Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
4 results
Search Results
Item Experimental analysis of SI engine performance and emission characteristics with gasoline-denatured spirit blends as alternative fuels(2010) Hubballi, P.A.; Ashok Babu, T.P.The experimental study focused on investigating benefits of unleaded gasoline (P100) - denatured spirit [DNS (ethanol 93.3% v/v + water 6.7% v/v)] blends as fuel in a four cylinder four stroke SI engine. Performance tests were conducted to study volumetric efficiency (VolE), brake thermal efficiency (BThE), brake power (BP), engine torque (torque), brake specific fuel consumption (BSFC). Engine exhaust emissions were investigated for carbon monoxide (CO), hydrocarbons (HC), oxides of nitrogen (NOx) and carbon dioxide (CO2). Experiments were conducted at different engine speeds between 2500 - 4500 rpm maintaining throttle position of 50% throughout the experiments. The fuel blends used include DNS30P70 (ethanol 28 % + water 2% + gasoline 70 %), DNS50P50 (ethanol 46.65 % + water 3.35 % + gasoline 50 %) and DNS85P15 (ethanol 79.3 % + water 5.7 % + gasoline 15 %) which were compared with base fuel P100. The investigations revealed that blending DNS with P100 increases BThE, VolE, BP, torque and BSFC. The CO, HC, NOx and CO2 emissions in the exhaust decrease when compared to P100 operation. The DNS85P15 blend produced encouraging results in improved engine performance and decreased engine exhaust emission.Item An investigation on CRDi engine characteristic using renewable orange-peel oil(Elsevier Ltd, 2019) Bragadeshwaran, B.; Kasianantham, K.; Arumuga Perumal, D.A.; Babu, J.M.; Tiwari, A.; Sharma, A.Aiming towards discovering a solution for the imminent fossil fuel crisis, the research contributes towards the utilisation of orange peel oil as a potential alternative to mineral diesel while strictly adhering to the emission norms. The study reveals the performance, combustion and emissions characteristics obtained upon operating a 20% by volume of OPO blended with diesel, in a compression ignition engine, integrated with a common rail direct injection (CRDi) system. The fuel injection pressures were varied as 400 bar, 500 bar and 600 bar. Furthermore, two stage injection strategies were employed while varying the pilot charge quantity as 10%, 20% and 30%. Subsequently, 10% EGR was employed for the test with 30% pilot injection quantity upon realising that the respective NOx emissions were the highest for the same. All the results were compared with the test results while utilising diesel at 600 bar injection pressure. For OPO20 the brake thermal efficiency at full load was observed to be 31.37% higher and the brake specific fuel consumption 5.53% lower than that for diesel. In-cylinder pressure values recorded were almost similar to diesel corresponding to brake power. Heat release rate was significantly higher in case of orange peel oil. Additionally, it was found that smoke, unburned hydrocarbons content and carbon monoxide emission decreased by 16.30%, 27.63% and 42.28% respectively in the engine exhaust. Oxides of nitrogen were recorded to be 15.46% higher than that of diesel. © 2018 Elsevier LtdItem Impact of 1-Hexanol/diesel blends on combustion, performance and emission characteristics of CRDI CI mini truck engine under the influence of EGR(Elsevier Ltd, 2020) Santhosh, K.; Kumar, G.N.Biofuels are the most promising sustainable and renewable alternative to diesel fuel. In the present renewable energy world, alcohols are gaining prime importance due to their nature of production and fuel properties. The present work aims to investigate the impact of 1-Hexanol and exhaust gas recirculation (10% and 20%) on engine characteristics of the common rail direct injection compression ignition engine. The experiment is carried out on a bench engine. The fraction of 1-Hexanol is varied from 10% to 40% in a step of 10% by volume. The results demonstrate that the use of 1-Hexanol/diesel blends lowers the cylinder pressure and mean gas temperature, which is 4.25% and 1.88% lower at 60% load for 40% 1-Hexanol compared to neat diesel fuel operation. The combustion duration is increased by 2.66?CA for 40% 1-Hexanol at 60% load compared to neat diesel fuel. However, an improvement in net heat release rate is noted which is 13.95% higher at 60% load for 40% 1-Hexanol, this increment is due to prolonged ignition delay. With the use of 1-Hexanol in the engine, there is a drastic reduction in nitrogen oxide emission is observed, this is the greatest impact of 1-Hexanol. However, a slight increment in the hydrocarbon and carbon monoxide emission is also noted due to poor fuel properties like lower cetane number, higher viscosity and higher latent heat of evaporation of 1-Hexanol. Compared to all other blends in the test 10% 1-Hexanol shows comparable results with pure diesel fuel, which is only 2.37% lower in brake thermal efficiency, 3.6% higher in brake specific fuel consumption, 17.55% lower in nitrogen oxide emission, 18.18% higher in hydrocarbon and 33.33% higher in carbon monoxide emission is noted. The exhaust gas recirculation helps in reducing the NOx emission, 40% 1-Hexanol is less sensitive to exhaust gas recirculation. Up to 40% of 1-Hexanol can be used in the CI engine without any modification. It is concluded that 1-Hexanol is a sustainable renewable biofuel due to the reason that even though the use of 1-Hexanol lowers the performance which helps in reducing the NOx emission greatly; the performance can be improved by modifying the engine parameters. © 2020 Elsevier LtdItem Combustion, performance, and emission characteristics of dairy-washed milk scum biodiesel in a dual cylinder compression ignition engine(Taylor and Francis Inc. 325 Chestnut St, Suite 800 Philadelphia PA 19106, 2020) Srikanth, H.V.; Venkatesh, J.; Godiganur, S.; Manne, B.; Bharath Kumar, S.; Spurthy, S.The present work has been carried out to study the suitability of milk dairy waste scum (MDWS) biodiesel as a fuel for diesel engine. The investigations were carried out on performance, emission and combustion characteristics of a direct injection dual cylinder diesel engine fueled with MDWS methyl ester, and their blends. Two-step transesterification process was used to synthesize the MDWS biodiesel, characterization according to specified ASTM D6751-15C standards. The performance characteristics studies showed an increased brake thermal efficiency of B20 (3%) and B30 (0.94%) blends in comparison to fossil diesel. However, the increased brake specific fuel consumption (BSFC) was also found with all the fuel blends and an higher (9%) BSFC was obtained with B50 compared to diesel fuel at full load condition. The emissions of blends were found to be lower in comparison with diesel fuel, except for nitrogen oxides. A 32% increase in NOx emission was found with B50 blend compared to diesel fuel at maximum load condition. However, improved combustion characteristics would found with MDWS blends with respect to in-cylinder pressure, ignition delay, and heat release rate compared to fossil diesel. © 2019 Taylor & Francis Group, LLC.