Effect of Mold Contour on Interfacial Heat Transfer During Solidification of AlSi11Cu3Fe Alloy (ADC-12)

Abstract

The present work investigated the effect of flat, concave, and convex mold contours on heat transfer during the solidification of an aluminum AlSi11Cu3Fe (ADC-12) alloy. Experiments were designed with copper/steel cylindrical and flat molds to study the effect of convex and flat casting/mold interface on heat transfer. To examine the effect of a concave and flat interfaces, an experimental setup consisting of a cylindrical and square bar chill was fabricated. Casting/mold (chill) interfacial heat flux was estimated by solving an inverse heat conduction problem (IHCP). The temperatures measured at locations inside the mold/chill were used as input to the inverse solver. It was observed that the flat contour yielded higher heat flux than a convex contour for both copper and steel molds. Although the volume to surface area (V/A) ratio for castings solidified against a flat and convex interface are the same, the larger mold volume associated with the flat interface yielded higher heat flux transients. Experiments involving chills suggested that the flat interface resulted in higher heat transfer when the (V/A) ratio for the chill was the same. To study and compare the combined effect of mold material and contour on heat transfer during casting solidification, the molds must have the same volumetric thermal effusivity per unit surface area available for heat transfer. © American Foundry Society 2023.