Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
Search Results
Item Study of CO oxidation activity of NiO-PDC and NiO-YSZ catalysts coated on alumina wash-coated honeycomb cordierite monolith(Springer Science and Business Media Deutschland GmbH, 2025) Wagay, A.A.; Shourya, A.; Patil, S.S.; Shirasangi, R.; Prasad Dasari, H.P.In this study, the EDTA-Citrate method was employed to synthesize NiO-PDC (NPC) and NiO-YSZ (NYZ) powder catalysts in nanostructured form. Subsequently, the catalysts were slurry dip-coated onto monolith cordierite substrates with alumina, using a one-step coating approach, and their CO oxidation activity was tested. The coating was achieved by first mixing the catalyst with the alumina suspension to prepare a homogeneous slurry, which was then used for dip coating onto the monolith. The adherence test was performed on the coated monolith to evaluate the mechanical stability of the catalyst-alumina composite layer. The coating was visually confirmed through optical imaging. The remaining powders (after coating) were then subjected to BET surface area, XRD, Raman spectroscopy, H2 TPR and O2 TPD analysis for characterization. Raman spectra showed that NPC exhibited higher oxygen vacancies than NYZ. H2 TPR and O2 TPD provided better evidence of the reduction potential and O2 desorption of NPC respectively. NPC/cord demonstrated the highest catalytic activity (T50 = 165 °C) compared to NYZ/cord (T50 = 215 °C) and bare cordierite (T50 = 777 °C), which is attributed to its better redox properties and higher oxygen vacancies. The effect of flow rate and heating rate on CO oxidation was studied on NPC/cord and NYZ/cord. The long-term stability of the NPC/cord and NYZ/cord were tested through 5-h and 50-h isothermal studies. © The Author(s) under exclusive licence to Associação Brasileira de Engenharia Química 2025.Item Diesel soot oxidation over Mn–Pr–Ce oxide catalysts: structural changes and the impact of Mn doping(Royal Society of Chemistry, 2025) Patil, S.S.; Prasad Dasari, H.P.; Shirasangi, R.; Harshini, H.The soot oxidation activity of manganese-doped ceria-praseodymium catalysts, synthesized via solution combustion synthesis, was evaluated. The analyses performed with XRD and Raman spectroscopy indicated that the Mn-doped CP catalysts displayed the typical fluorite structure of CeO2. The addition of Mn to CP led to a reduction in crystallite size from 14 nm to below 10 nm. The F2g Raman active mode of fluorite-structured Ce and the oxygen vacancies resulting from the addition of Mn and Pr (bands B 560 cm–1 to 580 cm–1) were consistently observed across all Mn-doped CP catalysts. 15 and 20 Mn-CP exhibited an additional secondary phase identified as Mn2O3. The analysis of BET surface area and BJH pore size revealed that the Mn-doped CP catalysts exhibited both micro and mesoporous characteristics. The H2-TPR and O2-TPD profiles indicated enhanced reducibility resulting from the incorporation of Mn and Pr into CeO2-doped catalysts. The improved T50 (365 ± 1 1C) for the 5 Mn-CP catalytic system is primarily due to its increased specific surface area of 45 m2 g–1 and the presence of active surface adsorbed oxygen species identified in the XPS and O2-TPD studies. 5 Mn-CP exhibited the lowest activation energy value compared to all other Mn-doped catalysts. © 2025 The Author(s)