Conference Papers
Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/28506
Browse
2 results
Search Results
Item Effect of SiC Reinforcement on Microstructure and Mechanical Properties of Aluminum Metal Matrix Composite(Institute of Physics Publishing helen.craven@iop.org, 2018) Ajagol, P.; Anjan, B.N.; Marigoudar, R.N.; Preetham Kumar, G.V.Aluminum reinforced with silicon carbide composites areextensively used in automobile industries and aerospaceowing to their favourable microstructure and improved mechanical behaviour with respect to pure aluminium but at a lower cost. Aluminium is remarkable for the low density and its ability to resist corrosion. The aim of present study istoevaluate the mechanical and microstructural properties of aluminum with silicon carbide (average particle size 30-45μm) reinforced in varying weight percentages (wt %) ranging from 0-15 wt% in a step of 5% each. Ultimate tensile strength, micro hardness and density of the fabricated composites were investigated as a function of varying SiC wt%. Microstructure analysis was carried out on casted composites using optical microscopy and scanning electron microscopy. From micrographs it is clear that fair distribution of reinforcing particles in the matrix and also observed some clustering and porosity in the cast material. Results revealed that, the addition of SiC reinforcement in the aluminum matrix increases the hardness and ultimate tensile strength gradually from 23 HV to 47 HV and 84 MPa to 130 MPa respectively. © Published under licence by IOP Publishing Ltd.Item Influence of sic and al2o3 particulate reinforcement on the mechanical properties of za27 metal matrix composites(Trans Tech Publications Ltd ttp@transtec.ch, 2019) Anjan, B.N.; Preetham Kumar, G.V.Zinc aluminum based matrix composites reinforced with SiC and Al2O3 particles have significant applications in the automobile field. Stir casting method followed by squeeze process was used for fabrication. ZA27 composites reinforced with SiC and Al2O3 particles (20-50µm) in various weight percentage (wt%) ranges from 0-10 in a step of 5 each was fabricated. OM, SEM and EDS analysis of microstructures obtained for matrix alloy and reinforced composites were performed in order to know the effect of varying wt% on physical and mechanical properties of composites. Squeeze casting technique shows better features such as fine microstructure as a result of low porosity and good bonding between matrix and reinforcement. Addition of reinforcements decreased the densities of matrix alloy. SiC reinforced composites showed better results as compared with Al2O3 reinforced ones. Hardness and ultimate tensile strength value of 10 wt% reinforced composites showed improved results. © 2019 Trans Tech Publications Ltd, Switzerland.