Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item LiClO4-doped plasticized chitosan and poly(ethylene glycol) blend as biodegradable polymer electrolyte for supercapacitors(Institute for Ionics, 2013) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.Biodegradable polymer electrolyte comprising the blend of chitosan (CS) and poly(ethylene glycol) (PEG) plasticized with ethylene carbonate and propylene carbonate, as host polymer, and lithium perchlorate (LiClO4), as a dopant, was prepared by solution casting technique. The ionic conductivity has been calculated using the bulk impedance obtained through impedance spectroscopy. The variation of conductivity and dielectric properties has been investigated as a function of polymer blend ratio, plasticizer content and LiClO4 concentration at temperature range of 298-343 K. The DSC thermograms show two broad peaks for CS/PEG blend and increased with increase in the LiClO4 content. The maximum conductivity has been found to be 1. 1 × 10-4 S cm-1 at room temperature for 70:30 (CS/PEG) concentration. The electric modulus of the electrolyte film exhibits a long tail feature indicative of good capacitance. The activation energy of all samples was calculated using the Arrhenius plot, and it has been found to be 0. 12 to 0. 38 eV. A carbon-carbon supercapacitor has been fabricated using this electrolyte, and its electrochemical characteristics and performance have been studied. The supercapacitor showed a fairly good specific capacitance of 47 F g-1. © 2012 Springer-Verlag.Item Tubular array, dielectric, conductivity and electrochemical properties of biodegradable gel polymer electrolyte(Elsevier Ltd, 2014) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.A supercapacitor based on a biodegradable gel polymer electrolyte (GPE) has been fabricated using guar gum (GG) as the polymer matrix, LiClO4 as the doping salt and glycerol as the plasticizer. The scanning electron microscopy (SEM) images of the gel polymer showed an unusual tubular array type surface morphology. FTIR, DSC and TGA results of the GPE indicated good interaction between the components used. Highest ionic conductivity and lowest activation energy values were 2.2 × 10-3 S cm-1 and 0.18 eV, respectively. Dielectric studies revealed ionic behavior and good capacitance with varying frequency of the GPE system. The fabricated supercapacitor showed a maximum specific capacitance value of 186 F g -1 using cyclic voltammetry. Variation of temperature from 273 K to 293 K did not significantly influence the capacitance values obtained from AC impedance studies. Galvanostatic charge-discharge study of supercapacitor indicated that the device has good stability, high energy density and power density. © 2013 Elsevier Ltd. All rights reserved.Item Reduced graphene oxide derived from used cell graphite and its green fabrication as an eco-friendly supercapacitor(Royal Society of Chemistry, 2014) Sudhakar, Y.N.; Muthu, M.; Bhat, D.; Senthil Kumar, S.Graphite extracted from a used primary cell was converted into reduced graphene oxide (rGO) using calcium carbonate together with rapid and local Joule heating by microwave irradiation. Electrodes were prepared by ultrasonically dispersing rGO in biodegradable poly(vinylpyrrolidone) (PVP) binder and coating this on recyclable poly(ethyleneterephthalate) (PET) sheet using a low cost screen printing technique. The use of the same polymer (PVP) as a binder, in addition to as the solid polymer electrolyte (SPE), enhances the compatibility and ionic conductivity of the hydrophobic rGO electrode in the supercapacitor system. Further, the phosphoric acid (H3PO4)-doped biodegradable SPE was screen printed for the first time on the rGO electrodes. Ionic conductivity and dielectric studies of the SPE were carried out at different temperatures and different dopant acid concentrations. The morphology, composition and structure of the graphene electrode components were characterized using Fourier transform infrared spectroscopy (FTIR), Raman spectroscopy, X-ray diffraction (XRD), scanning electron microscopy (SEM) and X-ray photoelectron spectroscopy (XPS) methods. Transmission electron microscopy (TEM) images showed a single layer or a few layers of rGO sheets and selected area electron diffraction showed the presence of slight defects. The fabricated environmentally friendly, industrially favorable and green supercapacitor showed a specific capacitance of 201 F g-1 and cyclic stability with 97% retention of the initial capacitance over 2000 cycles. Furthermore, the performance of this green supercapacitor is comparable to that of those fabricated using rGO synthesized from commercial graphite and in other literature reports. © 2014 The Royal Society of Chemistry.Item Effect of acid dopants in biodegradable gel polymer electrolyte and the performance in an electrochemical double layer capacitor(Institute of Physics Publishing custserv@iop.org, 2015) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.Proton-conducting biodegradable gellan gum gel polymer electrolytes (GPEs) have been prepared using three different dopants, namely ortho-phosphoric (o-H3PO4), sulfuric (H2SO4) and hydrochloric acids (HCl). The GPEs were cross-linked using borax. The polymeric gels were characterized by spectroscopic, thermal, ionic conductivities and dielectric measurements. Proton conductivity was in the range of 5.1 × 10-3 to 3.7 × 10-4 s cm-1 and activation energies were between 0.14 meV and 0.19 meV, at different temperatures. Among the doped acids, the H3PO4 doped GPE exhibited thermal stability at varying temperature. Electrochemical double layer capacitors (EDLCs) were fabricated using activated carbon as electrode material and GPEs. The EDLCs were tested using cyclic voltammetry, ac impedance spectroscopic and galvanostatic charge-discharge techniques. The maximum specific capacitance value was 146 F g-1 at a scan rate of 2 mV s-1. Quite stable values were obtained at a constant current density up to 1000 cycles. © 2015 The Royal Swedish Academy of Sciences.Item Preparation and characterization of phosphoric acid-doped hydroxyethyl cellulose electrolyte for use in supercapacitor(SpringerOpen, 2015) Sudhakar, Y.N.; Muthu, M.; Bhat, D.K.A new borax cross-linked biodegradable solid polymer electrolyte based on hydroxyethyl cellulose and phosphoric acid (H3PO4) was prepared. Characterizations of doped and undoped SPE were done using Fourier transform infrared spectroscopic and electrochemical studies. The ionic conductivity of the films increased with increase in acid concentration and the ionic conductivity obtained at 303 K was 4.1 × 10-3 S cm-1. Furthermore, effects of acid concentration on ionic conductivity and activation energy were discussed. Dielectric studies showed long tail-like feature indicating capacitive nature. A supercapacitor was fabricated and its electrochemical characteristics were studied. The supercapacitor showed a fairly good specific capacitance of 83 F g-1 at 2 mV s-1 and galvanostatic charge-discharge studies showed the mirror-like pattern with 98 % columbic efficiency. Cyclic stability was measured up to 2000 cycles. © 2015 The Author(s).Item Investigation of column purified dye derived carbon nanomaterials for security printing and supercapacitor applications(Elsevier B.V., 2024) Mehta, R.; Ullal, N.; Sahoo, B.; Dhanya, D.; Kulkarni, S.D.; Sudhakar, Y.N.; Abdul Salam, A.A.; K, U.B.; Anand, P.J.Literature evidence reveals versatile applications of carbon dots (CDs), but generally mixtures of various types of carbon nanomaterials, molecular intermediates as well as side products are obtained upon hydrothermal treatment of the precursor material. This demands isolation of pure components and their complete characterization before these nano carbonaceous materials are chosen for suitable applications. In the present study, perylenetetracarboxylic dianhydride (PTCDA) is subjected to hydrothermal treatment and the mother liquor obtained is separated using column chromatography technique using dichloromethane-methanol solvent system to isolate fractions of various fluorescent carbonaceous nanostructures. The TEM imaging of nano carbonaceous particles of all five fractions indicated that the first and third fractions were composed of nanoribbons, while the latter two fractions largely contained quasi-spherical nanoparticles of both lesser (carbon quantum dots) and greater (carbon nanodots) than 10 nm dimensions. The XPS results of all the fractions suggested separation based on polarity difference. The ID/IG ratios obtained from Raman spectra implied the presence of several defects on the CDs. The time resolved fluorescence spectra of third, fourth and fifth fractions revealed mono-exponential decay of fluorophores with excitation independent average lifetime values. The fifth fraction exhibited good biocompatibility and the highest absolute fluorescence quantum yield of 58.47 % among all the isolated samples. As these CDs displayed a remarkable rise in the quantum yield to 88.60 % when dispersed in water, a water-based flexo-ink was formulated. The photostable pale yellow flexo print proofs obtained on UV dull paper exhibited a green fluorescence under 365 nm illumination, whereas a yellow glow when shined with blue light, which can serve as an authentication feature for security documents and currency notes. Moreover, as the third fraction constitutes mainly of carbon nanoribbons (CNRs), an optimized polymer electrolyte was prepared along with sodium alginate (SA), and MgCl2 to understand their potential use in energy storage application. A supercapacitor was fabricated and tested for its electrochemical performance such as cyclic voltammtery (CV), electrochemical impedance spectroscopy (EIS) and galvanostatic charge/discharge (GCD). An enhanced current window was observed in the CV of SA/CNRs compared to pure SA and SA/CNRs/Mg films, which indicated a structural interaction of CNRs with SA. The conductivity of SA/CNRs/Mg was lesser than SA/CNRs in EIS studies due to the presence of Mg ions, while pure SA showed lesser conductivity. The dual ionic interaction of Na and Mg along with enhanced structural stability due to doped CNRs favors its convenient supercapacitor application. The fabricated eco-friendly supercapacitor showed a specific capacitance of 84 F/g. The GCD of the device displayed pseudocapacitance behaviour and was quite stable for 2000 cycles with coulombic efficiency of 96 %. © 2024 The Author(s)