Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
4 results
Search Results
Item Performance of pulsed plate bioreactor for biodegradation of phenol(2007) Shetty K, K.V.; Kalifathulla, I.; Srinikethan, G.Biodegradation of phenol was carried out using Nocardia hydrocarbonoxydans immobilised on glass beads, in a pulsed plate bioreactor. The effect of operating parameters like frequency of pulsation and amplitude of pulsation on the performance of pulsed plate bioreactor for biodegradation of phenol in a synthetic wastewater containing 500 ppm phenol was studied. Axial concentration profile measurements revealed that the pulsed plate bioreactor shows continuous stirred tank behaviour. As the amplitude was increased, percentage degradation increased, reaching 100% at amplitude of 4.7 cm and higher. Introduction of pulsation is found to increase the percentage degradation. Percentage degradation has increased with increase in frequency and 100% degradation was achieved at 0.5 s-1 and above. Biofilms developed in a non-pulsed bioreactor were thicker than those in the pulsed plate bioreactor. But biofilm thickness remained almost constant with increasing frequency. Biofilm density was found to be influenced by pulsation. The time required to reach steady state was more for pulsed reactor than the non-pulsed reactor and this start-up time had increased with increase in frequency of pulsation. The performance studies reveal that the pulsed plate bioreactor with immobilized cells has the potential to be an efficient bioreactor for wastewater treatment. © 2006 Elsevier B.V. All rights reserved.Item Biological phenol removal using immobilized cells in a pulsed plate bioreactor: Effect of dilution rate and influent phenol concentration(2007) Shetty K, K.V.; Ramanjaneyulu, R.; Srinikethan, G.The continuous aerobic biodegradation of phenol in synthetic wastewater was carried out using Nocardia hydrocarbonoxydans immobilized over glass beads packed between the plates in a pulsed plate bioreactor at a frequency of pulsation of 0.5 s-1 and amplitude of 4.7 cm. The influence of dilution rate and influent phenol concentration on start up and steady state performance of the bioreactor was studied. The time taken to reach steady state has increased with increase in dilution rate and influent phenol concentration. It was found that, as the dilution rate is increased, the percentage degradation has decreased. Steady state percentage degradation was also reduced with increased influent phenol concentration. Almost 100% degradation of 300 and 500 ppm influent phenol could be achieved at a dilution rate of 0.4094 h-1 and more than 99% degradation could be achieved with higher dilution rates. At a higher dilution rate of 1.0235 h-1 and at concentrations of 800 and 900 ppm the percentage degradation has reduced to around 94% and 93%, respectively. The attached biomass dry weight, biofilm thickness and biofilm density at steady state were influenced by influent phenol concentration and dilution rate. © 2007 Elsevier B.V. All rights reserved.Item Shear stress effects on production of exopolymeric substances and biofilm characteristics during phenol biodegradation by immobilized Pseudomonas desmolyticum (NCIM2112) cells in a pulsed plate bioreactor(Taylor and Francis Inc. 325 Chestnut St, Suite 800 Philadelphia PA 19106, 2016) Veena, B.R.; Shetty K, K.V.; Saidutta, M.B.This article reports studies on a continuous pulsed plate bioreactor (PPBR) with the cells of Pseudomonas desmolyticum (NCIM2112) immobilized on granular activated carbon (GAC) used as a biofilm reactor for biodegradation of phenol. Almost complete removal of 200 ppm phenol could be achieved in this bioreactor. Biofilm structure and characteristics are influenced by hydrodynamic and shear conditions in bioreactors. In this article, the effect of shear stress induced by frequency of pulsation on biofilm characteristics during the startup period in the PPBR is reported. The startup time decreased with the increase in frequency of pulsation. The formation of biofilm in PPBR was found to have three phases: accumulation, compaction, and plateau. The effect of frequency on production of exoploymeric substances (EPS) such as, protein, carbohydrate, and humic substance is reported. An increase in shear stress induced by the frequency of pulsation increased the production of exopolymeric substances in the biofilm during startup of the bioreactor. Increase in shear stress caused a decrease in biofilm thickness and an increase in dry density of the biofilm. Increase in shear stress resulted in a smoother and thinner biofilm surface with more compact and dense structure. © 2016, Copyright © Taylor & Francis Group, LLC.Item Microbial disinfection of water with endotoxin degradation by photocatalysis using Ag@TiO2 core shell nanoparticles(Springer Verlag service@springer.de, 2016) Sreeja, S.; Shetty K, K.V.The studies on photocatalytic disinfection of water contaminated with Escherichia coli using Ag core and TiO2 shell (Ag@TiO2) nanoparticles under UV irradiation showed that these nanoparticles are very efficient in water disinfection both in their free and immobilised form. Complete disinfection of 40 × 108 CFU/mL could be achieved in 60 min with 0.4 g/L catalyst loading and in 35 min with 1 g/L catalyst loading. Ag@TiO2 nanoparticles were found to be superior to TiO2 nanoparticles in photocatalytic disinfection of water. Kinetics of disinfection followed Chick’s law, and the pseudo-first-order rate constant was 0.0168 min?1 for a catalyst loading of 0.1 g/L. Disinfection of water and degradation of endotoxins (harmful disinfection residual) occurred simultaneously during photocatalysis thereby making the treated water safe for use. Endotoxin degradation showed a shifting order of kinetics. The rate of photocatalysis with nanoparticles immobilised in cellulose acetate film was marginally lower as compared to that of free nanoparticles. Negligible Ag ion leakage and re-growth of cells post-photo-catalytic treatment of water confirmed that complete disintegration of E. coli occurred during photocatalysis making the treated water safe for use. Therefore, Ag@TiO2 nanoparticles have a potential for large-scale application in drinking water treatment plants and household purification units. © 2016, Springer-Verlag Berlin Heidelberg.