Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Srinikethan, G.Subject: search.filters.subject.bioreactor

Search Results

Now showing 1 - 6 of 6
  • No Thumbnail Available
    Item
    Performance of pulsed plate bioreactor for biodegradation of phenol
    (2007) Shetty K, K.V.; Kalifathulla, I.; Srinikethan, G.
    Biodegradation of phenol was carried out using Nocardia hydrocarbonoxydans immobilised on glass beads, in a pulsed plate bioreactor. The effect of operating parameters like frequency of pulsation and amplitude of pulsation on the performance of pulsed plate bioreactor for biodegradation of phenol in a synthetic wastewater containing 500 ppm phenol was studied. Axial concentration profile measurements revealed that the pulsed plate bioreactor shows continuous stirred tank behaviour. As the amplitude was increased, percentage degradation increased, reaching 100% at amplitude of 4.7 cm and higher. Introduction of pulsation is found to increase the percentage degradation. Percentage degradation has increased with increase in frequency and 100% degradation was achieved at 0.5 s-1 and above. Biofilms developed in a non-pulsed bioreactor were thicker than those in the pulsed plate bioreactor. But biofilm thickness remained almost constant with increasing frequency. Biofilm density was found to be influenced by pulsation. The time required to reach steady state was more for pulsed reactor than the non-pulsed reactor and this start-up time had increased with increase in frequency of pulsation. The performance studies reveal that the pulsed plate bioreactor with immobilized cells has the potential to be an efficient bioreactor for wastewater treatment. © 2006 Elsevier B.V. All rights reserved.
  • No Thumbnail Available
    Item
    Biological phenol removal using immobilized cells in a pulsed plate bioreactor: Effect of dilution rate and influent phenol concentration
    (2007) Shetty K, K.V.; Ramanjaneyulu, R.; Srinikethan, G.
    The continuous aerobic biodegradation of phenol in synthetic wastewater was carried out using Nocardia hydrocarbonoxydans immobilized over glass beads packed between the plates in a pulsed plate bioreactor at a frequency of pulsation of 0.5 s-1 and amplitude of 4.7 cm. The influence of dilution rate and influent phenol concentration on start up and steady state performance of the bioreactor was studied. The time taken to reach steady state has increased with increase in dilution rate and influent phenol concentration. It was found that, as the dilution rate is increased, the percentage degradation has decreased. Steady state percentage degradation was also reduced with increased influent phenol concentration. Almost 100% degradation of 300 and 500 ppm influent phenol could be achieved at a dilution rate of 0.4094 h-1 and more than 99% degradation could be achieved with higher dilution rates. At a higher dilution rate of 1.0235 h-1 and at concentrations of 800 and 900 ppm the percentage degradation has reduced to around 94% and 93%, respectively. The attached biomass dry weight, biofilm thickness and biofilm density at steady state were influenced by influent phenol concentration and dilution rate. © 2007 Elsevier B.V. All rights reserved.
  • No Thumbnail Available
    Item
    Effect of media characteristics on performance of upflow aerobic biofilters
    (2008) Srinikethan, G.; Shrihari, S.; Pradeepan, V.S.
    Laboratory studies were conducted to assess the influence of media related factors such as porosity, pore size, particle size and specific surface area on the performance of upflow aerobic biofilters (ABFs). Three simple models of 8 litre capacity upflow submerged ABFs packed with support media of size 40 mm, 20 mm and 10 mm respectively were installed. The hydraulic retention time (HRT) was maintained as 12 hours. The study was carried out for a period of 90 days. The reactor performance indicated that the aerobic biofilter (ABF-3), associated with media of lowest porosity, pore size, particle size and highest specific surface area, demonstrating the highest BOD and COD removal efficiency of 93.32 % and 85.01 % respectively.
  • No Thumbnail Available
    Item
    Artificial neural networks model for the prediction of steady state phenol biodegradation in a pulsed plate bioreactor
    (2008) Shetty K, K.V.; Nandennavar, S.; Srinikethan, G.
    Background: A recent innovation in fixed film bioreactors is the pulsed plate bioreactor (PPBR) with immobilized cells. The successful development of a theoretical model for this reactor relies on the knowledge of several parameters, which may vary with the process conditions. It may also be a time-consuming and costly task because of their nonlinear nature. Artificial neural networks (ANN) offer the potential of a generic approach to the modeling of nonlinear systems. Results: A feedforward ANN based model for the prediction of steady state percentage degradation of phenol in a PPBR by immobilized cells of Nocardia hydrocarbonoxydans (NCIM 2386) during continuous biodegradation has been developed to correlate the steady state percentage degradation with the flow rate, influent phenol concentration and vibrational velocity (amplitude x frequency). The model used two hidden layers and 53 parameters (weights and biases). The network model was then compared with a Multiple Regression Analysis (MRA) model, derived from the same training data. Further these two models were used to predict the percentage degradation of phenol for blind test data. Conclusions: The performance of the ANN model was superior to that of the MRA model and was found to be an efficient data-driven tool to predict the performance of a PPBR for phenol biodegradation. © 2008 Society of Chemical Industry.
  • No Thumbnail Available
    Item
    Combined effect of plate pulsation parameters and phenol concentrations on the phenol removal efficiency of a pulsed plate bioreactor with immobilized cells
    (2008) Shetty K, K.V.; Kedargol, M.R.; Srinikethan, G.
    Continuous aerobic biodegradation of phenol in synthetic wastewater with phenol at different concentrations (200, 300, 500, 800 and 900 ppm) was carried out in a pulsed plate column, which is used as a bioreactor with immobilised cells of Nocardia hydrocarbonoxydans (NCIM 2386) at a dilution rate of 0.4094 h-1 and amplitude of 4.7 cm at various frequencies of pulsation (0, 0.25, 0.5, 0.75 and 1 s-1). The effect of frequency of pulsation on the steady state performance of the bioreactor for phenol biodegradation at different influent concentrations was studied. Percentage degradations were observed to be a combined effect of volumetric phenol loading, reactor residence time, mass transfer limitations and phenol inhibition effect. At 500 ppm influent phenol concentration the effect of frequencies of pulsation on the steady state percentage degradation at different amplitudes was studied. The percentage degradation increased with increase in frequency and almost 100% degradation was achieved at 0.75s-1, 0.5s-1 or 0.25s -1, with 3.3, 4.7 or 6.0 cm amplitudes respectively and hence the vibrational velocity (amplitude * frequency) was found to influence the steady state performance of the reactor. It was found that optimum vibrational velocities need to be fixed for maximum removal efficiency of the bioreactor depending on the influent phenol concentration. © IWA publishing 2008.
  • No Thumbnail Available
    Item
    Mixing and solid-liquid mass transfer characteristics in a three phase pulsed plate column with packed bed of solids in interplate spaces-a novel aerobic immobilized cell bioreactor
    (2011) Shetty K, V.S.; Srinikethan, G.
    Background: The pulsed plate column (PPC) with packed bed of solids in the interplate spaces finds use as a three phase aerobic bioreactor and is a potential heterogeneous catalytic reactor. Good knowledge of the extent of mixing in the liquid phase and solid-liquid mass transfer coefficient are essential for modeling, design and optimization of these columns. The present work aims at the study of liquid phase mixing and solid-liquid mass transfer characteristics in a three phase PPC. Results: Residence time distribution studies were performed. Dispersion number was found to increase with increase in liquid superficial velocities, frequency of pulsation, amplitude of pulsation and the vibrational velocities. Increase in frequency and amplitude of pulsation, and hence increase in vibrational velocity, resulted in increase of the solid-liquid mass transfer coefficient. Conclusions: The mixing behaviour in this contactor approximated a mixed flow behaviour. The three phase PPC was found to outperform many other kinds of three phase contactors in terms of solid liquid mass transfer characteristics. Empirical correlations developed can be used for the determination of solid-liquid mass transfer coefficients for three phase PPC and hence can facilitate the design, scale-up and modeling of these columns, when used as chemical or biochemical reactors. © 2011 Society of Chemical Industry.