Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Constrained radar waveform optimization for a cooperative radar-communication system(Elsevier B.V., 2023) Mahipathi, A.C.; Gunnery, S.; Srihari, P.; D'Souza, J.; Jena, P.The coexistence of radar-sensing and communication systems research has received a surge of interest in recent times to tackle the issue of spectrum inadequacy. Designing an optimized radar waveform for a coexistence scenario has been a challenging task for accomplishing the convergence of radar-sensing and communication functionalities, without degrading the performance at either end. This paper proposes a novel global optimization-based Spatial Branch and Bound (SBnB) approach to optimize the phase coefficients of a Non-Linear Frequency Modulated (NLFM) waveform in a CRCS framework. In addition, the Modified-Power Ratio Constraint-Cramér–Rao Lower Bound (M-PRC-CRLB), a local optimization-based approach is proposed to optimize the phase coefficients of an NLFM waveform. The spectral energy distribution and auto-correlation characteristics of an NLFM waveform are comprehensively investigated for various values of polynomial order (N) and at different threshold Signal-to-Noise-Ratio (SNR) values. To compare the proposed waveform design approaches (M-PRC-CRLB, SBnB) with the existing waveform design approaches namely, Minimum Estimation Error Variance (MEEV) and PRC- CRLB, a Peak-to-Side-Lobe-Ratio (PSLR), and Integrated-Side-Lobe-Ratio (ISLR) are evaluated at various polynomial orders and threshold SNR values. Furthermore, the performance of a CRCS is assessed using the radar estimation rate and communication data rate. The simulation results reveal that the proposed optimized radar waveform design approaches provide improved performance compared to the existing radar waveform design approaches in terms of radar estimation rate. Further, the proposed global optimization-based SBnB approach achieves a comparable performance of the communication data rate. In addition, the proposed approaches accomplish enhanced spectral utilization, controlled side-lobe energy levels, reduced range-domain ambiguities, and a higher information rate in a CRCS. © 2022 Elsevier B.V.Item Optimum Waveform Selection for Target State Estimation in the Joint Radar-Communication System(Institute of Electrical and Electronics Engineers Inc., 2024) Mahipathi, A.C.; Pardhasaradhi, B.P.; Gunnery, S.; Srihari, P.; D'Souza, J.; Jena, P.The widespread usage of the Radio Frequency (RF) spectrum for wireless and mobile communication systems generated a significant spectrum scarcity. The Joint Radar-Communication System (JRCS) provides a framework to simultaneously utilize the allocated radar spectrum for sensing and communication purposes. Generally, a Successive Interference Cancellation (SIC) based receiver is applied to mitigate mutual interference in the JRCS configuration. However, this SIC receiver model introduces a communication residual component. In response to this issue, the article presents a novel measurement model based on communication residual components for various radar waveforms. The radar system's performance within the JRCS framework is then evaluated using the Fisher Information Matrix (FIM). The radar waveforms considered in this investigation are rectangular pulse, triangular pulse, Gaussian pulse, Linear Frequency Modulated (LFM) pulse, LFM-Gaussian pulse, and Non-Linear Frequency Modulated (NLFM) pulse. After that, the Kalman filter is deployed to estimate the target kinematics (range and range rate) of a single linearly moving target for different waveforms. Additionally, range and range rate estimation errors are quantified using the Root Mean Square Error (RMSE) metric. Furthermore, the Posterior Cramer-Rao Lower Bound (PCRLB) is derived to validate the estimation accuracy of various waveforms. The simulation results show that the range and range rate estimation errors are within the PCRLB limit at all time instants for all the designated waveforms. The results further reveal that the NLFM pulse waveform provides improved range and range rate error performance compared to all other waveforms. © 2020 IEEE.Item A Survey on Waveform Design for Radar-Communication Convergence(Institute of Electrical and Electronics Engineers Inc., 2024) Chakravarthi Mahipathi, A.; Pardhasaradhi, B.; Lingadevaru, P.; Srihari, P.; D'Souza, J.; Cenkarmaddi, L.R.To provide service to an abundant number of communication users and to avoid the spectrum scarcity problem, many researchers are fascinated to work towards the convergence of radar sensing and communication systems. In addition, future intelligent systems like autonomous vehicles, Vehicle-to-everything (V2X), Unmanned Aerial Vehicles (UAV), and all smart systems are going to implement both radar and communication systems on the same platform, which motivates the researchers to focus on the development of Joint Radar-Communication Systems (JRCS). Cooperative Radar-Communication System (CRCS) and Dual Functional Radar Communication (DFRC) systems provide an opportunity for communication users to utilize radar resources without disturbing radar operation. Waveform design is essential in the development of new models and designs related to joint radar-sensing and communication systems. A cooperative radar communication system uses separate waveforms for radar and communication systems. The DFRC system uses the same waveform for radar and communication operations. So to model both joint radar communication systems one should have a clear idea regarding waveform design and its approaches. Therefore, this review paper focused on different waveform design approaches for modeling CRCS and DFRC systems. In addition, the prime objective of this review paper is to give a detailed view of the existing cooperative and dual-function waveform design approaches and provide a kick-start for new learners to work on this area. © 2023 IEEE.
