Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Novel RGO-ZnWO4-Fe3O4 nanocomposite as high performance visible light photocatalyst(Royal Society of Chemistry, 2016) Mohamed, M.M.J.; Shenoy, U.S.; Bhat, D.K.A novel RGO-ZnWO4-Fe3O4 nanocomposite is synthesized by a microwave irradiation method and its catalytic activity for the photo degradation of Methylene Blue (MB) is investigated. The prepared nanocomposites are characterized by powder X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), high resolution transmission electron microscopy (HRTEM), transmission electron microscopy (TEM), field emission scanning electron microscopy (FESEM), Raman spectroscopy, photoluminescence spectroscopy (PL) and UV-visible spectroscopy. The visible light photocatalytic activities of the prepared nanocomposites are investigated using a MB dye solution. It is noteworthy that RGO-ZnWO4-Fe3O4 nanocomposites exhibited relatively high photocatalytic activity compared to ZnWO4-RGO and pure ZnWO4 on MB in aqueous solution. This enhanced rate is due to the ability of the graphene in the RGO-ZnWO4-Fe3O4 composite to support carrier exploitation efficiently by tolerating the photo excited electron-hole pairs and thus encouraging oxidative degradation of the pollutants. This work could be extended to other organic pollutants as well and could provide new insights into ternary nanocomposites as high performance photocatalysts and their application in waste water treatment. © 2016 The Royal Society of Chemistry.Item Enhanced photocatalytic performance of N-doped RGO-FeWO4/Fe3O4 ternary nanocomposite in environmental applications(Elsevier Ltd, 2017) Mohamed, M.; Shenoy, U.S.; Bhat, D.K.Nitrogen doped RGO- FeWO4/Fe3O4 (NRGO-FeWO4/Fe3O4) ternary nanocomposite was synthesized by rapid single step microwave irradiation approach using iron acetate, ammonium tungstate and graphene oxide as precursors. The synthesized materials were thoroughly characterized by diffraction, microscopic and spectroscopic techniques. The materials were tested for their catalytic efficiency in photo degradation of Methylene Blue (MB) dye and in reduction of 4-nitrophenol (4-NP) to 4-aminophenol (4-AP). MB was mineralized within 100 minutes of visible light irradiation time in the presence of the ternary composite, apart from excellent stability and efficiency even after 10 consecutive cycles. The composite also had the capacity to convert 4-NP into 4-AP within 45 seconds and showed very good catalytic activity even after 20 cycles. The results revealed that ternary composite has way more efficiency than the component materials and can act as a promising catalyst for various environmental and engineering applications. © 2017 Elsevier LtdItem NiWO4-ZnO-NRGO ternary nanocomposite as an efficient photocatalyst for degradation of methylene blue and reduction of 4-nitro phenol(Elsevier Ltd, 2017) Mohamed, M.; Shenoy, U.S.; Bhat, D.K.A novel NiWO4-ZnO-NRGO ternary nanocomposite has been efficiently synthesized by decorating nitrogen doped reduced graphene oxide (NRGO) with zinc oxide and nickel tungstate nanoparticles via a facile microwave irradiation technique and its capability to catalyze photodegradation of methylene blue (MB) dye in aqueous solution and reduction of 4-nitro phenol (4-NP) to 4-amino phenol (4-AP) using sodium borohydride was explored. The as-synthesized nanocomposite was characterized by X-ray diffraction (XRD), Raman spectroscopy, Brunauer-Emmett-Teller (BET) analysis, energy dispersive X-ray (EDX) analysis, field emission scanning electron microscopy (FESEM), transmission electron microscopy (TEM), high-resolution transmission electron microscopy (HRTEM), X-ray photoelectron spectroscopy (XPS), photoluminescence (PL) spectroscopy and diffuse reflectance spectroscopy (DRS) techniques. The photocatalytic activity of the as-synthesized nanocomposite estimated through the photodegradation of MB under visible light irradiation showed 9 times improvement over pure NiWO4. It also showed excellent catalytic activity in reduction of 4-NP to 4-AP. The material also showed excellent stability and reusability. The entire study revealed that the novel NiWO4-ZnO-NRGO ternary nanocomposite can act as a promising bifunctional photocatalyst for environmental remediation and industrial application. © 2017 Elsevier LtdItem Tuning the Photocatalytic Activity of SrTiO3 by Varying the Sr/Ti Ratio: Unusual Effect of Viscosity of the Synthesis Medium(American Chemical Society service@acs.org, 2018) Bantawal, H.; Shenoy, U.S.; Bhat, D.K.SrTiO3 nanostructures were successfully synthesized in various alcohols as cosolvent as well as surfactant by a facile solvothermal method. The as-synthesized catalysts were characterized by X-ray diffraction technique, scanning electron microscopy, energy-dispersive X-ray analysis, Brunauer-Emmett-Teller analysis, diffuse reflectance spectroscopy, and photoluminescence spectroscopy. The possible formation mechanism of SrTiO3 in the presence of these alcohols is discussed, and the effect of these alcohols on the structure, Sr/Ti atomic ratio, and optical properties is related to the photocatalytic activity. First principles calculations were made use of to determine the effect of defects on the electronic structure and the band gap. The photocatalytic activity of these catalysts was evaluated by taking methylene blue as a model pollutant under visible light irradiation. It was found that the photocatalytic activity of ethanol-mediated SrTiO3 was found to be higher than the other samples because of the synergistic effect of high surface area and lesser defects. © 2018 American Chemical Society.Item Copper doping induced band structure and morphology transformation in CaTiO3 for textile dye photodegradation applications(Elsevier Ltd, 2024) Shenoy, U.S.; Uma, P.I.; Bhat, D.K.Semiconductor metal oxides with a wide bandgap like CaTiO3 can be exploited into an efficient visible light photocatalyst via cation doping. The type of dopant and the site of doping is known to greatly influence the photocatalytic activity of a material. Based on the intricacies of the density functional theory electronic structure study, we delve into the optimization of one-pot solvothermal synthesis to obtain Cu doped CaTiO3 nanocuboids. Doping of copper not only resulted in change in the electronic structure of the material but also led to change in the morphology. The uneven nanostep architecture resulted in increase in the surface area of the catalyst, which led to more active sites for the adsorption of the dyes and subsequent degradation. The reduced band gap and decreased recombination of charge carriers made the copper doped calcium titanate an efficient photocatalyst for degradation of both cationic (99.7% degradation of MV dye in 120 minutes) and anionic (99.8% degradation of RB in 45 minutes) dyes. © 2024 Elsevier B.V.