Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
10 results
Search Results
Item Comparison of performance of biodiesels of mahua oil and gingili oil in dual fuel engine(Serbian Society of Heat Transfer Engineers, 2008) Nadar, K.N.; Reddy, R.P.; Anjuri, E.R.In this work, an experimental work was carried out to compare the performance of biodiesels made from non edible mahua oil and edible gingili oil in dual fuel engine. A single cylinder diesel engine was modified to work in dual fuel mode and liquefied petroleum gas was used as primary fuel. Biodiesel was prepared by transesterification process and mahua oil methyl ester (MOME) and gingili oil methyl ester (GOME) were used as pilot fuels. The viscosity of MOME is slightly higher than GOME. The dualfuel engine runs smoothly with MOME and GOME. The test results show that the performance of the MOME is close to GOME, at the pilot fuel quantity of 0.45 kg/h and at the advanced injection timing of 30 deg bTDC. Also it is observed that the smoke, carbon monoxide and unburnt hydro carbon emissions of GOME lower than the MOME. But the GOME results in slightly higher NOx emissions. From the experimental results it is concluded that the biodiesel made from mahua oil can be used as a substitute for diesel in dual fuel engine.Item Combustion and emission characteristics of a dual fuel engine operated with mahua oil and liquefied petroleum gas(Serbian Society of Heat Transfer Engineers, 2008) Nadar, K.N.; Reddy, R.P.For the present work, a single cylinder diesel engine was modified to work in dual fuel mode. To study the feasibility of using methyl ester of mahua oil as pilot fuel, it was used as pilot fuel and liquefied petroleum gas was used as primary fuel. In dual fuel mode, pilot fuel quantity and injector opening pressure are the few variables, which affect the performance and emission of dual fuel engine. Hence, in the present work pilot fuel quantity and injector opening pressure were varied. From the test results, it was observed that the pilot fuel quantity of 5 mg per cycle and injector opening pressure of 200 bar results in higher brake thermal efficiency. Also the exhaust emissions such as smoke, unburnt hydrocarbon and carbon monoxide are lower than other pressures and pilot fuel quantities. The higher injection pressure and proper pilot fuel quantity might have resulted in better atomization, penetration of methyl ester of mahua oil and better combustion of fuel.Item Experimental investigation of esters of mahua oil as an alternative fuel for dual fuel engine(2008) Reddy, P.B.; Kapilan, N.; Reddy, R.P.In the present work, an attempt was made to use methyl ester of mahua oil (MEMO) as substitute for dieselin dual fuel engine. A four stroke single cylinder engine was modified to work in dual fuel mode. From the test results, it was observed that the MEMO could be used as pilot fuel in dual fuel engine. At lower loads, diesel gave higher brake thermal efficiency. But at higher loads, biodiesel resulted in brake thermal efficiency comparable with diesel and lower smoke and oxides of nitrogen emissions. From the test results, it was concluded that MEMO could be used as a substitute for diesel in dual fuel engine.Item Performance characteristics of a dual fuel engine operated with Mahua biodiesel and liquefied petroleum gas(ASTM International, 2011) Kapilan, N.; Ashok Babu, T.P.; Reddy, R.P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed the interest of the scientific community to look for alternative fuels of bio-origin such as vegetable oils and ethanol. India is looking at biodiesel derived from Mahua oil (MO), as one of the renewable alternative fuels for compression ignition (CI) engine. Although MO biodiesel (MOB) has several advantages over fossil diesel, in the present scenario, the use of biodiesel is restricted due to its high cost. In India, liquefied petroleum gas (LPG) is easily available and is one of the cheapest gaseous fuels. Hence, use of LPG to fuel a CI engine along with MOB seems to be an option for substitution of fossil diesel. In the present work, LPG, which was fumigated along with the air and biodiesel was admitted into the engine cylinder through conventional fueling device as an igniter. A single cylinder CI engine was modified to work in dual fuel mode and engine tests were carried out at rated speed under variable load conditions. The performance of the engine in dual fuel mode was compared with the diesel. The dual fuel operation results in thermal efficiency close to the diesel and also reduces the NOx and smoke emissions significantly. From the experimental results, we concluded that biodiesel in dual fuel mode with cheaper gaseous fuel induction is an option for reducing the operating cost of the biodiesel fuelled CI engine. Copyright ©2011 by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959.Item Performance characteristics of a dual fuel engine operatedwith mahua biodiesel and liquefied petroleum gas(2011) Kapilan, N.; Ashok Babu, T.P.A.; Reddy, R.P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed the interest of the scientific community to look for alternative fuels of bio-origin such as vegetable oils and ethanol. India is looking at biodiesel derived from Mahua oil (MO), as one of the renewable alternative fuels for compression ignition (CI) engine. Although MO biodiesel (MOB) has several advantages over fossil diesel, in the present scenario, the use of biodiesel is restricted due to its high cost. In India, liquefied petroleum gas (LPG) is easily available and is one of the cheapest gaseous fuels. Hence, use of LPG to fuel a CI engine along with MOB seems to be an option for substitution of fossil diesel. In the present work, LPG, which was fumigated along with the air and biodiesel was admitted into the engine cylinder through conventional fueling device as an igniter. A single cylinder CI engine was modified to work in dual fuel mode and engine tests were carried out at rated speed under variable load conditions. The performance of the engine in dual fuel mode was compared with the diesel. The dual fuel operation results in thermal efficiency close to the diesel and also reduces the NOx and smoke emissions significantly. From the experimental results, we concluded that biodiesel in dual fuel mode with cheaper gaseous fuel induction is an option for reducing the operating cost of the biodiesel fuelled CI engine. Copyright © 2011 by ASTM International.Item An experimental investigation on performance and emission parameters of a multi-cylinder SI engine with gasoline–LPG dual fuel mode of operation(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2017) Nayak, V.; Shankar, K.S.; Dinesha, P.; Mohanan, P.The present study deals with the performance and emission characteristics of a multi-point fuel injection (MPFI) spark ignition (SI) engine in gasoline–liquefied petroleum gas (LPG) dual fuel mode of operation. The LPG–gasoline ratio varied from 0 to 100% by controlling the injector signals at various speed and load conditions. Experiments show that the power output decreases with increase in speed and LPG content at lower load marginally due to lower volumetric efficiency. At higher load and lower speed conditions as the percentage of LPG increases there is not much difference in the power output. Results also reveal that 50% LPG flow gives maximum efficiency at full load condition and 4000 rpm due to lower fuel consumption. With 50% usage of LPG, the average increase in brake thermal efficiency (BTE) is 2% till the engine speed of 4000 rpm at full load (100%) and half load (50%) conditions. As the LPG ratio increases the engine will work in the lean region for all speed and load conditions. For all load and speed conditions, results reveal that 100% LPG will give minimum hydrocarbon (HC) and carbon monoxide (CO) emissions. Oxide of nitrogen (NOX) emissions are higher for 100% LPG. However 50% LPG flow gives good agreement of NOX, HC and CO emissions when compared with gasoline operation. © 2016 Informa UK Limited, trading as Taylor & Francis Group.Item Cycle by cycle variations of LPG-gasoline dual fuel on a multi-cylinder MPFI gasoline engine(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2018) Vighnesha, N.; Shankar, K.S.; Dinesha, P.; Mohanan, P.Combustion stability of a multipoint port fuel injection spark ignition engine working on liquefied petroleum gas (LPG)-gasoline dual fuel mode of operation was analysed. LPG-gasoline ratio was varied from 0 to 100% by controlling the injector signals at wide open throttle condition and 3000 RPM. Increasing LPG ratio will give higher peak pressure and higher indicated mean effective pressure (IMEP) because of the higher flame propagation speed of LPG. The experiment showed that maximum pressure will occur nearer to top dead centre when compared to gasoline. Fluctuation in maximum pressure is higher for LPG and is minimum for 50% LPG. Time return map showed that combustion instabilibity will be more for 100% LPG and is less for 50% LPG. Coefficient of variation of IMEP and maximum pressure for gasoline is higher than LPG. With 100% LPG, NOx emission is almost three times that of gasoline. Hence it can be concluded that 50% LPG will give the better combustion characteristics when compared to other fuel blends. © 2017, © 2017 Informa UK Limited, trading as Taylor & Francis Group.Item Experimental studies on cyclic variations in a single cylinder diesel engine fuelled with raw biogas by dual mode of operation(Elsevier Ltd, 2020) Jagadish, C.; Gumtapure, V.In this research work, cycle-by-cycle variations of a single cylinder, diesel engine operated with raw biogas is investigated. The biogas used to run the engine is obtained from food waste and as the composition of 88.10%-CH4 + 11.895%-CO2. To study the combustion characteristics, the naturally aspirated diesel engine is converted into dual mode by inducting the biogas into the intake manifold for different proportions from BG20 to BG60 with a step of 10% is mixed with air (i.e. BG60-60% of biogas by mass) respectively. Combustion parameters are measured and recorded by the means of the data acquisition system (DAQ) for 100 combustion cycle. By determining the parameters such as standard deviation, coefficient of variation and return map, the cycle variability is analyzed. From the experimental result, it is observed that as the engine is operated at higher loads and as the biogas is increased from BG20 to BG60 the cyclic variations for maximum cylinder pressure (Pmax) and indicated mean effective pressure (IMEP) increases. Coefficient of variation of Pmax for BG20 and BG40 is lower by 2.3% and 11.98% as compared to diesel. From time return map, BG40 showed good combustion stability and lesser NOx emission compared to diesel. © 2020 Elsevier LtdItem Experimental investigation of methane-enriched biogas in a single cylinder diesel engine by the dual fuel mode(Taylor and Francis Ltd., 2022) Chandrashekar, J.; Gumtapure, V.In this experimental work characteristic such as performance, combustion and emission of a single cylinder, four-stroke constant speed, direct injection, water-cooled diesel engine is investigated. The engine is operated by dual fuel mode using methane-enriched biogas (88.10%-CH4 + 11.89%-CO2) obtained from the food waste. Biogas (BG) is inducted into the engine at intake manifold with various mixtures like BG20, BG30 and BG40 mixed with air (i.e. BG40-40% of CH4 by mass respectively) at actual injection timing of 27.5° before top dead centre (bTDC) for different loads. The performance, combustion and emission characteristics of the engine operated by dual fuel mode were experimentally investigated, and compared with respect to diesel. By observing the experimental results, BG40 was optimized on the basis of lesser emissions and improved performance. BG40 showed lesser brake thermal efficiency and higher brake specific energy consumption than BG20 and BG30 for all loads. On the other hand, BG40 showed lower BTE by 15.5% and 15.62% compared to diesel at 3/4th and full load. Whereas the cylinder peak pressure for BG40 is higher than diesel by 5.36% and the net heat release rate is 14.9% higher than the diesel at full load. BG40 emitted higher carbon monoxide (CO) emissions than diesel by 5% at full load. The nitrogen oxide (NOx) emission for BG40 was lesser by 26.60% than diesel at full load, whereas the soot emission was 22.71% lower than diesel at full load respectively. © 2022 Taylor & Francis Group, LLC.Item Experimental Study on the Effect of Injection Timing on a Dual Fuel Diesel Engine Operated With Biogas Derived From Food Waste(American Society of Mechanical Engineers (ASME), 2022) Chandrashekar, J.; Gumtapure, V.The present work emphasizes the effects of injection timing on the characteristics of a 5.2-kW powered four-stroke diesel engine using biogas and its heat loss analysis. The biogas is obtained from food waste consisting of methane (CH4)-88.1% and carbon dioxide (CO2)-11.8% as the composition. The biogas (BG) is selected by mass basis ranging from 20% to 60% with 10% increments and is used to operate the engine by dual-fuel mode. The effect of three injection timings such as 25.5 deg (retarded), 27.5 deg (actual), and 29.5 deg (advanced) before top-dead center (bTDC) under dual-mode operation to enhance the properties of the engine is studied, and the results are compared with diesel mode at actual injection timing. Maximum brake thermal efficiency of 30.1% was observed for BG20 operated at 29.5-deg bTDC injection timing (IT). The dual mode operated at the injection timing of 29.5-deg bTDC showed an increase in cylinder pressure compared to diesel by 11.9% at full load conditions, whereas carbon monoxide emission was lower by 5.2% at 29.5-deg bTDC IT than diesel, and nitrogen oxide emission was lower at 25.5 deg bTDC IT than diesel mode by 45%. Besides, at 75% engine load, the least amount of heat losses was observed for BG50 exhibiting effective conversion of fuel energy into equivalent work higher than that of diesel by 2.2%, respectively. © © 2022 by ASME.