biodiesel and exhaust gas recirculation (EGR) on the performance and emission characteristics of a CI engine at 180 bar fuel injection pressure (FIP) with standard injection timing. B20, B40 biodiesel blends with 10, 15 and 20% EGR ratios were used for the study to investigate brake thermal efficiency (BTE), carbon monoxide (CO), unburned hydrocarbons (UBHC), NOx, and smoke opacity. Reduction in CO, HC and smoke opacity is noticed with simarouba biodiesel fuel while increasing NOx compared to diesel. Application of EGR along with biodiesel resulted in simultaneous reduction of nitrogen oxides and smoke without affecting engine performance. It was found from experiment that B20 blend at 15% EGR shown superior performance characteristics compared to other conditions. © Springer India 2017.
  • No Thumbnail Available
    Item
    Influence of Magneto-combustion on regulated emissions of an automotive engine under variable speed operation
    (MechAero Found. for Techn. Res. and Educ. Excellence office@mechaero.org, 2020) Oommen, L.P.; Kumar, G.N.
    The present study investigates the influence of magneto-combustion on the macro pollutants emitted from a multi point fuel injection (MPFI) automotive engine. The regulated emissions of an auto engine include carbon monoxide, un-burnt hydrocarbon (UBHC)and oxides of nitrogen (NOx) which are the by-products of internal combustion of the hydrocarbon fuel used. Depending upon the physiochemical characteristics of pollutants and their concentrations, these pollutants result in numerous physical ailments and mortality. Magneto-combustion is an under investigated technology which effectively reduces the emission of toxic vehicular exhaust. The exposure to an external magnetic field realigns the hydrocarbon structure and alters its combustion properties. The tests conducted on a Maruthi Zen MPFI engine under two different patterns of magnetisation resulted in a maximum reduction of carbon monoxide by 23.97%, UBHC by 13.1% and NOx by 5.23%, thereby reduced the cumulative negative impact on the environment. © 2020. MechAero Foundation for Technical Research & Education Excellence.
  • No Thumbnail Available
    Item
    Impact of 1-Hexanol/diesel blends on combustion, performance and emission characteristics of CRDI CI mini truck engine under the influence of EGR
    (Elsevier Ltd, 2020) Santhosh, K.; Kumar, G.N.
    Biofuels are the most promising sustainable and renewable alternative to diesel fuel. In the present renewable energy world, alcohols are gaining prime importance due to their nature of production and fuel properties. The present work aims to investigate the impact of 1-Hexanol and exhaust gas recirculation (10% and 20%) on engine characteristics of the common rail direct injection compression ignition engine. The experiment is carried out on a bench engine. The fraction of 1-Hexanol is varied from 10% to 40% in a step of 10% by volume. The results demonstrate that the use of 1-Hexanol/diesel blends lowers the cylinder pressure and mean gas temperature, which is 4.25% and 1.88% lower at 60% load for 40% 1-Hexanol compared to neat diesel fuel operation. The combustion duration is increased by 2.66?CA for 40% 1-Hexanol at 60% load compared to neat diesel fuel. However, an improvement in net heat release rate is noted which is 13.95% higher at 60% load for 40% 1-Hexanol, this increment is due to prolonged ignition delay. With the use of 1-Hexanol in the engine, there is a drastic reduction in nitrogen oxide emission is observed, this is the greatest impact of 1-Hexanol. However, a slight increment in the hydrocarbon and carbon monoxide emission is also noted due to poor fuel properties like lower cetane number, higher viscosity and higher latent heat of evaporation of 1-Hexanol. Compared to all other blends in the test 10% 1-Hexanol shows comparable results with pure diesel fuel, which is only 2.37% lower in brake thermal efficiency, 3.6% higher in brake specific fuel consumption, 17.55% lower in nitrogen oxide emission, 18.18% higher in hydrocarbon and 33.33% higher in carbon monoxide emission is noted. The exhaust gas recirculation helps in reducing the NOx emission, 40% 1-Hexanol is less sensitive to exhaust gas recirculation. Up to 40% of 1-Hexanol can be used in the CI engine without any modification. It is concluded that 1-Hexanol is a sustainable renewable biofuel due to the reason that even though the use of 1-Hexanol lowers the performance which helps in reducing the NOx emission greatly; the performance can be improved by modifying the engine parameters. © 2020 Elsevier Ltd
  • No Thumbnail Available
    Item
    The effect of tri-fuel blends on engine characteristics of a direct injection diesel engine with exhaust gas recirculation
    (Taylor and Francis Ltd., 2022) Santhosh, K.; Kumar, G.N.; Shahapur, S.
    Biofuels are the most promising alternative to petro-diesel. In this work, the combined effect of mahua biodiesel and 1-Hexanol is studied on the engine characteristics. The concentration of both 1-Hexanol and mahua biodiesel is varied, 10%, 20%, and 30% each with diesel fuel. Common rail direct injection diesel engine is used in this study. Engine load is varied from 20% to 80% in step of 20%, the speed of the engine is constant throughout the experiment. Biofuel blends showed improved cylinder pressure and mean gas temperature at a higher engine load. At 60% load, 10H10M80D (10% 1-Hexanol/10% mahua biodiesel/80% diesel) showed 3.45% lower thermal efficiency and 6.11% higher fuel consumption compared to diesel. At 60% load, all the biofuel blends showed 50% lower carbon monoxide emission. At 60% load, 10H10M80D showed 33.33% lower hydrocarbon emission and 0.96% higher nitrogen oxide emission compared to baseline readings. The biofuel blends are less sensitive to exhaust gas recirculation (EGR) due to the oxygenated nature of biofuels. With 20% EGR, at 60% load, 10H10M80D showed 39.48% lower nitrogen oxide compared to no EGR. The results of 10H10M80D showed the best performance at all loads. © 2022 Taylor & Francis Group, LLC.
  • No Thumbnail Available
    Item
    Experimental studies on the influence of axial and radial fields of sintered neo-delta magnets in reforming the energy utilization combustion and emission properties of a hydrocarbon fuel
    (Taylor and Francis Ltd., 2024) Oommen, L.P.; Kumar, G.N.
    Permanent magnets based on rare earth components have been increasingly finding their applications in modern technologies. Although the magnetic properties tend to deteriorate rapidly at temperatures in excess of 150ºC, sintered NdFeB magnets can be employed in reforming the physical and combustion properties of hydrocarbon fuels. In the present investigation, two different magnetization patterns of high-grade NdFeB magnets are applied in varying intensities on a multicylinder MPFI engine fueled by gasoline and the alteration in combustion and emission properties of the fuel are studied. The magnetic field restructures the hydrocarbon molecules and causes the pseudo clusters to break away thus reducing the inherent viscosity and enhancing the association of hydrocarbon molecules with the oxidizer. The effectiveness of two different magnetization patterns of sintered NdFeB magnetic material in reforming the combustion characteristics is studied and compared. The study shows a maximum increase of 9.2% in power output and 7.74% in thermal efficiency of the test engine along with a significant reduction in the generation of toxic emissions that are the byproducts of combustion. The study also concludes that radial magnetic fields are more effective in conditioning the fuel and reducing the emission of CO, HC, and NOx by 8.57%, 5.52%, and 1.25% compared to the same intensity fields under axial magnetization. The combustion behavior of gasoline is studied under both field patterns. The statistical analysis of mean effective pressures through radar plots is conclusive of the reduction in cycle by cycle variations under magnetic field-assisted combustion. Abbreviations: NdFeB:Neodymium Iron Boron permanent magnet; SmCo:Samarium Cobalt permanent magnet; MPFI:Multipoint Port Fuel injection; BP:Brake Power; BTE:Brake Thermal Efficiency; BSFC:Brake Specific Fuel Consumption; NHRR:Net Heat Release Rate; IMEP:Indicated Mean Effective Pressure; COV:Coefficient of Variation; CO:Carbon Monoxide; CO2:Carbon dioxide; HC: hydrocarbon; NOxOxides of Nitrogen. © 2020 Taylor & Francis Group, LLC.
  • No Thumbnail Available
    Item
    Experimental investigation and optimization of performance, emission, and vibro-acoustic parameters of SI engine fueled with n-propanol and gasoline blends using ANN-GA coupled with NSGA3-modified TOPSIS hybrid approach
    (Elsevier Ltd, 2024) Kirankumar, K.R.; Kumar, G.N.; Kamath, N.; Gangadharan, K.V.
    In the present study, performance, emission, and vibro-acoustic studies were conducted on a spark ignition (SI) engine fueled with gasoline and an n-propanol blend at variable compression ratio (CR), speed, and propanol blend fraction (PBF). Experimental data were used to model an artificial neural network (ANN) trained with a genetic algorithm (GA). ANN predictive responses were employed to establish regression relationships between brake power (BP), brake specific fuel consumption (BSFC), brake thermal efficiency (BTE), oxides of nitrogen (NOx), carbon monoxide (CO), hydrocarbon (HC), resultant vibration acceleration (RVA), and sound pressure level (SPL) with operating parameters using response surface methodology (RSM). These models served as objective functions in the non-dominated sorting genetic algorithm-3 (NSGA3), a multi-objective optimization (MOO) technique, to optimize responses and obtain non-dominated solutions. These solutions were filtered using a modified technique for order preference by similarity to the ideal solution (TOPSIS) to obtain a compromised optimal solution. ANN-GA model outcomes showed high accuracy, with coefficient of determination (R2) and root mean square error (RMSE) values ranging from 0.979 to 0.993 and 0.0381 to 0.0643, respectively. NSGA3 coupled with modified TOPSIS identified optimal operating conditions at 1271.77 RPM, a CR of 11.96, and a PBF of 33.26 %. © 2024 Elsevier Ltd