Drilling parameter optimization of cenosphere/HDPE syntactic foam using CO2 laser

Abstract

High-density polyethylene is a high-strength, and low-weight material system. Besides numerous applications in a variety of fields and products, its machining for generation of holes is rather difficult with traditional methods such as drilling as the process is not very conducive for composites due to associated damage. Hence, a non-contact material removal process such as laser machining provides an appealing, cost-effective, accurate, and fast alternative. For this study, the effect of the laser process controls key parameters such as laser power and laser speed on the cut surface integrity defined by surface roughness, kerf taper angle, and heat-affected zone of neat HDPE and HDPE with 60 wt% cenosphere was investigated and optimized using response surface methodology. Also, the machining operation was visualized using a Photron FASTCAM SA 1.1 high-speed camera to observe the effects of the high-intensity laser beam on specimens and to investigate the mechanism of laser machining. The optimum values for a defect-free cut surface (minimum surface roughness and low kerf taper angle) in neat HDPE comes out to be as laser power of 97.5 W and laser speed of 5 mm/s, with corresponding surface roughness and kerf taper angle of 54.304 μm and 0.152 degrees respectively and the optimum input values for HDPE with 60 wt% cenosphere are 102.126 W laser power and 5 mm/s laser speed, with corresponding surface roughness and kerf taper angle of 26.574 μm and 0.253 degrees. This study finds importance for the industrial and medical application to creates small size holes for mechanical joints such as rivets, bolts, and screws in assembly as low surface roughness and kerf width are always preferred as quality parameters in creating holes for industrial applications. © 2022