Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item A heterogeneous process such as open die extrusion has been done on CP titanium and the extent of heterogeneity has been determined. The pressure for carrying out the process has been calculated theoretically, measured experimentally and calculated indirectly from hardness measurement in the deformation zone. Hardness-stress-train correlation is very useful here. A nomogram has been given so that knowing, ?, ?, ? and hardness, the punch pressure can be read off. It is a steady-reckoner that is very relevant for the shop floor in industry or the laboratory.(Elsevier Science S.A., Hardness-stress-strain correlation in titanium open die extrusion: an alternative to visioplasticity) Srinivasan, K.; Venugopal, P.1999Item Influence of die angle on containerless extrusion of commercially pure titanium tubes(2007) Srinivasan, K.; Venugopal, P.Containerless tube extrusion has been investigated with commerically pure titanium at room temperature and a strain rate of 0.07 s-1 using 20 conical dies of five different strains and four different angles with MoS2 lubricant. Theoretical punch pressures have been calculated using appropriate equations from slab analysis of the process and compared with experimentally determined punch pressures. It is found that there exists an optimum angle at which the punch pressure is the least at a given strain.Item Formability limit in containerless (open die) extrusion of commercial purity titanium rods and tubes(2008) Srinivasan, K.; Venugopal, P.Containerless extrusion requires far less forces compared to conventional direct extrusion of rods and tubes due to the elimination of container wall-billet friction. But the strains that can be imparted are less in the former due to the unsupported billet which gets upset first if the axial stress exceeds yield stress of the billet material. If this stress is equal to yield stress, it corresponds to the limit of the process of pure containerless extrusion. It is found that this limit strain as predicted by theory is far less compared to what is observed experimentally. This discrepancy is explained on the basis of heating that takes place in the deformation zone due to ideal, frictional, and shear work done in carrying out the extrusion process.