Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Effect of thermal response on physical properties during drilling operations-A case study(Elsevier Ltd, 2018) Vijay Kumar, S.; Murthy, Ch.S.N.; Kunar, B.M.The temperature induced or generated during deep hole drilling operations is due to the heat generated between the interface of work piece surface and the tool surface. Several research study have been conducted to predict the temperature involved while drilling process as a predominant functions of many parameters like feed rate, torque, depth of cut etc. Similarly many experimental procedures have been conducted by several researchers to measure temperature directly by using thermocouples, infrared measurement, pyrometer, and thermisters etc. There is no precise experimental method is available to measure analytical value of energy, power, heat flux etc, while drilling process. The temperature rigma depends on material compositions and physical properties. This paper presents the influence of temperature on physical properties of some study samples during drilling operations. © 2017 Elsevier Ltd.Item Dynamic Mechanical Analysis and Thermal Stability of Neem Wood Veneer Plastic Composites(Elsevier Ltd, 2019) Nagamadhu, M.; Vijay Kumar, S.; Ravi Kumar, S.; Suraj, R.; Kumar, G.C.The neem wood veneer is used as core materials in many of the wood structural applications. In this research work, neem wood polymer composite (NWPC) were prepared to understand the effect of weight fraction, stacking sequence, and interfacial bonding between neem wood veneer and epoxy material. NWPC were prepared conventional compression molding and Thermo-mechanical properties of wood epoxy composite samples were investigated by the dynamic mechanical analyzer over the temperature range from 30 to 180°C. Storage modulus (G') and Loss modulus (G") of NWPC samples exhibited significant effect with respect weight fraction of wood veneer. Similarly epoxy has good interfacial bonding agent to enhance the strength of multilayered wood polymer composites. However, the stacking sequence having major changes in dynamic mechanical properties, G' & G" increases along the wood fiber direction with negligible load bearing capacity in transfers direction. By changing the orientation of the wood veneer properties improved in both the direction. Additionally, scanning electron microscopy (SEM) evidently shows the interfacial bonding efficiency. © 2019 Elsevier Ltd.Item Temperature Measurement During Rotary Drilling of Rocks - A Statistical Approach(Springer Nature, 2020) Vijay Kumar, S.; Kunar, B.M.; Murthy, C.S.N.This paper discusses a statistical analysis to measure the temperature during rotary drilling of fine-grained sandstone (pink) using embedded thermocouple method. The regression models consist of three input variables such as diameter of the bit, rpm and rate of penetration for different depth of thermocouples. Experimental test were conducted in computer numerical control (CNC) vertical machining centre. The measured temperature has been applied to study the influencing parameter using statistical technique. Analysis of variance (ANOVA) shows that the percentage contribution ratio of each operational parameters on temperature (output response). The most influencing parameter for temperature is rate of penetration with a percentage contribution of 71.32%, followed by drill bit diameter and spindle speed which contribute 19.27% and 2.99% respectively. The ANOVA and regression models for temperature give p-values of less than 0.05. Hence the predicted regression models are statistically significant and good predictive capabilities with acceptable accuracy. © 2020, Springer Nature Switzerland AG.