Please use this identifier to cite or link to this item: https://idr.nitk.ac.in/jspui/handle/123456789/10728
Full metadata record
DC FieldValueLanguage
dc.contributor.authorPrabhu, K.N.-
dc.contributor.authorDeshapande, P.-
dc.contributor.authorSatyanarayan-
dc.date.accessioned2020-03-31T08:22:58Z-
dc.date.available2020-03-31T08:22:58Z-
dc.date.issued2012-
dc.identifier.citationMaterials Science and Engineering A, 2012, Vol.533, , pp.64-70en_US
dc.identifier.urihttp://idr.nitk.ac.in/jspui/handle/123456789/10728-
dc.description.abstractSolidification rate is an important variable during processing of materials, including soldering, involving solidification. The rate of solidification controls the metallurgical microstructure at the solder joint and hence the mechanical properties. A high tensile strength and a lower ductile-brittle transition temperature are necessary for reliability of solder joints in electronic circuits. Hence in the present work, the effect of cooling rate during solidification on microstructure, impact and tensile properties of Sn-9Zn lead-free solder alloy was investigated. Four different cooling media (copper and stainless steel moulds, air and furnace cooling) were used for solidification to achieve different cooling rates. Solder alloy solidified in copper mould exhibited higher cooling rate as compared to other cooling media. The microstructure is refined as the cooling rate was increased from 0.03 to 25 C/s. With increase in cooling rate it was observed that the size of Zn flakes became finer and distributed uniformly throughout the matrix. Ductile-to-brittle transition temperature (DBTT) of the solder alloy increased with increase in cooling rate. Fractured surfaces of impact test specimens showed cleavage like appearance and river like pattern at very low temperatures and dimple like appearance at higher temperatures. The tensile strength of the solder alloy solidified in Cu and stainless moulds were higher as compared to air and furnace cooled samples. It is therefore suggested that the cooling rate during solidification of the solder alloy should be optimum to maximize the strength and minimize the DBTT. 2011 Elsevier B.V.en_US
dc.titleEffect of cooling rate during solidification of Sn-9Zn lead-free solder alloy on its microstructure, tensile strength and ductile-brittle transition temperatureen_US
dc.typeArticleen_US
Appears in Collections:1. Journal Articles

Files in This Item:
File Description SizeFormat 
10728.pdf2.47 MBAdobe PDFThumbnail
View/Open


Items in DSpace are protected by copyright, with all rights reserved, unless otherwise indicated.