Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Venkataramana, K.Subject: search.filters.subject.elastic modulus

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    Studies on Uniaxial compressive strength of laterite masonry prisms
    (2011) Unnikrishnan, S.; Narasimhan, M.C.; Venkataramana, K.
    Laterite is a well known conventional building material in Asian countries. In spite of its large popularity in construction, a systematic characterization of this material, as a building block, has not been seriously attempted so far. The strength and elastic properties of laterite masonry are influenced by the individual properties of the laterite blocks and the mortar. In the present study, characterization of the laterite block and the mortar and compressive strength of laterite masonry prisms have been investigated using detailed laboratory experiments and numerical analysis. The experimental results, related to the compressive strength and stress-strain characteristics of laterite and mortar and compressive strength of laterite masonry prisms are presented. Finite element analysis of laterite masonry prism has also been carried out. The studies have shown that the modulus of elasticity of laterite blocks tested is less than that of mortar used in making the laterite masonry. Further, the laterite masonry prisms have been observed to have failed by bond failure and subsequent splitting of laterite blocks. Also, increase in thickness of mortar joint gives rise to a decrease in laterite tensile stresses in mortar joint leading to higher prism strengths, if bond remains intact. © 2011 CAFET-INNOVA technical society. All right reserved.
  • No Thumbnail Available
    Item
    Experimental studies on the effects of corrosion on the flexural strength of RC beams
    (CAFET INNOVA Technical Society cafetinnova@gmail.com 1-2-18/103, Mohini Mansion, Gagan Mahal Road, Domalguda, Hyderabad 500029, 2014) Pandit, P.; Venkataramana, K.; BabuNarayan, K.S.; Parla, B.; Kimura, Y.
    RC structures are generally very durable and are capable of withstanding a variety of adverse environmental conditions. However, failures of these structures still occur and reinforcement corrosion is one of the major causes. In the present research, corroded Ordinary Portland Cement (OPC) beams were tested in the laboratory to evaluate their flexural behavior. Accelerated corrosion technique was adopted to corrode the beams. The corrosion was measured using Applied Corrosion Monitoring (ACM) instrument. From the results, it is seen that, as the rate of corrosion increases, the load carrying capacity decreases. The deflection increases initially and then decreases. It is observed that the stiffness of the beams is reduced when rate of corrosion is increased due to changes in the modulus of elasticity of corroded steel. © 2014 CAFET-INNOVA TECHNICAL SOCIETY.