Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
32 results
Search Results
Item Experimental investigation of esters of mahua oil as an alternative fuel for dual fuel engine(2008) Reddy, P.B.; Kapilan, N.; Reddy, R.P.In the present work, an attempt was made to use methyl ester of mahua oil (MEMO) as substitute for dieselin dual fuel engine. A four stroke single cylinder engine was modified to work in dual fuel mode. From the test results, it was observed that the MEMO could be used as pilot fuel in dual fuel engine. At lower loads, diesel gave higher brake thermal efficiency. But at higher loads, biodiesel resulted in brake thermal efficiency comparable with diesel and lower smoke and oxides of nitrogen emissions. From the test results, it was concluded that MEMO could be used as a substitute for diesel in dual fuel engine.Item 6BTA 5.9 G2-1 Cummins engine performance and emission tests using methyl ester mahua (Madhuca indica) oil/diesel blends(2009) Godiganur, S.; Suryanarayana Murthy, C.H.; Reddy, R.P.Neat mahua oil poses some problems when subjected to prolonged usage in CI engine. The transesterification of mahua oil can reduce these problems. The use of biodiesel fuel as substitute for conventional petroleum fuel in heavy-duty diesel engine is receiving an increasing amount of attention. This interest is based on the properties of bio-diesel including the fact that it is produced from a renewable resource, its biodegradability and potential to exhaust emissions. A Cummins 6BTA 5.9 G2- 1, 158 HP rated power, turbocharged, DI, water cooled diesel engine was run on diesel, methyl ester of mahua oil and its blends at constant speed of 1500 rpm under variable load conditions. The volumetric blending ratios of biodiesel with conventional diesel fuel were set at 0, 20, 40, 60, and 100. Engine performance (brake specific fuel consumption, brake specific energy consumption, thermal efficiency and exhaust gas temperature) and emissions (CO, HC and NOx) were measured to evaluate and compute the behavior of the diesel engine running on biodiesel. The results indicate that with the increase of biodiesel in the blends CO, HC reduces significantly, fuel consumption and NOx emission of biodiesel increases slightly compared with diesel. Brake specific energy consumption decreases and thermal efficiency of engine slightly increases when operating on 20% biodiesel than that operating on diesel. © 2008 Elsevier Ltd. All rights reserved.Item Combustion characteristics of diesel engine operating on jatropha oil methyl ester(Serbian Society of Heat Transfer Engineers, 2010) Dhananjaya, D.A.; Sudhir, C.V.; Mohanan, P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed interest of scientific community to look for alternative fuels of bio-origin such as vegetable oils. Vegetable oils can be produced from forests, vegetable oil crops, and oil bearing biomass materials. Non-edible vegetable oils such as jatropha oil, linseed oil, mahua oil, rice bran oil, karanji oil, etc., are potentially effective diesel substitute. Vegetable oils have reasonable energy content. Biodiesel can be used in its pure form or can be blended with diesel to form different blends. It can be used in diesel engines with very little or no engine modifications. This is because it has combustion characteristics similar to petroleum diesel. The current paper reports a study carried out to investigate the combustion, performance and emission characteristics of jatropha oil methyl ester and its blend B20 (80% petroleum diesel and 20% jatropha oil methyl ester) and diesel fuel on a single-cylinder, four-stroke, direct injections, water cooled diesel engine. This study gives the comparative measures of brake thermal efficiency, brake specific energy consumption, smoke opacity, HC, NOx, ignition delay, cylinder peak pressure, and peak heat release rates. The engine performance in terms of higher thermal efficiency and lower emissions of blend B20 fuel operation was observed and compared with jatropha oil methyl ester and petroleum diesel fuel for injection timing of 20° bTDC, 23° bTDC and 26° bTDC at injection opening pressure of 220 bar.Item Experimental analysis of SI engine performance and emission characteristics with gasoline-denatured spirit blends as alternative fuels(2010) Hubballi, P.A.; Ashok Babu, T.P.The experimental study focused on investigating benefits of unleaded gasoline (P100) - denatured spirit [DNS (ethanol 93.3% v/v + water 6.7% v/v)] blends as fuel in a four cylinder four stroke SI engine. Performance tests were conducted to study volumetric efficiency (VolE), brake thermal efficiency (BThE), brake power (BP), engine torque (torque), brake specific fuel consumption (BSFC). Engine exhaust emissions were investigated for carbon monoxide (CO), hydrocarbons (HC), oxides of nitrogen (NOx) and carbon dioxide (CO2). Experiments were conducted at different engine speeds between 2500 - 4500 rpm maintaining throttle position of 50% throughout the experiments. The fuel blends used include DNS30P70 (ethanol 28 % + water 2% + gasoline 70 %), DNS50P50 (ethanol 46.65 % + water 3.35 % + gasoline 50 %) and DNS85P15 (ethanol 79.3 % + water 5.7 % + gasoline 15 %) which were compared with base fuel P100. The investigations revealed that blending DNS with P100 increases BThE, VolE, BP, torque and BSFC. The CO, HC, NOx and CO2 emissions in the exhaust decrease when compared to P100 operation. The DNS85P15 blend produced encouraging results in improved engine performance and decreased engine exhaust emission.Item Performance and emission characteristics of double cylinder CI engine operated with cardanol bio fuel blends(2012) Mallikappa, D.N.; Reddy, R.P.; Murthy, C.S.N.India imports more than seventy percent of the oil it uses and is looking for alternative fuel to reduce its dependence on imports. In India, bio fuels derived from non-edible oils is considered as a renewable alternative to the fossil diesel. The cost of the biodiesel is higher than diesel and hence in this work, cardanol was used as an alternative renewable fuel for the diesel engine. The engine tests were conducted on a double cylinder, direct injection, compression ignition engine. From the engine tests, it is observed that the brake power increases (by 70% approximately) as load increases. Brake specific energy conversion decreases (by 25-30% approximately) with increase in brake power. Brake thermal efficiency increases with higher brake power and emission levels (HC, CO, NOX) were nominal up to 20% blends. © 2011 Elsevier Ltd.Item Effect of oxygen enrichment of intake air on the performance and emission of single cylinder CI engine fueled with cardanol blends(Taylor and Francis Inc. 325 Chestnut St, Suite 800 Philadelphia PA 19106, 2015) Dinesha, P.; Mohanan, P.In this study, the effect of intake air enrichment on the performance and emission characteristics of a single-cylinder direct-injection diesel engine fueled with non edible oil namely Cardanol-diesel-methanol blend (B20M10) are investigated. With increase of intake air oxygen concentration, CO and HC decreased while brake thermal efficiency and NOx considerably increased. The maximum Brake Thermal Efficiency of 33.98% is obtained for B20M10 with 7% oxygen enrichment of intake air. Maximum NOx emission 20% is obtained for B20M10 with 7% oxygen enrichment for the full load condition. Decreases of 20% and 14.5% in CO emission are obtained for B20M10, over B20M10 with 7% oxygen enrichment, where as 76.8% and 74% decrease in hydrocarbon emission is obtained over B20M10 without oxygen enrichment.Item Experimental Investigation of Variations in Spark Timing using a Spark-Ignition Engine with Hydrogen-Blended Gasoline(Wiley-VCH Verlag info@wiley-vch.de, 2015) Shivaprasad, K.V.; Chitragar, P.R.; Kumar, G.N.This study describes an experiment conducted using an electronically controllable single-cylinder high-speed gasoline engine to analyze the performance and emissions characteristics of various hydrogen-gasoline blends. The experiments have been conducted for various engine speeds and spark timings at the wide open throttle position. The experimental results revealed that the engine brake thermal efficiency and brake mean effective pressure first increase and then decrease with the increase engine speed at all spark timings. The minimum amount of brake specific energy consumption was observed for 20% hydrogen addition in the total fuel blend at 3000rpm engine speed and 14°crank angle (CA) before top dead center (BTDC) spark timing. Hydrocarbon and carbon monoxide emissions were reduced with the retardation of spark timings. Nitrogen oxide emissions were continuously increased with the addition of hydrogen in the fuel blend as well as spark timing advance. © 2015 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim.Item Influence of spark timing on the performance and emission characteristics of gasoline–hydrogen-blended high-speed spark-ignition engine(Taylor and Francis Ltd. michael.wagreich@univie.ac.at, 2017) Shivaprasad, K.V.; Chitragar, P.R.; Nayak, V.; Kumar, G.N.This article experimentally investigates the effect of spark timing on performance and emission characteristics of high-speed spark-ignition (SI) engine operated with different hydrogen–gasoline fuel blends. For this purpose, the conventional carbureted SI engine is modified into an electronically controllable engine, wherein an electronically controllable unit was used to control the ignition timings and injection duration of gasoline. The tests were conducted with different spark timings at the wide open throttle position and 3000 rpm engine speed. The experimental results demonstrated that brake mean effective pressure and engine brake thermal efficiency increased first and then decreased with the increase in spark advance. Peak cylinder pressure, temperature and heat release rate were increased until 20% hydrogen addition and with increased spark timings. NOx emissions were continuously increased with the increment in both spark timings and hydrogen addition, whereas hydrocarbon emissions were increased with spark timings but decreased with hydrogen addition. CO emissions were reduced with the increase in spark timing and hydrogen addition. © 2016 Informa UK Limited, trading as Taylor & Francis Group.Item Design of magneto-rheological brake for optimum dimension(Springer Verlag service@springer.de, 2018) Lijesh, L.; Kumar, D.; Gangadharan, K.V.Online control of braking performance of magneto-rheological (MR) brake by bridling the apparent viscosity of MR fluid and by amending magnetic field is considered as an effective and smart option to replace the conventional disc brake. The magnetic field procreated by electromagnet in MR brake is reliant on dimensions and material properties of MR brake (casing, rotor and MR fluid region). Extensive works have been reported on enhancing the magnetic properties of MR fluid to achieve maximum braking performance; however, scarce works are available that reflects that the dimensions of MR brake influence the braking performance. Prior works on MR brakes focus on designing for meticulous outer dimensions of brakes, and thus, their results find little utility to a new designer. Therefore, the objective of the present work is to propose a methodology to determine the dimension of MR brake for a given outer dimensions, which shall provide maximum braking performance. The, braking performance is evaluated by assessing the effective torque and brake density. Magneto-static analysis using ANSYS is employed for determining the magnetic field in the MR region, and thereafter, the braking torque is calculated. From the obtained results, curve fit equations are proposed to estimate the values of (i) MR brake casing thickness, (ii) height of the MR brake to rotor, (iii) thickness of core, and (iv) thickness of MR fluid region, for achieving maximum torque. To validate the proposed methodology, MR brake with two different electromagnets and rotors is developed. The static performance of MR brake is evaluated by measuring the braking torque for different currents using a torque wrench and the dynamic performance of the MR brakes is performed on an MR brake test setup. The dynamic performance is evaluated by measuring viscous torque. Finally, the comparisons of the theoretical and experimental results are performed and the obtained results are presented. © 2018, The Brazilian Society of Mechanical Sciences and Engineering.Item An investigation on CRDi engine characteristic using renewable orange-peel oil(Elsevier Ltd, 2019) Bragadeshwaran, B.; Kasianantham, K.; Arumuga Perumal, D.A.; Babu, J.M.; Tiwari, A.; Sharma, A.Aiming towards discovering a solution for the imminent fossil fuel crisis, the research contributes towards the utilisation of orange peel oil as a potential alternative to mineral diesel while strictly adhering to the emission norms. The study reveals the performance, combustion and emissions characteristics obtained upon operating a 20% by volume of OPO blended with diesel, in a compression ignition engine, integrated with a common rail direct injection (CRDi) system. The fuel injection pressures were varied as 400 bar, 500 bar and 600 bar. Furthermore, two stage injection strategies were employed while varying the pilot charge quantity as 10%, 20% and 30%. Subsequently, 10% EGR was employed for the test with 30% pilot injection quantity upon realising that the respective NOx emissions were the highest for the same. All the results were compared with the test results while utilising diesel at 600 bar injection pressure. For OPO20 the brake thermal efficiency at full load was observed to be 31.37% higher and the brake specific fuel consumption 5.53% lower than that for diesel. In-cylinder pressure values recorded were almost similar to diesel corresponding to brake power. Heat release rate was significantly higher in case of orange peel oil. Additionally, it was found that smoke, unburned hydrocarbons content and carbon monoxide emission decreased by 16.30%, 27.63% and 42.28% respectively in the engine exhaust. Oxides of nitrogen were recorded to be 15.46% higher than that of diesel. © 2018 Elsevier Ltd