Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Performance of pulsed plate bioreactor for biodegradation of phenol(2007) Shetty K, K.V.; Kalifathulla, I.; Srinikethan, G.Biodegradation of phenol was carried out using Nocardia hydrocarbonoxydans immobilised on glass beads, in a pulsed plate bioreactor. The effect of operating parameters like frequency of pulsation and amplitude of pulsation on the performance of pulsed plate bioreactor for biodegradation of phenol in a synthetic wastewater containing 500 ppm phenol was studied. Axial concentration profile measurements revealed that the pulsed plate bioreactor shows continuous stirred tank behaviour. As the amplitude was increased, percentage degradation increased, reaching 100% at amplitude of 4.7 cm and higher. Introduction of pulsation is found to increase the percentage degradation. Percentage degradation has increased with increase in frequency and 100% degradation was achieved at 0.5 s-1 and above. Biofilms developed in a non-pulsed bioreactor were thicker than those in the pulsed plate bioreactor. But biofilm thickness remained almost constant with increasing frequency. Biofilm density was found to be influenced by pulsation. The time required to reach steady state was more for pulsed reactor than the non-pulsed reactor and this start-up time had increased with increase in frequency of pulsation. The performance studies reveal that the pulsed plate bioreactor with immobilized cells has the potential to be an efficient bioreactor for wastewater treatment. © 2006 Elsevier B.V. All rights reserved.Item Biological phenol removal using immobilized cells in a pulsed plate bioreactor: Effect of dilution rate and influent phenol concentration(2007) Shetty K, K.V.; Ramanjaneyulu, R.; Srinikethan, G.The continuous aerobic biodegradation of phenol in synthetic wastewater was carried out using Nocardia hydrocarbonoxydans immobilized over glass beads packed between the plates in a pulsed plate bioreactor at a frequency of pulsation of 0.5 s-1 and amplitude of 4.7 cm. The influence of dilution rate and influent phenol concentration on start up and steady state performance of the bioreactor was studied. The time taken to reach steady state has increased with increase in dilution rate and influent phenol concentration. It was found that, as the dilution rate is increased, the percentage degradation has decreased. Steady state percentage degradation was also reduced with increased influent phenol concentration. Almost 100% degradation of 300 and 500 ppm influent phenol could be achieved at a dilution rate of 0.4094 h-1 and more than 99% degradation could be achieved with higher dilution rates. At a higher dilution rate of 1.0235 h-1 and at concentrations of 800 and 900 ppm the percentage degradation has reduced to around 94% and 93%, respectively. The attached biomass dry weight, biofilm thickness and biofilm density at steady state were influenced by influent phenol concentration and dilution rate. © 2007 Elsevier B.V. All rights reserved.Item Modelling and simulation of steady-state phenol degradation in a pulsed plate bioreactor with immobilised cells of Nocardia hydrocarbonoxydans(2011) Shetty K, V.S.; Verma, D.K.; Srinikethan, G.A novel bioreactor called pulsed plate bioreactor (PPBR) with cell immobilised glass particles in the interplate spaces was used for continuous aerobic biodegradation of phenol present in wastewater. A mathematical model consisting of mass balance equations and accounting for simultaneous external film mass transfer, internal diffusion and reaction is presented to describe the steady-state degradation of phenol by Nocardia hydrocarbonoxydans (Nch.) in this bioreactor. The growth of Nch. on phenol was found to follow Haldane substrate inhibition model. The biokinetic parameters at a temperature of 30 ± 1 °C and pH at 7.0 ± 0.1 are ? m = 0.5397 h -1, K S = 6.445 mg/L and K I = 855.7 mg/L. The mathematical model was able to predict the reactor performance, with a maximum error of 2% between the predicted and experimental percentage degradations of phenol. The biofilm internal diffusion rate was found to be the slowest step in biodegradation of phenol in a PPBR. © 2010 Springer-Verlag.