Faculty Publications

Now showing 1 - 3 of 3

Biological sulfide oxidation using autotrophic Thiobacillus sp.: Evaluation of different immobilization methods and bioreactors
(2009) Ravichandra, P.; Gopal, M.; Jetty, A.
Aims: Evaluation of various immobilization methods and bioreactors for sulfide oxidation using Thiobacillus sp. was studied. Methods and Results: Ca-alginate, K-carrageenan and agar gel matrices (entrapment) and polyurethane foam and granular activated carbon (adsorption) efficacy was tested for the sulfide oxidation and biomass leakage using immobilized Thiobacillus sp. Maximum sulfide oxidation of 96% was achieved with alginate matrix followed by K-carrageenan (88%). Different parameters viz. alginate concentration (1%, 2%, 3%, 4% and 5%), CaCl2 concentration (1%, 2%, 3%, 4% and 5%), bead diameter (1, 2, 3, 4 and 5 mm), and curing time (1, 3, 6, 12 and 18 h) were studied for optimal immobilization conditions. Repeated batch experiments were carried out to test reusability of Ca-alginate immobilized beads for sulfide oxidation in stirred tank reactor and fluidized bed reactor (FBR) at different sulfide concentrations. Conclusions: The results proved to be promising for sulfide oxidation using Ca-alginate gel matrix immobilized Thiobacillus sp. for better sulfide oxidation with less biomass leakage. Significance and Impact of the Study: Biological sulfide oxidation is gaining more importance because of its simple operation. Present investigations will help in successful design and operation of pilot and industrial level FBR for sulfide oxidation. © 2009 The Society for Applied Microbiology.
Kinetics of bioreduction of hexavalent chromium by poly vinyl alcohol-alginate immobilized cells of Ochrobactrum sp. Cr-B4 and comparison with free cells
(Taylor and Francis Inc. 325 Chestnut St, Suite 800 Philadelphia PA 19106, 2016) Hora, A.; Shetty K, K.V.
The cells of Ochrobactrum sp. Cr-B4 immobilized in PVA-alginate blended matrix could be successfully used for bioreduction of Cr(VI) from contaminated water. The removal mechanism included adsorption on solid-liquid interface and enzyme catalyzed chromate reduction. At lower concentrations the initial rate of Cr(VI) reduction with immobilized cells was found to be slightly higher than that of free cells owing to adsorption on the immobilization matrix. But after a certain time the rate of Cr(VI) reduction by free and immobilized cells was similar. The estimation of effectiveness factor (?), indicated that there were no diffusional limitations offered by the immobilization of Cr-B4 as the value of ? was fond to be near “one” at different concentrations of Cr(VI). The kinetic analysis showed that both free and immobilized cells followed Michaelis–Menten kinetics with Kmand Vmaxof 456.1 mg/L and 14.67 mg/L/h for free cells respectively; 499.4 mg/L and 15.32 mg/L/h for immobilized cells respectively. The kinetic characteristics of Cr(VI) reduction were not altered by immobilization. This study reveals the potential applications of immobilized Cr-B4 in development of industrially feasible and economically viable bioremediation strategy for discharging Cr(VI) free effluent into the environment. © 2015 Balaban Desalination Publications. All rights reserved.
Isolation and identification of Pseudomonas from wastewater, its immobilization in cellulose biopolymer and performance in degrading Triclosan
(Academic Press, 2019) Devatha, C.P.; Narasimhappa, N.
Triclosan (TCS) is a well-known emerging contaminant got wide use in daily use products of domestic purpose, which provides the way to enter the ecological cycle, and is preferably detected in sewage treatment plants. In this study, TCS degrading bacteria (TDB) was isolated and identified from a wastewater treatment plant at the National Institute of Technology-Karnataka, Surathkal (NITK), India. The isolate was reported as Pseudomonas strain by performing 16S RNA Sequencing using BLAST analysis. Bacterial growth depends upon several environmental factors. Hence its growth optimization was carried out by response surface method (RSM) based central composite design (CCD) and validated by the artificial neural network (ANN). The Parameters or inputs used for optimization are pH, time (days), agitation (rpm) and sorbent dosage (?g/L). Experiments were conducted in batch mode to achieve optimum growth of bacteria based on RSM trial runs. The RSM model predictions were in better agreement with the experimental results and it was confirmed by ANN. The deviation lies within ±10% with experimental results compared to ANN for maximum trials. Hence optimized parameters were established and arrived at pH - 7, time - 13 days, agitation - 150 rpm, dosage - 1.5 ?g/L presented 69% removal of TCS. Minimum inhibitory assay of isolated strain was conducted to identify the degradation capacity of TCS and it was found out to be lesser than 0.025 mg of TCS. Later the strain was immobilized in two different matrices. One is biopolymer extracted from cellulose (Water Hyacinth) along with sodium alginate and second is free bacteria with sodium alginate and was made in the form of beads. The removal of TCS by TDB-cellulose-alginate (BCA) and TDB-Alginate (BA) beads were 58% and 30% respectively. Hence it was concluded that BCA beads showed effective removal compared to BA beads. Therefore, isolate can degrade TCS when the concentration ranges from 0.025 mg/L to 5.5 ng/L. © 2018 Elsevier Ltd

Faculty Publications

Browse

Filters

Settings

Sort By

Results per page

Search Results