Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
48 results
Search Results
Item N and p doped poly(3,4-ethylenedioxythiophene) electrode materials for symmetric redox supercapacitors(2007) Bhat, D.K.; Muthu, M.S.A symmetric redox supercapacitor has been fabricated based on n and p doped Poly(3,4-ethylenedioxythiophene)(PEDOT) coated on stainless steel (SS) electrodes. The characterization and performance of the supercapacitor has been studied by FTIR, Cyclic Voltammetry and AC Impedance spectroscopy. The supercapacitor showed a maximum specific capacitance of 121 F g-1 at a scan rate of 10 mV s-1. The time constant calculated for the supercapacitor through the active-reactive power behavior measurement was 12 milliseconds indicating the suitability of the system for efficient use at low frequency range. © 2007 Springer Science+Business Media, LLC.Item Nano ZnO-activated carbon composite electrodes for supercapacitors(2010) Muthu, M.S.; Bhat, D.K.; Aggarwal, A.; Prahladh Iyer, S.; Sravani, G.A symmetrical (p/p) supercapacitor has been fabricated by making use of nanostructured zinc oxide (ZnO)-activated carbon (AC) composite electrodes for the first time. The composites have been characterized by field emission scanning electron microscopy (FESEM) and X-ray diffraction analysis (XRD). Electrochemical properties of the prepared nanocomposite electrodes and the supercapacitor have been studied using cyclic voltammetry (CV) and AC impedance spectroscopy in 0.1 M Na2SO4 as electrolyte. The ZnO-AC nanocomposite electrode showed a specific capacitance of 160 F/g for 1:1 composition. The specific capacitance of the electrodes decreased with increase in zinc oxide content. Galvanostatic charge-discharge measurements have been done at various current densities, namely 2, 4, 6 and 7 mA/cm2. It has been found that the cells have excellent electrochemical reversibility and capacitive characteristics in 0.1 M Na2SO4 electrolyte. It has also been observed that the specific capacitance is constant up to 500 cycles at all current densities. © 2010 Elsevier B.V. All rights reserved.Item Microwave synthesized nanostructured TiO 2 -activated carbon composite electrodes for supercapacitor(Elsevier B.V., 2012) Muthu, M.; Bhat, D.K.Electrochemical properties of a supercapacitor based on nanocomposite electrodes of activated carbon with TiO 2 nano particles synthesized by a microwave method have been determined. The TiO 2 /activated carbon nanocomposite electrode with a composition of 1:3 showed a specific capacitance 92 Fg -1 . The specific capacitance of the electrode decreased with increase in titanium dioxide content. The p/p symmetrical supercapacitor fabricated with TiO 2 /activated carbon composite electrodes showed a specific capacitance of 122 Fg -1 . The electrochemical behavior of the neat TiO 2 nanoparticles has also been studied for comparison purpose. The galvanostatic charge-discharge test of the fabricated supercapacitor showed that the device has good coulombic efficiency and cycle life. The specific capacitance of the supercapacitor was stable up to 5000 cycles at current densities of 2, 4, 6 and 7 mA cm -2 . © 2012 Elsevier B.V.Item Effect of acid dopants in biodegradable gel polymer electrolyte and the performance in an electrochemical double layer capacitor(Institute of Physics Publishing custserv@iop.org, 2015) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.Proton-conducting biodegradable gellan gum gel polymer electrolytes (GPEs) have been prepared using three different dopants, namely ortho-phosphoric (o-H3PO4), sulfuric (H2SO4) and hydrochloric acids (HCl). The GPEs were cross-linked using borax. The polymeric gels were characterized by spectroscopic, thermal, ionic conductivities and dielectric measurements. Proton conductivity was in the range of 5.1 × 10-3 to 3.7 × 10-4 s cm-1 and activation energies were between 0.14 meV and 0.19 meV, at different temperatures. Among the doped acids, the H3PO4 doped GPE exhibited thermal stability at varying temperature. Electrochemical double layer capacitors (EDLCs) were fabricated using activated carbon as electrode material and GPEs. The EDLCs were tested using cyclic voltammetry, ac impedance spectroscopic and galvanostatic charge-discharge techniques. The maximum specific capacitance value was 146 F g-1 at a scan rate of 2 mV s-1. Quite stable values were obtained at a constant current density up to 1000 cycles. © 2015 The Royal Swedish Academy of Sciences.Item Fabrication and performance evaluation of hybrid supercapacitor electrodes based on carbon nanotubes and sputtered TiO2(Institute of Physics Publishing michael.roberts@iop.org, 2016) Aravinda, L.S.; Nagaraja, K.K.; Nagaraja, H.S.; Bhat, K.U.; Badekai Ramachandra, B.R.We report a simple and eco-friendly method for the fabrication of a titanium dioxide/functionalized multiwalled carbon nanotube (TiO2/FMWCNT) composite electrode for use in supercapacitors. The nanocomposite electrodes were formed by depositing titanium dioxide onto FMWCNTs using reactive magnetron sputtering, thus providing a green roue for the formation of the binder-free composite electrode. It is shown that the electrochemical performance of the fabricated electrodes can be altered by tuning the thickness of the titanium dioxide overlayer. The integrated nanocomposite electrode showed an improved specific capacitance of 90 Fg-1 in two-electrode configuration. © 2016 IOP Publishing Ltd.Item Synthesis and characterization of Ni-P-Ag composite coating as efficient electrocatalyst for alkaline hydrogen evolution reaction(Elsevier Ltd, 2016) Elias, L.; Hegde, A.C.The effect of addition of silver nanoparticle sol (SNS) into Ni-P plating bath was studied in terms of the variation in electrocatalytic behavior of the developed coatings in 1.0 M KOH. Ni-P-Ag composite coating was achieved through direct electrolysis by adding a known quantity of the conventionally prepared SNS into Ni-P bath. Ni-P-Ag coatings electrodeposited galvanostatically on copper under different conditions of the bath was used as electrode material for alkaline hydrogen evolution reaction (HER). The optimal concentration of the SNS required for maximum electrocatalytic activity towards HER was obtained by adding different volumes of SNS (from 0 to 50 mL L?1) into the bath. The HER efficiency of the test electrodes in 1.0 M KOH medium was examined using cyclic voltammetry (CV) and chronopotentiometry (CP) techniques. The kinetics of HER on the alloy and composite electrodes were established through Tafel polarization and electrochemical impedance spectroscopy (EIS) analyses. Energy dispersive spectroscopy (EDS) was used to confirm the incorporation of Ag nanoparticles into the Ni-P alloy matrix. The microstructure and morphology of the alloy and composite coatings were analyzed by Scanning Electron Microscopy (SEM). A significant improvement in the electrocatalytic property of nano-Ag derived composite coatings was found, and was attributed to the enhanced electroactive sites of Ag particles. Deposition conditions to maximize the electrocatalytic activity of Ni-P-Ag nanocomposite coatings in relation to traditional Ni-P alloy coatings was arrived, and results are discussed. © 2016Item Hydrothermally synthesized reduced graphene oxide and Sn doped manganese dioxide nanocomposites for supercapacitors and dopamine sensors(Elsevier Ltd, 2017) Shanbhag, D.; Bindu, K.; Aarathy, A.R.; Ramesh, R.; Moolayadukkam, M.; Nagaraja, H.S.?-MnO2 nanowires and its nanocomposites (rGO-MnO2 and Sn@rGO-MnO2) were synthesized by a facile hydrothermal technique. Two important electrochemical applications of nanocomposites, viz, electrodes for supercapacitor and sensors for a biomolecule, dopamine are reported. The prepared nanowires have been characterized by XRD, which reveals smaller crystallite size of rGO- MnO2 composites compared to pristine MnO2 and the trend is supported by BET analysis. The wrapping of MnO2 NWs with rGO sheets increases the surface area, as well as, creates more dislocations at the interfaces. The correlation between physicochemical properties leads to an enhancement in the electrochemical performance of the materials. The as-fabricated Sn@rGO-MnO2 supercapacitor electrode reveals superior performance. The specific capacitance of 139.05, 309.7 and 460.9 F/g at a scanning rate of 20 mV/s, in an aqueous Na2SO4 solution (1 M) is obtained for MnO2, rGO-MnO2 and Sn@rGO-MnO2 respectively. Also, the reported nanocomposites show excellent performance towards detection of dopamine. Among ?-MnO2/GCE, rGO-MnO2/GCE and Sn@rGO-MnO2/GCE based sensors for Dopamine detection, rGO-MnO2/GCE sensor exhibits the highest sensitivity of 433.6 ?A/mM and broad linear range, whereas Sn@rGO-MnO2 exhibits lower detection limit of 0.13 ?M. © 2017 Elsevier LtdItem Porous cobalt chalcogenide nanostructures as high performance pseudo-capacitor electrodes(Elsevier Ltd, 2017) Bhat, K.S.; Shenoy, S.; Nagaraja, H.S.; Sridharan, K.Electrochemical supercapacitor is an essential technology that is pivotal for the development of reliable energy storage devices. Herein, we report the fabrication of supercapacitor electrodes using nanostructured porous cobalt chalcogenide (CoTe2 and CoSe2) electrodes, anticipating an enhanced performance owing to their higher contact area with electrolyte and large pore volume enabling shorter diffusion paths for ion exchange. In this regard, we synthesized CoTe2 and CoSe2 nanostructures via an anion-exchange-reaction between pre-synthesized Co(OH)2 hexagonal nanosheets and chalcogen (tellurium and selenium) ions under hydrothermal conditions. Structural, morphological and compositional properties of the as-synthesized materials are examined using X-ray diffraction, Raman spectroscopy, scanning electron microscopy, high resolution transmission electron microscopy and energy dispersive X-ray spectroscopy. Pseudo-capacitive properties of CoTe2 and CoSe2 nanostructures as working electrodes are studied through cyclic voltammetry and galvanostatic charge-discharge methods using an electrochemical workstation. CoSe2 electrode delivered a specific capacitance of 951 F g?1 at a scan rate of 5 mV s?1, which surprisingly is almost three times higher in comparison to CoTe2 electrode (360 F g?1). Both CoTe2 and CoSe2 electrodes exhibited good capacitance retention capability for 2500 CV cycles. The superior electrochemical performance of the nanoporous CoSe2 electrode indicate their applicability for high-performance energy storage device applications. © 2017 Elsevier LtdItem Adsorptive Treatment of Landfill Leachate using Activated Carbon Modified with Three Different Methods(Springer Verlag service@springer.de, 2018) Erabee, I.K.; Ahsan, A.; Jose, B.; Aziz, M.M.A.; Ng, A.W.M.; Idrus, S.; Daud, N.N.N.Activated Carbon (AC) is an adsorbent having high surface area which makes the process of removing heavy metals from wastewater (such as landfill leachate) very effective. This study explored the utilization of three methods of modification of AC produced from coconut shell by treating it with nitric acid (HNO3), potassium permanganate (KMnO4) and heating at 600°C to improve the adsorption capacity. The AC can remove multi-pollutants in the filtration process which was used to treat landfill leachate. The water quality parameters such as pH, TSS, Ammonia-Nitrogen and a few heavy metals were considered in the present study. Results showed that the removal of these parameters was proportional with the increase of contact time and the bed depth of AC. The isotherm analysis of the adsorption of modified AC showed the best Removal Efficiency (RE) can be achieved when AC treated with KMnO4 for NH3-N, zinc, TSS and sulphide. The morphology of the AC was studied through Scanning Electron Microscopy (SEM), Energy Dispersive X-ray spectroscopy (EDX) pattern analysis and Fourier Transform Infrared (FTIR) analysis. It was found that various types of oxygen functional groups were introduced onto the surface of coconut shell derived AC through oxidation using HNO3. FTIR was used to characterize the surface oxygen functional groups. The surface functional groups such as N-H and C-H stretching played a significant role in heavy metals adsorption. Hence, it can be concluded that the hybrid technique by using electrolysis process with AC adsorption be an effective way to remove the suspended solids and heavy metals from landfill leachate and thus able to reduce environmental pollution. © 2018, Korean Society of Civil Engineers.Item Effect of TiO2 nanoparticles on hydrogen evolution reaction activity of Ni coatings(University of Science and Technology Beijing, 2018) Kullaiah, R.; Elias, L.; Hegde, A.C.The electrocatalytic activity of electrodeposited Ni and Ni–TiO2 coatings with regard to the alkaline hydrogen evolution reaction (HER) was investigated. The Ni coatings were electrodeposited from an acid chloride bath at different current densities, and their HER activities were examined in a 1.0-mol·L-1 KOH medium. The variations in the HER activity of the Ni coatings with changes in surface morphology and composition were examined via the electrochemical dissolution and incorporation of nanoparticles. Electrochemical analysis methods were used to monitor the HER activity of the test electrodes; this activity was confirmed via the quantification of gases that evolved during the analysis. The obtained results demonstrated that the Ni–TiO2 nanocomposite test electrode exhibited maximum activity toward the alkaline HER. The surface appearance, composition, and the phase structure of all developed coatings were analyzed using scanning electron microscopy (SEM), energy dispersive spectroscopy (EDS), and X-ray diffraction (XRD), respectively. The improvement in the electrocatalytic activity of Ni–TiO2 nanocomposite coating toward HER was attributed to the variation in surface morphology and increased number of active sites. © 2018, University of Science and Technology Beijing and Springer-Verlag GmbH Germany, part of Springer Nature.