Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Impact of changing compression ratio on engine characteristics of an SI engine fueled with equi-volume blend of methanol and gasoline(Elsevier Ltd, 2020) Nuthan Prasad, B.S.; Pandey, J.K.; Kumar, G.N.In the present investigation, experiments were conducted in wide open throttle condition (WOT) for different speed ranging from 1200 rpm to 1800 rpm at an interval of 200 on a single-cylinder four-stroke variable compression ratio (VCR) SI engine. The engine fueled with equi-volume blend of methanol/gasoline fuel, while 14° BTDC ignition timing is maintained for all three different compression ratios (8, 9 & 10). Increasing the compression ratio from CR8 to CR10 for the methanol/gasoline blend has improved combustion efficiency by increasing the peak pressure and net heat release value by 27.5% and 30% respectively at a speed of 1600 rpm. The performance results show a good agreement of improvisation of 25% increase in BTE, and BSFC reduction by 19% at compression ratio 10:1. At higher compression ratio 10:1, there was a significant decrease observed in CO and HC by 30–40%, and the same trend is observed at all speeds; however, NOx emission increased with the increasing CR. © 2019 Elsevier LtdItem Effect of hydrogen enrichment on performance, combustion, and emission of a methanol fueled SI engine(Elsevier Ltd, 2021) Nuthan Prasad, B.S.; Pandey, J.K.; Kumar, G.N.The study of potentially high rated alternative fuel (Methanol) for the IC engines is an exciting topic in the recent research advancement. However, the study of combination of methanol and hydrogen is considered to address both economic and environmental needs. Hydrogen with best combustion characteristics will compensate for the drawbacks of methanol as a fuel. In the present investigation hydrogen enrichment to methanol has shown a significant enhancement in performance and combustion; the overall emission has reduced substantially. The experiments for a different set of trials, including hydrogen enrichment ranging between 5% and 20% with 2.5% increment, the engine is operated with wide-open throttle (WOT) condition for different speeds. The increase in enrichment of hydrogen has shown a rise in BTE, BP, and a reduced BSEC value. The percentage increase in BTE is between 20 and 30%, and an increase in hydrogen beyond 12.5% would affect the volumetric efficiency, and thus performance declines after that. The exhaust emissions have a huge impact on hydrogen enrichment; CO, HC, and CO2 emission are reduced by 30–40%; however, an increase in cylinder temperature due to rapid combustion slightly increases the NOx emission. Thus hydrogen enriched methanol operating at higher compression ratio can improve the overall engine characteristics significantly. © 2021 Hydrogen Energy Publications LLCItem Effect of variable compression ratio and equivalence ratio on performance, combustion and emission of hydrogen port injection SI engine(Elsevier Ltd, 2022) Pandey, J.K.; Kumar, G.N.The present study includes an experimental investigation of the performance, combustion, and emission parameters of a hydrogen port fueled SI engine under wide-open throttle. The compression ratio (CR) is varied from 10 to 15, equivalence ratio (φ) from 0.4 to 1.0, and speed from 1400RPM to 1800RPM. The ignition timing is maintained at 20° before the top dead center. The brake thermal efficiency increases by nearly 10% from CR10 to CR15, and it also increased by 13.7% by changing φ from 0.4 to 0.9. Similarly, BP increases in the same fashion. The combustion enhances with an increase in peak pressure by increasing CR from 10 to 15 and φ from 0.4 to 0.9; however, φ 1.0 exhibits a negative trend. However, the NOX emission increases continuously with CR and φ, and so as the exhaust gas temperature. The carbon-based emissions are negligible, and volumetric efficiency decreases with φ and increases with CR. © 2021 Elsevier LtdItem Study of performance, combustion, and NOx emission behavior of an SI engine fuelled with ammonia/hydrogen blends at various compression ratio(Elsevier Ltd, 2022) Dinesh, M.H.; Pandey, J.K.; Kumar, G.N.In the present paper, an experimental investigation has been performed under variable CR and 1400&1800RPM speed at a fixed spark timing of 24ºCA BTDC under wide-open throttle conditions. The hydrogen blending is performed based on energy fractions from 5% to 21% of the total fuel energy. With increasing compression ratio (CR), the flame development gets faster, and the flame propagation speed improves, leading to a short combustion period. Similarly, increasing hydrogen fraction improves combustion, resulting in a rapid rise in pressure and temperature. Despite a 13.64% decrease in volumetric efficiency from 5% to 21% hydrogen fraction at 1400 and 1800 RPM, BP and BTE increased by 16.89% and 33%, respectively. The slow-burning properties of NH3 extend the combustion period, resulting in a long-delayed burning period. As a result, the temperature of the low-hydrogen fraction of the exhaust gas is higher. As the hydrogen fraction and CR increase, this effect decreases, resulting in lower EGT. The hydrogen addition increases the peak temperature; therefore, NOx increases continuously with increasing hydrogen despite reducing ammonia. Ammonia is a key element used to reduce NOx from vehicles. A practical solution for controlling the NOx due to the ammonia/hydrogen blend is selective catalytic reduction (SCR). © 2022 Hydrogen Energy Publications LLCItem Influence of ignition timing on performance and emission characteristics of an SI engine fueled with equi-volume blend of methanol and gasoline(Taylor and Francis Ltd., 2023) Nuthan Prasad, B.S.; Kumar, G.N.In the present investigation, experiments were conducted in wide open throttle condition (WOT) for different speed ranging from 1400 rpm to 1800 rpm at an interval of 200 on a single-cylinder four-stroke port-injected; spark-ignition engine. The engine fueled with equi-volume blend of methanol/gasoline was tested for different ignition timing and its effects on engine characteristics. The experiment results shown, retardation of ignition timing to 14⁰ BTDC exhibits excellent results compared to 24⁰ BTDC ignition timing. The results obtained show a good agreement of improvisation observed with M50 fuel in terms of BTE and BSEC at a speed of 1600 rpm when compared to gasoline fuel. The optimal ignition timing attributes to good combustion efficiency with increasing cylinder pressure and heat release rate. However, low carbon–hydrogen ratio and oxygen content in methanol aids to reduced NOx, HC, and CO emissions by 50%, 35%, and 40%, respectively. The small increase of 10% in CO2 emission is observed; this is due to retardation of ignition time, which allows the M50 fuel to absorb sufficient energy and achieve complete combustion. © 2019 Taylor & Francis Group, LLC.