Conference Papers

Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/28506

Browse

Author: search.filters.author.Nayak, J.Subject: search.filters.subject.Powder metallurgy

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    The influence of microwave sintering on the tribological performance of powder metallurgy based aluminum cenospheres composites
    (Trans Tech Publications Ltd ttp@transtec.ch, 2015) Ananda Kumar, M.G.; Seetharamu, S.; Sampath Kumaran, P.; Nayak, J.
    The Metal Matrix Composites (MMCs) especially Aluminum based systems have unique advantages of having superior mechanical, chemical and electrical properties, in addition to light weight and high stiffness. In this work, composites comprising of Aluminum with varied concentrations of Cenospheres as reinforcement was produced by Powder Metallurgy (PM) route. The densification of the composites was effected both by conventional and Microwave (MW) sintering techniques. The microstructures of the sintered samples were observed through scanning electron microscope (SEM) and phases by x ray diffraction technique (XRD), followed by evaluation of tribological parameter namely slide wear behavior and solid particle erosion resistance. The densities and the Brinell hardness values for the samples were also evaluated. The results showed that microwave sintered samples exhibited higher hardness, lower erosion and slide wear loss. © (2015) Trans Tech Publications, Switzerland.
  • No Thumbnail Available
    Item
    Effect of chromium addition on properties of sinter-forged Fe-Cu-C alloy steel
    (World Scientific Publishing Co. Pte Ltd wspc@wspc.com.sg, 2018) Kulkarni, V.R.; Nayak, J.; Dabhade, V.V.
    The present work deals with sinter-forged powder metallurgical (P/M) steels alloyed with chromium by addition of ferrochrome powder, which allows a close control over the chromium contents of alloy steels. Chromium contents can be varied by adjusting appropriately weighed ferrochrome powder in the P/M mixtures. Fe-Cu (2%) and C (0.7%) is the base composition for this P/M alloy steel. Study with the addition of 0.5% and 3% chromium by weight in the form of ferrochrome powder is carried out. The P/M alloy steel of base composition with no chromium content is also prepared for comparative study. The paper deals with these three alloy steels formed by the sinter-forging technique of powder metallurgy. The results of hardness and wear in hardened and tempered condition are reported in the present work. © 2018 World Scientific Publishing Company.