Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Solar photocatalysis for treatment of Acid Yellow-17 (AY-17) dye contaminated water using Ag@TiO2 core-shell structured nanoparticles(2013) Khanna, A.; Shetty K, K.Wastewater released from textile industries causes water pollution, and it needs to be treated before discharge to the environment by cost effective technologies. Solar photocatalysis is a promising technology for the treatment of dye wastewater. The Ag@TiO2 nanoparticles comprising of Ag core and TiO2 shell (Ag@TiO2) have unique photocatalytic property of inhibition of electron-hole recombination and visible light absorption, which makes it a promising photocatalyst for use in solar photocatalysis and with higher photocatalytic rate. Therefore, in the present work, the Ag@TiO2 nanoparticles synthesized by one pot method with postcalcination step has been used for the degradation of Acid Yellow-17 (AY-17) dye under solar light irradiation. The Ag@TiO2 nanoparticles were characterized using thermogravimetric-differential thermal analysis, X-ray diffraction, transmission electron microscopy, selected area electron diffraction, and energy dispersive X-ray analysis. The catalyst has been found to be very effective in solar photocatalysis of AY-17, as compared to other catalysts. The effects of pH, catalyst loading, initial dye concentration, and oxidants on photocatalysis were also studied. The optimized parameters for degradation of AY-17 using Ag@TiO2 were found to be pH 3, dye/catalyst ratio of 1:10 (g/g), and 2 g/L of (NH4)2S2O8 as oxidant. Efficient decolorization and mineralization of AY-17 was achieved. The kinetics of color, total organic carbon, and chemical oxygen demand removal followed the Langmuir-Hinshelwood model. Ag@TiO2 catalyst can be reused thrice without much decline in efficiency. The catalyst exhibited its potential as economic photocatalyst for treatment of dye wastewater. © 2013 Springer-Verlag Berlin Heidelberg.Item Simultaneous adsorption of Remazol brilliant blue and Disperse orange dyes on red mud and isotherms for the mixed dye system(Springer Verlag service@springer.de, 2017) Ratnamala, R.; Shetty K, K.V.; Srinikethan, G.The paper presents the adsorption of Remazol brilliant blue (RBB) and Disperse orange 25 (DO25) dyes from aqueous solution of the mixture of dyes onto concentrated sulphuric acid-treated red mud (ATRM). First-order derivative spectrophotometric method was developed for the analysis of RBB and DO25 in mixed dye aqueous solution to overcome the limitations arising due to interference in the zero-order spectral method. The optimum conditions to maximize RBB adsorption favoured the adsorption of RBB, and those for DO25 favoured DO25 adsorption from the mixed dye aqueous solutions. Presence of a second dye always inhibited the adsorption of a target dye. The uptake and percentage adsorption of each of the dyes onto ATRM from the aqueous solution of the mixture of dyes decreased considerably with increasing concentrations of the other dye showing the antagonistic effect. Monocomponent Langmuir isotherm fitted the mixed dye adsorption equilibrium data better than the monocomponent Freundlich isotherm. However, monocomponent models are suitable for the fixed concentration of the other dye. Modified Langmuir isotherm model adequately predicted the multi-component adsorption equilibrium data for RBB-DO25-ATRM adsorption system with a good accuracy and is more generic from the application point of view. © 2017, Springer-Verlag Berlin Heidelberg.Item Auto-combustion synthesis of narrow band-gap bismuth ferrite nanoparticles for solar photocatalysis to remediate azo dye containing water(Springer Science and Business Media Deutschland GmbH, 2021) Kalikeri, S.; Shetty K, V.Narrow band gap of ferrites makes it a good photocatalyst, and it plays very prominent role in the level of degradation of organic dyes by photocatalysis. In the current study, bismuth ferrite (BFO) nanoparticles were synthesized by auto-combustion technique. The synthesized BFO particles have the average crystallite size of 33 nm and band gap energy of 1.9 eV. As revealed by microscopic images, uniform, distinct, and hexahedral shaped BFO nanoparticles of 42.7 nm are formed. The BFO nanoparticles exhibited visible and solar light-mediated photocatalytic activity in degrading Acid Yellow-17. The optimum pH and catalyst loading were found to be pH 5 and 0.2 g/L respectively. Around complete degradation under solar and 95% degradation under visible light could be achieved within 135 min of irradiation. Around 85% and 83% chemical oxygen demand (COD) removal could also be achieved under solar and visible light respectively. The degradation followed first-order kinetics in terms of COD removal. The BFO nanoparticles are promising as solar light active catalysts for wastewater treatment. © 2020, Springer-Verlag GmbH Germany, part of Springer Nature.Item Continuous fixed-bed adsorption of reactive azo dye on activated red mud for wastewater treatment-Evaluation of column dynamics and design parameters(Springer Science and Business Media Deutschland GmbH, 2023) Mavinkattimath, R.G.; Shetty K, V.; Srinikethan, G.Continuous adsorption of Remazol Brilliant Blue (RBB) dye in water onto sulfuric acid activated red mud (CATRM) in a fixed bed column was investigated. Breakthrough curves were obtained experimentally by varying the bed height (Z), influent flow rate (Q), and dye concentration(C0). The adsorption efficiency in the removal of RBB was favored at lower C0, higher Z, and lower Q. The maximum adsorption capacity of the activated red mud bed in the column was obtained at C0 = 70 mg/L, Z = 8 cm, and Q = 5 mL/min and found to be 106 mg/g. Important parameters of column dynamics and design such as mass transfer zone (MTZ) and length of unused bed (LUB) were evaluated from the breakthrough curves. The MTZ and LUB have varied with varying Z, which indicated the existence of nonideal conditions. Thomas model was found to be valid to predict the column dynamics and the model parameters were evaluated. Bed depth service time (BDST) model parameters were evaluated to facilitate the determination of packed bed height for the design of packed bed adsorption column. The bed could be regenerated with NaOH solution with desorption efficiency decreasing from 83.8 to 55.72% from the first to third cycle. A fixed bed of CATRM can be effectively used for continuous dye removal from industrial wastewater. © 2023, The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.Item Mechanistic studies on bioremediation of dye using Aeromonas veronii immobilized peanut shell biochar(Academic Press Inc., 2024) Singh, A.; Manikandan, S.K.; Nair, V.Recalcitrant chemicals in the environment not only present obstacles to living organisms but also contribute to the degradation of natural resources. One contribution to environmental pollution is the discharge of synthetic dyes from the textile sector. This study investigates the combined effect of microbial cells and biochar on eliminating methyl orange (MO) dye. The immobilization of Aeromonas veronii on peanut shell biochar (APSB) was conducted to investigate its efficacy in removing MO dye from water. PSB synthesized by pyrolysis at 300 °C for 120 min showed maximum bacterial immobilization potential. The highest degradation rate of 96.19 % was achieved in APSB within 96 h using MO dye concentration of 100 mg L?1, incubation temperature of 37 °C, pH 7, and biocatalyst dosage of 1g L?1. In comparison, free cells achieved degradation rates of 72.53 % and 61.56 % for PSB. Moreover, the adsorption process was primarily controlled by PSB, with subsequent dye mineralization by A. veronii, as supported by FTIR and LC-MS studies. Moreover, this innovative approach exhibited the reusability of the biocatalyst, giving 76.23 % removal after fifth cycle, suggesting sustainable alternative in dye remediation and potential option for real-time applications. © 2024 Elsevier Inc.Item Extracellular biosynthesis of CuO-TiO2 nanocomposites using Alcaligenes aquatilis for the photodegradation of reactive and azo dyes under visible light irradiation(Springer, 2025) Agarwalla, S.; Shetty K, V.In this study, CuO/TiO2 nanocomposites were biologically synthesized using cell-free supernatant (CFS) of Alcaligenes aquatilis growth culture by two-step synthesis method, one-pot method with sequential addition of precursors, and one-pot method with simultaneous addition of precursors. The one-pot method with simultaneous addition of precursors was found to be the best method for the synthesis in terms of degradation of reactive blue-220 (RB-220) and acid yellow-17 (AY-17) dyes under visible light irradiation. CuO/TiO2 nanocomposite was found to have the crystallite size of 14.7nm and the bandgap energy of 2.5 eV. The effect of synthesis parameters such as synthesis time, pH of CFS, and the ratio of Cu to Ti in the synthesis mixture on the photocatalytic degradation efficacy of these nanocomposite structures under visible light irradiation was studied. The optimum conditions for the synthesis of CuO/TiO2 nanocomposite particles by one-pot method with simultaneous addition of precursors were found to be pH 12 of CFS, synthesis duration of 24 h, and molar ratio of Cu to Ti in the synthesis mixture as 1:22 for RB-220 dye and 1:25 for AY-17 degradation. CuO/TiO2 nanocomposite particles synthesized under the optimum conditions and without any calcination could degrade RB-220 and AY-17 dyes completely in 120 min and 150 min, respectively. The kinetics of degradation of RB-220 and AY-17 by CuO@TiO2 nanocomposite particles followed first-order kinetic model with rate constant of 0.028 min?1 and 0.018 min?1, respectively. © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2023.