Journal Articles
Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/19884
Browse
2 results
Search Results
Item Numerical consideration of LTNE and darcy extended forchheimer models for the analysis of forced convection in a horizontal pipe in the presence of metal foam(American Society of Mechanical Engineers (ASME), 2021) Jadhav, P.H.; Gnanasekaran, N.; Arumuga Perumal, D.The intent of the current research work is to emphasize the computational modeling of forced convection heat dissipation in the presence of high porosity and thermal conductivity metallic foam in a horizontal pipe for different regimes of the fluid flow for a range of Reynolds number. A two-dimensional physical domain is considered in which Darcy extended Forchheimer (DEF) model is adopted in the aluminum metallic foam to predict the features of fluid flow and local thermal nonequilibrium (LTNE) model is employed for the analysis of heat transfer in a horizontal pipe for different flow regimes. The numerical results are initially matched with experimental and analytical results for the purpose of validation. The average Nusselt number for fully filled foam is found to be higher compared to other filling rate of metallic foams and the clear pipe at the cost of pressure drop. As an important finding, it has been observed that the laminar and transition flow gives higher heat transfer enhancement ratio and thermal performance factor compared to turbulent flow. This work resembles numerous industrial applications such as solar collectors, heat exchangers, electronic cooling, and microporous heat exchangers. The novelty of the work is the selection of suitable flow and thermal models in order to clearly assimilate the flow and heat transfer in metallic foam. The presence of aluminum metal foam is highlighted for the augmentation of heat dissipation in terms of PPI and porosity. The parametric study proposed in this work surrogates the complexity and cost involved in developing an expensive experimental setup. © 2021 American Society of Mechanical Engineers (ASME). All rights reserved.Item Performance score based multi-objective optimization for thermal design of partially filled high porosity metal foam pipes under forced convection(Elsevier Ltd, 2022) Jadhav, P.H.; Trilok, G.; Gnanasekaran, N.; Mobedi, M.Optimization study in flow through metal foams for heat exchanging applications is very much essential as it involves variety of fluid flow and structural properties. Moreover, the identification of best combinations of structural parameters of metal foams for simultaneous improvement of heat transfer and pressure drop is a pressing situation. In this work, six different metal foam configurations are considered for the enhancement of heat transfer in a circular conduit. The foam is aluminum with PPI varying from 10 to 45 and almost the same porosity (0.90-0.95). The aluminum foams are chosen from the available literature and they are partially filled in the conduit to reduce the pressure drop. For a constant heat flux condition, the goal is to find out the efficient metal foam and configurations when air is considered as a working fluid. A special attention is paid to the preference between pressure drop and heat transfer enhancements. That is why TOPSIS optimization techniques with five different criteria (contains the combination of the weightage/priority of heat transfer and pressure drop) is used. Based on the numerical results of heat and fluid flow in conduit, it is found that when an equal importance is given to both heat transfer and friction effect, 30 PPI aluminum foam with 80% filling on the inner lateral of the pipe provides the best score as 0.8197. The best configuration and PPI for different preferences between friction and heat transfer enhancements is discussed in details. The Reynolds number varies from 4500 to 16500. © 2021 Elsevier Ltd