Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
35 results
Search Results
Item Crystallinity, magnetic and electrochemical studies of PVDF/Co 3O4 polymer electrolyte(Elsevier Ltd, 2012) Bhatt, A.S.; Bhat, D.K.Organic-inorganic nanocomposites are gaining importance in the recent times as polymer electrolyte membranes. In the present work, composites were prepared by combining nano sized Co3O4 and poly(vinyledene fluoride) (PVDF), using spin coating technique. The surface of the PVDF/Co 3O4 system characterized through field emission scanning electron microscopy (FESEM) revealed a porous structure of the films. The nanoparticles tend to aggregate on the surface and inside the pores, leading to a decrease in the porosity with an increase in Co3O4 content. Co3O4 nanoparticles prohibit crystallization of the polymer. Differential scanning calorimetry (DSC) studies revealed a decrease in crystallinity of PVDF/Co3O4 system with an increase in the oxide content. Magnetic property studies of the composite films revealed that with an increase in Co3O4 content, the saturation magnetization values of the nanocomposites increased linearly, showing successful incorporation of the nanoparticles in the polymer matrix. Further, ionic conductivity of the composite films was evaluated from electrochemical impedance spectroscopy. Addition of Co3O4 nanoparticles enhanced the conductivity of PVDF/Co3O4 system. © 2011 Elsevier B.V. All rights reserved.Item Defluoridation of fresh water using the process of Electrocoagulation combined with Adsorption(2013) Wali, A.; Saidutta, M.B.In India, fluoride is the major inorganic pollutant of natural origin found in groundwater. Fluoride pollution occurs due to natural and manmade reasons and high concentrations have a detrimental effect on health. Electrochemical techniques like Electrocoagulation(EC) appears to be one of the most effective approaches for treatment of water and wastewater because of its versatility, safety, selectivity, amenability to automation and environmental compatibility. Results show that the percentage removal of fluoride was around 94 to 96% for monopolar and bipolar electrodes. Adsorbents like tricalcium phosphate and activated alumina used along with electrocoagulation process also gave promising results. © 2013 CAFET-INNOVA TECHNICAL SOCIETY.Item Probing the synergism of halloysite nanotubes and electrospinning on crystallinity, polymorphism and piezoelectric performance of poly(vinylidene fluoride)(Royal Society of Chemistry, 2016) Khalifa, M.; Mahendran, A.; Anandhan, S.Poly(vinylidene fluoride) (PVDF) nanofibers have tremendous potential in nano-sensing and energy scavenging applications. In this study, uniaxially aligned nanofibers were developed from halloysite nanotubes (HNT)/PVDF nanocomposite using electrospinning technique. Incorporation of HNT into PVDF not only reduced the diameter of the electrospun nanofibers, but, also improved their morphology. Fourier transform infrared spectroscopy, wide angle X-ray diffraction and differential scanning calorimetry techniques were used to characterize the crystallinity, polymorphism and polymer-filler interaction in the nanocomposite nanofibers. A force sensor was indigenously designed to study the piezoelectric responses of the nanocomposite nanofibers. At 10 wt% of HNT loading, the sensor produced the highest voltage output, which can be ascribed to its highest ?-phase content. Incorporation of HNT and use of electrospinning synergistically enhanced the ?-phase content and hence the piezoelectric behavior of PVDF. Hence, these nanofibers could be promising and prominent materials in sensor and actuator applications. © The Royal Society of Chemistry.Item Electroactive poly(vinylidene fluoride) fluoride separator for sodium ion battery with high coulombic efficiency(Elsevier B.V., 2016) Janakiraman, S.; Surendran, A.; Ghosh, S.; Anandhan, S.; Adyam, A.Electroactive separators are recent interest in self-charging rechargeable batteries. In this study, electrospun polyvinylidene fluoride (PVDF) is characterized as an electroactive separator for Na-ion batteries. The intrinsic ?-phase with high porosity of the separator is confirmed from X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), Field emission scanning electron microscopy (FESEM) and Atomic Force Microscopy (AFM) studies. The electroactive separator is immersed in 1M NaClO4-ethylene carbonate (EC)/diethyl carbonate (DEC) (1:1 by weight) solution. The physicochemical characteristics of electroactive separator electrolyte (EaSE) were investigated using sodium ion conductivity, ion transference number and contact angle measurements. Linear and cyclic voltammetry studies were also carried out for the electrolyte system to evaluate oxidation stability window. The inherent ?-phases of the separator as obtained by electrospinning has an ionic conductivity of ~ 7.38 × 10- 4 S cm- 1 under ambient condition. Sodium ion cell made from EaSE with Na0·66Fe0.5Mn0·5O2 as cathode and Na metal as anode has displayed a stable cycle performance with a coulombic efficiency of 92% after 90 cycles. © 2016 Published by Elsevier B.V.Item Synergism of Electrospinning and Nano-alumina Trihydrate on the Polymorphism, Crystallinity and Piezoelectric Performance of PVDF Nanofibers(Minerals, Metals and Materials Society 184 Thorn Hill Road Warrendale PA 15086, 2018) Khalifa, M.; Deeksha, B.; Mahendran, A.; Anandhan, S.Poly(vinlylidene fluoride) (PVDF) is known for its electroactive phases, which can be nucleated by incorporating nanoparticles into PVDF to enhance its piezoelectric performance. In this study, the synergistic effect of electrospinning and nano alumina trihydrate (ATH) filler was used to enhance the electroactive ? phase of PVDF. Electrospun nanofibers of PVDF/ATH nanocomposite (PANCF) were synthesized with different loadings of ATH. The presence of ATH enhances the surface charges of the electrospun droplets, leading to thinner fibers. The highest ?-phase content was found to be 70.1% for PANCF with 10% ATH. The piezoelectric performance of the nanofiber mats was studied using an indigenous setup. The highest voltage output of 840 mV was produced by PANCF with 10% ATH. These nanofibers could be a promising material in the field of sensors, actuators and energy-harvesting applications. © 2018, The Minerals, Metals & Materials Society.Item Electrochemical characterization of a polar ?-phase poly (vinylidene fluoride) gel electrolyte in sodium ion cell(Elsevier B.V., 2019) Janakiraman, S.; Surendran, A.; Biswal, R.; Ghosh, S.; Anandhan, S.; Adyam, A.A polar ?-phase poly (vinylidene fluoride) (PVDF) membrane is developed through the electrospinning method. PVDF gel electrolyte for sodium ion batteries was obtained by saturating the bare porous membrane in a liquid electrolyte, 1 M NaClO4 in EC: DEC (1:1 vol%). The physical and electrochemical characteristics of the polar ?-phase PVDF membrane are explored by X-ray diffraction (XRD), Field emission scanning electron microscopy (FESEM), Atomic force microscope (AFM), sodium ion conductivity, linear sweep voltammetry (LSV) and sodium ion transference number. The ionic conductivity of a polar ?-phase PVDF gel electrolyte exhibited 9.2 × 10?4 S cm?1, higher than the commercially used Celgard® 2400 membrane 0.36 × 10?4 S cm?1 at ambient temperature. The electrochemical expolarations of the sodium ion half-cell (Na2/3Fe1/2Mn1/2O2) as a cathode and sodium metal as a counter electrode) conducted from PVDF gel electrolyte are analysed by cyclic voltammetry (CV) and electrochemical impedance spectroscopy (EIS). CV of the battery showed a pseudo capacitive nature. The equivalent circuit model of the sodium ion cell brought out the effect of dipole moments in the polymer chains on the battery performance. © 2018 Elsevier B.V.Item A new strategy of PVDF based Li-salt polymer electrolyte through electrospinning for lithium battery application(Institute of Physics Publishing helen.craven@iop.org, 2019) Janakiraman, S.; Surendran, A.; Ghosh, S.; Anandhan, S.; Adyam, A.Polyvinylidene fluoride (PVDF) ultrafine fibers with different proportions of lithium nitrate (LiNO3) were fabricated by an electrospinning device. The processing parameters are optimized to 19 wt% PVDF to get a bead free structure. Scanning electron microscope (SEM) and atomic force microscope (AFM) showed the uniform and interconnected porous structure. With the addition of 2 wt% LiNO3, the fiber diameter of the electrospun membrane decreased from 371 to 222 nm. Furthermore, the addition of LiNO3 into the nanofibrous membrane enhanced the ionic conductivity from 0.97 ×10-3 S cm-1 to 1.61 ×10-3 S cm-1 at room temperature after soaking with 1 M LiPF6 (lithium hexafluoro-phosphate) in ethylene carbonate (EC) and diethyl carbonate (DEC) in (1:1 wt%). Compared with the conventional Celgard and pristine PVDF membrane, the salt doped PVDF membranes showed higher electrochemical stability window and lower interfacial resistance. The electrospun membrane separators (ES) were assembled into Lithium cobalt oxide (LiCoO2) as cathode and lithium metal as an anode. The salt doped membrane showed superior discharge, C-rate and stable cycle performance than the commercial Celgard membrane. © 2018 IOP Publishing Ltd.Item Synergism of graphitic-carbon nitride and electrospinning on the physico-chemical characteristics and piezoelectric properties of flexible poly(vinylidene fluoride) based nanogenerator(Springer Netherlands rbk@louisiana.edu, 2019) Khalifa, M.; Mahendran, A.; Anandhan, S.Herein, we investigated the piezoelectric performance of electrospun poly(vinylidene fluoride)/graphitic carbon nitride (PVDF/g-C 3 N 4 ) nanocomposite fibers (PGN-X). Addition of g-C 3 N 4 nanosheets improved the spinnability of nanofibers and augmented the ?-phase content of PVDF. The synthesized PGN non-woven mats were flexible and easily deformable without disrupting the continuity of fibers. Upon the addition of g-C 3 N 4 , tensile strength and thermal stability of nanocomposite fibers improved significantly. A maximum voltage output of ~7.5 V was generated for PGN nanogenerator which is ~8 times more than that of PVDF nanogenerator. Also, the PGN-X nanogenerator generated current output of 0.23 ?A and a power density of 0.22 ?W/cm ?2 . Improved physico-chemical characteristics and piezoelectric performance of PGN nanogeneratoris promising and makes it suitable for portable electronic and wearable devices. © 2019, The Polymer Society, Taipei.Item Durable, efficient, and flexible piezoelectric nanogenerator from electrospun PANi/HNT/PVDF blend nanocomposite(John Wiley and Sons Inc. cs-journals@wiley.com, 2019) Khalifa, M.; Mahendran, A.; Anandhan, S.Currently, there is considerable research focus on portable, lightweight, shock-resistant, and inexpensive wearable devices that are ideally powered by harvesting abundant mechanical or vibration energy, making battery or related wiring superfluous. In this study, piezoelectric nanogenerator was electrospun from PANi (polyaniline)/HNT (halloysite nanotube)/PVDF (poly[vinylidene fluoride]) blend nanocomposite. Polymorphism, crystallinity and morphology of the nanogenerator were explored in detail. HNT and PANi acted as a nucleating agent and conductive filler, respectively in PVDF; their synergism helps improve the piezoelectric performance of PVDF. The piezoelectric performance of the nanogenerator patch was studied under various external mechanical stresses, such as pressure, tapping, and impact. A maximum voltage output of approximately 7.2 V was generated by the nanogenerator under impact. The nanogenerator patch attached to human arm exhibited not only excellent piezoelectric response during arm movements, but, also proved to be flexible, highly sensitive and durable. This nanogenerator could possibly be used in wearable piezoelectric energy conversion application for self-powered devices. POLYM. COMPOS., 40:1663–1675, 2019. © 2018 Society of Plastics Engineers. © 2018 Society of Plastics EngineersItem Electrospun electroactive polyvinylidene fluoride-based fibrous polymer electrolyte for sodium ion batteries(Institute of Physics Publishing helen.craven@iop.org, 2019) Janakiraman, S.; Surendran, A.; Biswal, R.; Ghosh, S.; Anandhan, S.; Adyam, A.Electrospinning is an efficient technique to produce ultrafine electroactive mat, diameters ranging from few nanometers to micrometers to use as a separator in sodium ion battery. The polyvinylidene fluoride (PVDF) polymer solution was optimized to 19 wt%, applied voltage 25 kV and flow rate of 0.5 ml h-1 to get a bead free ultrafine electroactive structure. The electroactive ?-phase is confirmed by x-ray diffractometer (XRD). Ionic conductivities, electrolyte uptake, wettability, linear sweep voltammetry (LSV) and thermal stability of the electroactive fibrous polymer electrolyte (EFPE) were studied by soaking the separator with a liquid electrolyte of 1 M sodium hexafluorophosphate (NaPF6) dissolved in ethylene carbonate (EC)/propylene carbonate (PC) (1:1 vol%). The EFPE exhibits high ionic conductivity of 1.08 mS cm-1 and electrochemical stability window of 5.0 V versus Na/Na+ under ambient condition. The half-cell containing Na0.66Fe0.5Mn0.5O2 as cathode and EFPE as the separator cum electrolyte showed a stable cycling performance at a current rate of 0.1C. © 2019 IOP Publishing Ltd.