Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Investigation of steady state rheological properties and sedimentation of coated and pure carbonyl iron particles based magneto-rheological fluids(Elsevier Ltd, 2020) Swaroop, K.V.; Aruna, M.N.; Kumar, H.; Rahman, M.R.MR fluids face a major problem of sedimentation rate due to the high- density difference between the magnetic particles and the carrier medium that affects the performance of the magnetorheological devices. In this work, two MRF samples are prepared, where MRF-1 and MRF-2 are pure and coated carbonyl iron particles (CIPs) based MR fluids. The surface modification of the CIPs is performed using the solvent dispersion method to improve the sedimentation rate. The spherical shape and particle size analysis of the pure CIPs and coated CIPs' morphology is investigated using the Scanning Electron Microscope (SEM). The Thermal Gravimetric Analysis (TGA) shows that the coated CIPs have high thermal stability and confirm that 6% by wt. coating is present in the coated sample. The chemical bonding of the coated CIPs is detected using the Fourier Transform Infrared Spectroscopy (FT-IR). The saturation magnetization (Ms) of pure and coated CIPs is 245 emu/g and 120 emu/g, respectively, at 15 kOe, which is obtained by using a superconducting quantum interface device (SQUID). The rheology flow curve properties show that MRF-1 and MRF-2 exhibit yield stress of about 10 kpa and 9 kpa, respectively, for varying magnetic fields ranging from 0 to 343 kA/m. The Herschel-Bulkley model is fitted with the experimental data and the shear thinning behaviour is observed for both MR fluids. The sedimentation study shows that MRF-2 has better settling rate than MRF-1, which is observed by using the visual observation method up to 600 h. © 2020 Elsevier Ltd. All rights reserved.Item A novel approach to investigate effect of magnetic field on dynamic properties of natural rubber based isotropic thick magnetorheological elastomers in shear mode(Central South University of Technology f-ysxb@mail.csut.edu.cn, 2015) Hegde, S.; Kiran, K.; Gangadharan, K.V.The preparation of natural rubber based isotropic thick magnetorheological elastomers (MRE) was focused on by varying the percentage volume concentration of carbonyl iron powder and developing a test set up to test the dynamic properties. Effect of magnetic field on the damping ratio was studied on the amplification region of the transmissibility curve. The viscoelastic dynamic damping nature of the elastomer was also studied by analyzing the force-displacement hysteresis graphs. The results show that MR effect increases with the increase in magnetic field as well as carbonyl iron powder particle concentration. It is observed that softer matrix material produces more MR effect. A maximum of 125% improvement in the loss factor is observed for the MRE with 25% carbonyl iron volume concentration. FEMM simulation shows that as carbonyl iron particle distribution becomes denser, MR effect is improved. FEMM analysis also reveals that if the distance between the adjacent iron particles are reduced from 20 ?m to 10 ?m, a 40% increase in stored energy is observed. © 2014, Central South University Press and Springer-Verlag Berlin Heidelberg.Item Experimental investigation on the effect of carbon nanotube additive on the field-induced viscoelastic properties of magnetorheological elastomer(Springer New York LLC barbara.b.bertram@gsk.com, 2018) Poojary, U.R.; Hegde, S.; Gangadharan, K.V.The additives improve the properties of magnetorheological elastomer by modifying the surface of ferromagnetic filler particles or by varying the properties of a host polymer matrix. In this study, effect of carbon nanotube additive on the viscoelastic properties of magnetorheological elastomer reinforced with optimum quantity of ferromagnetic filler is studied. Room temperature vulcanizing silicone elastomer-based test samples are prepared by mixing the elastomer with the carbon nanotube and carbonyl iron powder blend obtained from ultrasonication. Viscoelastic properties are measured by adopting the dynamic blocked transfer stiffness method. The results revealed that the properties of magnetorheological elastomer vary significantly with the inclusion of carbon nanotube. With the addition of 0.5 wt% carbon nanotube, the zero field dynamic stiffness of magnetorheological elastomer is enhanced by 36.7% and the loss factor is increased by 17.2%. The enhancement in zero field properties led to the least field-induced enhancement for magnetorheological elastomer doped with 0.5 wt% carbon nanotube. A relatively larger flexibility of pure magnetorheological elastomer samples had resulted in the maximum field-induced enhancement of 48.04%. Among the prepared test samples with carbon nanotube addition, the sample loaded with 0.25 wt% carbon nanotube exhibited a pronounced stiffness enhancement and lower loss factor. This substantiated the existence of an optimum limit for carbon nanotube additive. The present study also confirmed the feasibility of developing MRE tailor-made to suit the particular application by selecting a proper composition of matrix, filler and the additives. © 2017, Springer Science+Business Media, LLC, part of Springer Nature.Item Semi-active vibration control of SiC-reinforced Al6082 metal matrix composite sandwich beam with magnetorheological fluid core(SAGE Publications Ltd info@sagepub.co.uk, 2020) Allien, J.V.; Kumar, H.; Desai, V.Dynamic characterization of silicon carbide particles reinforced Al6082 alloy metal matrix composite sandwich beam with magnetorheological fluid core is experimentally investigated. The study is focused on determining the effect of magnetorheological fluid core on the dynamic behavior of the sandwich structure. The magnetorheological fluid core is enclosed between the top and bottom metal matrix composite beams. The metal matrix composite beams are cast with silicon carbide particles in Al6082 alloy varying from 0 to 20 wt%. The magnetorheological fluid is prepared in-house and contains 30 vol.% carbonyl iron powder and 70 vol.% silicone oil. The free vibration test is conducted to determine the natural frequencies and damping ratio. It is found that the natural frequencies and damping ratio of the sandwich beams increased with an increase in the applied magnetic flux density. The experimental forced dynamic response of sandwich beams is carried out using sine sweep excitation. Vibration amplitude suppression capabilities of the sandwich beams subjected to varying magnetic flux densities are determined. The experimental forced vibration results reveal that metal matrix composite–magnetorheological fluid core sandwich beams have excellent vibration amplitude suppression capabilities. © IMechE 2019.Item Dynamic behavior of sandwich beams with different compositions of magnetorheological fluid core(Taylor and Francis Ltd., 2021) Acharya, S.; Allien, V.J.; Puneet, P.; Kumar, H.Magnetorheological fluid (MRF) sandwich beams belong to a class of adaptive beams that consists of MRF sandwiched between two or more face layers and have a great prospective for use in semi-active control of beam vibrations due to their superior vibration suppression capabilities. The composition of MRF has a strong influence on the MRF properties and hence affects the vibration characteristics of the beam. In this work, six MRF samples (MRFs) composed of combination of two particle sizes and three weight fractions of carbonyl iron powder (CIP) were prepared and their viscoelastic properties were measured. The MRFs were used to fabricate different MRF core sandwich beams. Additionally, a sandwich beam with commercially available MRF 132DG fluid as core was fabricated. The modal parameters of the cantilever MRF sandwich beams were determined at different magnetic fields. Further, sinusoidal sweep excitation tests were performed on these beams at different magnetic fields to investigate their vibration suppression behavior. MRF having larger particle size and higher weight fraction of CIP resulted in higher damping ratio and vibration suppression. Finally, optimal particle size and weight fraction of CIP were determined based on the maximization of damping ratio and minimization of weight of MRF. © 2021 The Author(s). Published by Informa UK Limited, trading as Taylor & Francis Group.