Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
7 results
Search Results
Item Effect of dry torrefaction pretreatment of the microwave-assisted catalytic pyrolysis of biomass using the machine learning approach(Elsevier Ltd, 2022) Ramesh, R.; Suriapparao, D.V.; Sankar Rao, C.S.; Sridevi, V.; Kumar, A.This study employs the Leave-One-Out cross-validation approach to build a machine-learning model using polynomial regression to predict pyro product yield through microwave-assisted pyrolysis of sawdust over KOH catalyst and graphite powder a susceptor. The determination of coefficient (R2) validates the developed models. All the developed models achieved a high prediction accuracy with R2 > 0.93, which signifies that the experimental values are in good agreement with the predicted one. The dependence of the catalyst loading and pretreatment temperature on dominating process parameters such as heating rate, pyrolysis temperature, susceptor thermal energy, and pyro products, namely bio-oil, biochar, and biogas, are explored. The yield of biochar is reduced; however, bio-oil and biogas are enhanced as the catalyst loading increased. On the other hand, increasing the temperature of pretreated sawdust decreased bio-oil and biogas yields while increasing biochar yields. Further, microwave conversion efficiency, and susceptor thermal energy increased with increased catalyst quantity and pretreatment temperatures of sawdust. It was observed that the average heating rate was increased by increasing the catalyst quantity while maintaining the same pyrolysis time until pretreatment temperatures of 150 °C were reached, after which the heating rate dropped due to the continuous microwave energy input to the system. © 2022 Elsevier LtdItem The role of solvent soaking and pretreatment temperature in microwave-assisted pyrolysis of waste tea powder: Analysis of products, synergy, pyrolysis index, and reaction mechanism(Elsevier Ltd, 2022) Talib Hamzah, H.; Sridevi, V.; Seereddi, M.; Suriapparao, D.V.; Ramesh, R.; Sankar Rao, C.S.; Gautam, R.; Kaka, F.; Pritam, K.This study focuses on microwave-assisted pyrolysis (MAP) of fresh waste tea powder and torrefied waste tea powder as feedstocks. Solvents including benzene, acetone, and ethanol were used for soaking feedstocks. The feedstock torrefaction temperature (at 150 °C) and solvents soaking enhanced the yields of char (44.2–59.8 wt%) and the oil (39.8–45.3 wt%) in MAP. Co-pyrolysis synergy induced an increase in the yield of gaseous products (4.7–20.1 wt%). The average heating rate varied in the range of 5–25 °C/min. The energy consumption in MAP of torrefied feedstock (1386 KJ) significantly decreased compared to fresh (3114 KJ). The pyrolysis index dramatically varied with the solvent soaking in the following order: ethanol (26.7) > benzene (25.6) > no solvent (10) > acetone (6). It shows that solvent soaking plays an important role in the pyrolysis process. The obtained bio-oil was composed of mono-aromatics, poly-aromatics, and oxygenated compounds. © 2022 Elsevier LtdItem The effect of torrefaction temperature and catalyst loading in Microwave-Assisted in-situ catalytic Co-Pyrolysis of torrefied biomass and plastic wastes(Elsevier Ltd, 2022) Ramesh, R.; Suriapparao, D.V.; Sankar Rao, C.S.; Sridevi, V.; Kumar, A.; Shah, M.In the current study, the effect of torrefaction temperatures (125–175 °C) and catalyst quantity (5–15 g) on co-pyrolysis of torrefied sawdust (TSD) and polystyrene (PS) are investigated to obtain value-added products. The role of torrefaction in co-pyrolysis of TSD: PS was analyzed to understand the product yields, synergy, and energy consumption. As the torrefaction temperature increases, oil yield (48.3–59.6 wt%) and char yield (24.3–29 wt%) increase while gas yield (27.4–11.4 wt%) decreases. Catalytic co-pyrolysis showed a significant level of synergy when compared to non-catalytic co-pyrolysis. For the conversion (%), a positive synergy maximum (-2.6) exists at a torrefaction temperature of 175 °C and 15 g of KOH catalyst. To develop the model, polynomial regression-based machine learning was used to predict pyrolysis product yields and energy usage variables. The developed models showed significant prediction accuracy (R2 > 0.98), suggesting the experimental values and the predicted values matched well. © 2022 Elsevier LtdItem A review on analysis of biochar produced from microwave-assisted pyrolysis of agricultural waste biomass(Elsevier B.V., 2023) Ramesh, R.; Surya, D.V.; Sankar Rao, C.S.; Yadav, A.; Sridevi, V.; Remya, N.Every year the agricultural product processing industries produce large quantities of agricultural waste biomass (AWB). Whose disposal has become a serious issue concerning solid waste management due to environmental and health issues. Microwave-assisted pyrolysis (MAP) is an intriguing technology for producing valuable products from waste feedstocks. AWB is converted into a valuable product like biochar by using MAP. The conversion of AWB into biochar by MAP is influenced by several factors such as type of feedstock, pyrolysis temperature, residence time, pressure, heating rate, susceptor, particle size, and microwave power. However, no review article is available to understand the role of MAP on biochar production from AWB. The current review focused on understanding the fundamentals of biochar production. It also reviews the challenges in producing biochar process by compatible, acceptable, and sustainable and its future directions to gain economic benefits even at small-scale applications. The generation of biochar from MAP and its uses in agriculture are discussed. The current review would address the knowledge gap and highlight the critical implications in biochar production and applications. © 2023 Elsevier B.V.Item Two-step synthesis of biochar using torrefaction and microwave-assisted pyrolysis: Understanding the effects of torrefaction temperature and catalyst loading(Elsevier B.V., 2023) Ramesh, P.; Sankar Rao, C.S.; Surya, D.V.; Sridevi, V.; Kulkarni, A.The study focused on synthesizing the biochar from sawdust using torrefaction followed by pyrolysis. Sawdust was torrefied at different temperatures (125 °C, 150 °C, and 175 °C) using a conventional hot air oven. The obtained torrefied biochar was subjected to Microwave-assisted pyrolysis at a power of 300 W for 10 min. Graphite was used as a susceptor, and KOH was used as a catalyst. The maximum biochar product yield varied from 24 to 48 wt% and increased with torrefaction temperature. The average heating rates ranged from 54.5 to 74.6 °C/min. At 10 g of KOH, higher heating rates were obtained. The pyrolysis index analyzed varied between 97.5 and 111.5 and decreased with the increase in torrefaction temperature. The obtained biochar was analyzed using SEM, BET, XRD, FTIR, ICP-OES, and Raman spectroscopy. Porous structure formation enhanced, and the concentrations of Ca, Al, and Fe decreased with the increase in torrefaction temperature. © 2023 Elsevier B.V.Item Synergistic effects and product yields in microwave-assisted in-situ co-pyrolysis of rice straw and paraffin wax(Institution of Chemical Engineers, 2024) Hamzah, H.T.; Sridevi, V.; Surya, D.V.; Ramesh, P.; Sankar Rao, C.; Palla, S.; Abdullah, T.A.Microwave-assisted pyrolysis is one of the most efficient methods for solid waste management. This study employed microwave-assisted catalytic co-pyrolysis to convert Paraffin wax (PW) and rice straw (RS) into valuable char, gas, and oil products. KOH and graphite were used as the catalyst and susceptor, respectively. The RS and PW blend served as the feedstock (with a blend ratio of 0–10 g). The yields of co-pyrolysis at different blending ratios of RS: PW exhibited variations in char content (ranging from 9.8% to 22.6% by wt.), oil production (ranging from 34.1% to 76.9% by wt.), and gas formation (ranging from 13.2% to 47.5% by wt.). The effects of the RS: PW ratio on the average heating rate, feedstock conversion, and product yields were also investigated. Analyses were performed to assess the synergistic impacts on product yields, average heating rates, and conversion factors. Notably, co-pyrolysis synergy led to increased oil and char production. Furthermore, we conducted FTIR analysis on the oil and char produced through the catalytic co-pyrolysis of RS: PW. In conjunction with co-pyrolysis synergy, the catalyst facilitated the formation of amides, alkenes, aliphatic compounds, and aromatic compounds. © 2023 The Institution of Chemical EngineersItem Effect of solvent pre-treatment on microwave assisted pyrolysis of Spirulina (Algal Biomass) and Ficus benghalensis (Lignocellulosic Biomass) for production of biofuels: comparative experimental studies(Springer Science and Business Media Deutschland GmbH, 2025) Varma, J.V.; Sridevi, V.; Musalaiah, M.; King, P.; Hamzah, H.T.; Tanneru, H.K.; Ramesh, R.; Malleswari, G.B.The study focuses on the comparison of microwave-assisted pyrolysis (MAP) of Spirulina, (algal biomass), and aerial roots of Ficus benghalensis (lignocellulosic biomass) as feedstocks for biofuel production. Solvent ethanol was used to pretreat feedstocks. The experiments were carried out using a microwave power of 450 W, considering both fresh and solvent-pretreated feedstocks. Solvent-pretreated Spirulina demonstrated a high bio-oil yield of 56.1 wt. % and a biochar yield of 13.5 wt. %, whereas for solvent-pretreated Ficus benghalensis, the corresponding yields were 35.4 wt. % and 12.3 wt.%. Both solvent-treated and fresh algal biomass feedstocks showed higher yields than lignocellulose biomass. Pre-treatment of feedstocks showed positive results on microwave energy consumption and pyrolysis index. The average heating values were 27.3 0C/min for pretreated Spirulina and 46.2 0C/min for pretreated Ficus benghalensis. Fourier Transform Infrared (FTIR) characterized the obtained bio-oils and biochar. The FTIR results indicated the presence of distinctive functional groups such as N=C=O, O=C=O, N-O, and S=O in MAP of Spirulina bio-oil, and C=C and C-I stretching in MAP of Ficus benghalensis bio-oil. The FTIR results for biochar were consistent across both feedstocks, showing common functional groups such as C-Cl, C=C, C-H, O-H, C-F, and S=O. However, in the case of Spirulina, an extra functional group, C=N, was also detected. Pre-treatment of microalgal biomass is essential for the maximal recovery of biofuel precursors packed inside the complex microalgal cell wall. It was concluded that pre-treatment is an efficient way to improve the yield and composition of bio-oil with low microwave power and short microwave irradiation time. Efforts are still required to develop an economical and environmentally benign pre-treatment approach to facilitate 100% biomass conversion to added-value products. © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2024.