Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Experimental and finite element analysis of power transformer(Structural Engineering Research Centre, 2014) Nandam, N.; Ramesh Babu, R.R.; Venkataramana, K.Post earthquake studies have clearly shown that the seismic performance of substation is very weak and results in damage causing huge direct and indirect loss to the power utilities. Considerable time is spent to repair, retrofit or replace the damaged substation equipment and to restore power supply. Many substation equipments failed when installed in the substation due to moderate earthquake forces though these equipment were experimentally qualified. Power transformer is one of such critical equipment of substation. Vibrations due to earthquake amplified by the transformer tank causes failure in the porcelain bushings mounted on the top of the transformer tank. An attempt has been made in this study to identify resonance frequencies and corresponding damping ratios of a typical transformer by both experimental and numerical methods. In addition, ground acceleration amplification is also calculated from shake table experiments and response analysis of finite element model.Item Design and analysis of dual output flyback converter for standalone PV/battery system(International Journal of Renewable Energy Research, 2017) Sabhahit, N.S.; Gaonkar, D.N.; Naik, A.In this paper, the cost comparison is carried out among flyback, forward and full bridge converters based upon the number of circuit components. The performance assessment in terms of efficiency of the PV array with MPPT controller using flyback and forward converter is detailed. The design and control of Photovoltaic/battery system using a flyback converter for stand-alone applications is presented. A flyback converter is used to get DC output along with an AC output for high frequency applications without employing an inverter. The PV/battery system uses photovoltaic array as the main source of power and a battery as the storage device. The energy input of the PV system is effectively utilized by adopting an MPPT technique and the storage battery is controlled to balance the load requirements using a bi-directional dc-dc converter. This system ensures that the load demand is satisfied under varying solar irradiance conditions and a constant voltage is maintained for different load conditions. The modelling and control strategy of the implemented system is realized in MATLAB/Simulink environment.Item Enhanced mobility aware routing protocol for Low Power and Lossy Networks(Springer New York LLC barbara.b.bertram@gsk.com, 2019) Sanshi, S.; Jaidhar, C.D.Due to the technological advancement in Low Power and Lossy Networks (LLNs), sensor node mobility becomes a basic requirement for many extensive applications. Routing protocol designed for LLNs must ensure real-time data transmission with minimum power consumption. However, the existing mobility support protocols cannot work efficiently in LLNs as they are unable to adapt to the change in the network topology quickly. Therefore, we propose an Enhanced Routing Protocol for LLNs (ERPL), which updates the Preferred Parent (PP) of the Mobile Node (MN) quickly whenever the MN moves away from the already selected PP. Further, a new objective function that takes the mobility of the node into an account while selecting a PP is proposed. Performance of the ERPL has been evaluated with the varying system and traffic parameters under different topologies similar to most of the real-life networks. The simulation results showed that the proposed ERPL reduced the power consumption, packet overhead, latency and increased the packet delivery ratio as compared to other existing works. © 2017, Springer Science+Business Media, LLC, part of Springer Nature.