Book Chapters
Permanent URI for this collectionhttps://idr.nitk.ac.in/handle/123456789/28507
Browse
2 results
Search Results
Item Strength characteristics of laterized mortars using processed laterite(Springer, 2019) Basavana Gowda, S.N.; C, C.; Yaragal, S.C.The rapid pace of population growth in India has enforced the construction industry to use construction materials at an accelerated rate leads to the exhaustion of natural resources. Large-scale constructions have a severe influence on the environment instigating many threats either directly or indirectly like exhaustion of the river due to unscientific sand mining being done at a frightening level, etc. To address this issue, it is required to find substitutes for river sand for producing mortars. One among the locally available marginal resource is laterite. In this study, an attempt is made to study the performance of cement mortars using laterite as fine aggregate in replacement levels of 0, 25, 50, 75 and 100% to natural fine aggregates (river sand). Studies were carried out in two stages, initially river sand is replaced with laterite quarry waste (unprocessed laterite), and then it is replaced with the processed laterite. The flowability and compressive strength characteristics of mortars are studied. Results indicate that, the decrease in compressive strength of mortars with increase in replacement levels of river sand by unprocessed laterite was more, when compared to mortars with processed laterite. However, there is only 13% reduction in strength for laterized mortar with 100% processed laterite when compared to control mortar is observed. © Springer Nature Singapore Pte Ltd. 2019.Item Fast Setting Steel Fibre Geopolymer Mortar Cured Under Ambient Temperature(Springer, 2021) Prasanna, K.M.; Theodose, I.; Shivaprasad, K.N.; Das, B.B.Cement and cementitious materials are being used worldwide as the most popular multipurpose construction materials but the greenhouse gas such as carbon dioxide (CO2) produced during its manufacturing process creating a huge environmental hazard, thus efforts have been made for alternative binders. Geopolymer binder is new age binder alternative to ordinary Portland cement in infrastructure projects because it is produced from eco-friendly and industrial waste materials. This study was aimed to produce fast setting with ground-granulated blast-furnace slag (GGBS) in fly ash-based geopolymer mortar incorporated with steel fibres cured under ambient temperature. In this research, alkaline to binder ratio was varied from 0.5 to 0.8, crimped steel fibre are varied from 0.5 to 1.5% by total volume of binder and combination of fly ash (FA) and GGBS (100%:0%, 90%:10%, 80%:20%, 70%:30%, 60%:40% and 50%:50%) as binder were used for preparation of fibre geopolymer mortar. The tests conducted include stetting time and flowability of geopolymer mortar, compressive strength and microstructural characterisation of steel fibre geopolymer mortar. The tests for compressive strength were carried out on standard size of mortar samples at curing period of 3, 7 and 28 days. It is noted from the test results that increase in GGBS content setting times were decreased; however, the compressive strength of fly ash-based geopolymer mortar increased. The highest compressive strength at 28 days of curing period was found to be 69.5 MPa, which is obtained with content of 1% of steel fibres and alkaline to binder ratio of 0.6 with 50%:50% binder’s proportions. Further, it is observed that the incorporation of steel fibres in plain geopolymer mortar have enhanced the compressive strength and optimum dosage of fibres was found to be 1%. © 2021, Springer Nature Singapore Pte Ltd.