Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
68 results
Search Results
Item Comparison of performance of biodiesels of mahua oil and gingili oil in dual fuel engine(Serbian Society of Heat Transfer Engineers, 2008) Nadar, K.N.; Reddy, R.P.; Anjuri, E.R.In this work, an experimental work was carried out to compare the performance of biodiesels made from non edible mahua oil and edible gingili oil in dual fuel engine. A single cylinder diesel engine was modified to work in dual fuel mode and liquefied petroleum gas was used as primary fuel. Biodiesel was prepared by transesterification process and mahua oil methyl ester (MOME) and gingili oil methyl ester (GOME) were used as pilot fuels. The viscosity of MOME is slightly higher than GOME. The dualfuel engine runs smoothly with MOME and GOME. The test results show that the performance of the MOME is close to GOME, at the pilot fuel quantity of 0.45 kg/h and at the advanced injection timing of 30 deg bTDC. Also it is observed that the smoke, carbon monoxide and unburnt hydro carbon emissions of GOME lower than the MOME. But the GOME results in slightly higher NOx emissions. From the experimental results it is concluded that the biodiesel made from mahua oil can be used as a substitute for diesel in dual fuel engine.Item Combustion and emission characteristics of a dual fuel engine operated with mahua oil and liquefied petroleum gas(Serbian Society of Heat Transfer Engineers, 2008) Nadar, K.N.; Reddy, R.P.For the present work, a single cylinder diesel engine was modified to work in dual fuel mode. To study the feasibility of using methyl ester of mahua oil as pilot fuel, it was used as pilot fuel and liquefied petroleum gas was used as primary fuel. In dual fuel mode, pilot fuel quantity and injector opening pressure are the few variables, which affect the performance and emission of dual fuel engine. Hence, in the present work pilot fuel quantity and injector opening pressure were varied. From the test results, it was observed that the pilot fuel quantity of 5 mg per cycle and injector opening pressure of 200 bar results in higher brake thermal efficiency. Also the exhaust emissions such as smoke, unburnt hydrocarbon and carbon monoxide are lower than other pressures and pilot fuel quantities. The higher injection pressure and proper pilot fuel quantity might have resulted in better atomization, penetration of methyl ester of mahua oil and better combustion of fuel.Item Evaluation of methyl esters of mahua oil (mahua indica) as diesel fuel(2008) Kapilan, N.; Reddy, R.P.There is increasing interest in India for suitable alternative fuels that are environment friendly. This search has led to mahua oil (MO) as one alternative for diesel fuel in India. Mahua oil methyl esters (MOME) were prepared by transesterification using potassium hydroxide (KOH) as catalyst and nuclear magnetic resonance (NMR) testing was done to determine the conversion of vegetable oil to biodiesel (MOME). The properties of MOME were close to those of diesel oil. Engine testing was conducted using a single-cylinder 4-stroke direct-injection, constant-speed compression-ignition diesel engine using MO, MOME and B20 as fuels. The engine ran smoothly with MOME and B20, but heavy smoke emissions were observed when MO was used as fuel. © 2007 AOCS.Item 6BTA 5.9 G2-1 Cummins engine performance and emission tests using methyl ester mahua (Madhuca indica) oil/diesel blends(2009) Godiganur, S.; Suryanarayana Murthy, C.H.; Reddy, R.P.Neat mahua oil poses some problems when subjected to prolonged usage in CI engine. The transesterification of mahua oil can reduce these problems. The use of biodiesel fuel as substitute for conventional petroleum fuel in heavy-duty diesel engine is receiving an increasing amount of attention. This interest is based on the properties of bio-diesel including the fact that it is produced from a renewable resource, its biodegradability and potential to exhaust emissions. A Cummins 6BTA 5.9 G2- 1, 158 HP rated power, turbocharged, DI, water cooled diesel engine was run on diesel, methyl ester of mahua oil and its blends at constant speed of 1500 rpm under variable load conditions. The volumetric blending ratios of biodiesel with conventional diesel fuel were set at 0, 20, 40, 60, and 100. Engine performance (brake specific fuel consumption, brake specific energy consumption, thermal efficiency and exhaust gas temperature) and emissions (CO, HC and NOx) were measured to evaluate and compute the behavior of the diesel engine running on biodiesel. The results indicate that with the increase of biodiesel in the blends CO, HC reduces significantly, fuel consumption and NOx emission of biodiesel increases slightly compared with diesel. Brake specific energy consumption decreases and thermal efficiency of engine slightly increases when operating on 20% biodiesel than that operating on diesel. © 2008 Elsevier Ltd. All rights reserved.Item Synthesis of biodiesel from edible and non-edible oils and characterisation(2009) Kapilan, N.; Ashok Babu, T.P.A.; Varun, J.D.In recent years, biodiesel has been receiving increasing attention because of scarcity and increasing cost of fossil fuels and growing emissions of combustion related pollutants. In the present work, biodiesel was synthesised via the transesterification of edible and non-edible oils such as gingili and mahua, with methanol as alcohol and sodium hydroxide as catalyst. The yield percentage obtained from non-edible mahua oil was comparable to that obtained from edible gingili oil, under optimum conditions. According to American Society of Testing and Methods (ASTM), several tests were conducted to characterise the biodiesel in relation to diesel oil, in order to evaluate various physical, chemical and thermal properties such as viscosity, acid value, iodine value, flash point, fire point and calorific value. From the results, it was observed that the fuel properties of biodiesel produced from mahua oil and gingili oil were within the recommended standards of biodiesel fuel of various countries. Hence the biodiesel produced from gingili oil and mahua oil can be used as a renewable alternative fuel for the diesel engine. © 2009 Energy Institute.Item Characterization and effect of using Mahua oil biodiesel as fuel in compression ignition engine(2009) Kapilan, N.; Ashok Babu, T.P.; Reddy, R.P.There is an increasing interest in India, to search for suitable alternative fuels that are environment friendly. This led to the choice of Mahua Oil (MO) as one of the main alternative fuels to diesel. In this investigation, Mahua Oil Biodiesel (MOB) and its blend with diesel were used as fuel in a single cylinder, direct injection and compression ignition engine. The MOB was prepared from MO by transesterification using methanol and potassium hydroxide. The fuel properties of MOB are close to the diesel and confirm to the ASTM standards. From the engine test analysis, it was observed that the MOB, B5 and B20 blend results in lower CO, HC and smoke emissions as compared to diesel. But the B5 and B20 blends results in higher efficiency as compared to MOB. Hence MOB or blends of MOB and diesel (B5 or B20) can be used as a substitute for diesel in diesel engines used in transportation as well as in the agriculture sector. © 2009 Science Press, Institute of Engineering Thermophysics, CAS and Springer Berlin Heidelberg.Item Effect of using Mahua as an alternative fuel in diesel engine(2009) Kapilan, N.; Ashok Babu, T.P.A.; Reddy, R.P.There is an increasing interest in India, to search for suitable alternative fuels that are environment friendly. This led to the choice of non-edible Mahua Oil (MO) as one of the main alternative fuels to diesel oil in India. The objective of the present work is to use MO as a partial renewable alternative substitute for diesel in the agricultural diesel engine. Since the viscosity of the MO is high, it was blended with conventional diesel oil in various proportions (M5, M10, M15 and M20 on volume basis) and fuel properties of the blends were determined and compared with the diesel. Engine tests were carried out on a single cylinder diesel engine at varying loads (0%, 25%, 50%, 75% and 100%), without making any modification in the fuel injection system and the results were compared with the diesel. The M5 and M10 blends resulted in performance and emission characteristics comparable to diesel operation and also emits lower carbon monoxide, hydrocarbon and smoke emissions as compared to other blends. From the analysis, it is concluded that the MO can be partially substituted for diesel oil in the diesel engine, without making any modification in the hardware of the engine.Item Combustion characteristics of diesel engine operating on jatropha oil methyl ester(Serbian Society of Heat Transfer Engineers, 2010) Dhananjaya, D.A.; Sudhir, C.V.; Mohanan, P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed interest of scientific community to look for alternative fuels of bio-origin such as vegetable oils. Vegetable oils can be produced from forests, vegetable oil crops, and oil bearing biomass materials. Non-edible vegetable oils such as jatropha oil, linseed oil, mahua oil, rice bran oil, karanji oil, etc., are potentially effective diesel substitute. Vegetable oils have reasonable energy content. Biodiesel can be used in its pure form or can be blended with diesel to form different blends. It can be used in diesel engines with very little or no engine modifications. This is because it has combustion characteristics similar to petroleum diesel. The current paper reports a study carried out to investigate the combustion, performance and emission characteristics of jatropha oil methyl ester and its blend B20 (80% petroleum diesel and 20% jatropha oil methyl ester) and diesel fuel on a single-cylinder, four-stroke, direct injections, water cooled diesel engine. This study gives the comparative measures of brake thermal efficiency, brake specific energy consumption, smoke opacity, HC, NOx, ignition delay, cylinder peak pressure, and peak heat release rates. The engine performance in terms of higher thermal efficiency and lower emissions of blend B20 fuel operation was observed and compared with jatropha oil methyl ester and petroleum diesel fuel for injection timing of 20° bTDC, 23° bTDC and 26° bTDC at injection opening pressure of 220 bar.Item The effect of karanja oil methyl ester on Kirloskar HA394DI diesel engine performance and exhaust emissions(Serbian Society of Heat Transfer Engineers, 2010) Godiganur, S.; Suryanarayana Murthy, Ch.; Reddy, R.P.Biofuels are being investigated as potential substitutes for current high pollutant fuels obtained from the conventional sources. The primary problem associated with using straight vegetable oil as fuel in a compression ignition engine is caused by viscosity. The process of transesterifiction of vegetable oil with methyl alcohol provides a significant reduction in viscosity, thereby enhancing the physical properties of vegetable oil. The Kirloskar HA394 compression ignition, multi cylinder diesel engine does not require any modification to replace diesel by karanja methyl ester. Biodiesel can be used in its pure form or can be blended with diesel to form different blends. The purpose of this research was to evaluate the potential of karanja oil methyl ester and its blend with diesel from 20% to 80% by volume. Engine performance and exhaust emissions were investigated and compared with the ordinary diesel fuel in a diesel engine. The experimental results show that the engine power of the mixture is closed to the values obtained from diesel fuel and the amounts of exhaust emissions are lower than those of diesel fuel. Hence, it is seen that the blend of karanja ester and diesel fuel can be used as an alternative successfully in a diesel engine without any modification and in terms of emission parameters; it is an environmental friendly fuel.Item Performance and emission characteristics of a Kirloskar HA394 diesel engine operated on fish oil methyl esters(2010) Godiganur, S.; Suryanarayana Murthy, Ch.; Reddy, R.P.The high viscosity of fish oil leads to problem in pumping and spray characteristics. The inefficient mixing of fish oil with air leads to incomplete combustion. The best way to use fish oil as fuel in compression ignition (CI) engines is to convert it into biodiesel. It can be used in CI engines with very little or no engine modifications. This is because it has properties similar to mineral diesel. Combustion tests for methyl ester of fish oil and its blends with diesel fuel were performed in a kirloskar H394 DI diesel engine, to evaluate fish biodiesel as an alternative fuel for diesel engine, at constant speed of 1500 rpm under variable load conditions. The tests showed no major deviations in diesel engine's combustion as well as no significant changes in the engine performance and reduction of main noxious emissions with the exception on NOx. Overall fish biodiesel showed good combustion properties and environmental benefits. © 2009 Elsevier Ltd. All rights reserved.