Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
8 results
Search Results
Item Activated carbon- supported Vanado-nickelate (IV) based hybrid materials for energy application(Elsevier Ltd, 2021) Maity, S.; BM, N.; Kella, T.; Shee, D.; Das, P.P.; Mal, S.S.The rapid development of supercapacitor (SC) technology leads to increased demand for nanofabrication of novel and effective electroactive hybrid materials for next-generation energy storage devices. Herein, nickel tetradecavanadate, K2H5[NiV14O40](NiV14), is doped into porous activated carbon (AC), for the first time, in different wt.% in order to investigate the homogeneous loading of the inorganic metal-oxide component on the AC matrix. The resulting complex, AC-NiV14, is found to have possessed an enhanced electrochemical characteristic (for both symmetric and asymmetric SC cell), which operates at a significantly higher potential of 1.2 V. The combination of the double-layer capacitance (EDLC) and the redox-active polyoxometalate cluster leads to an intrinsic increase in specific capacitance (capacity) (from 45.3 Fg?1 (54.4 Cg?1) for AC to 316 Fg?1 (379.2 Cg?1) for 15 wt.% AC-NiV14 at a current density of 1 Ag?1). It was also observed that there is an increase of 20% in the operating voltage compared to conventional AC supercapacitors with acidic aqueous electrolytes. Firstly, symmetric supercapacitor's electrochemical performances of various wt.% of NiV14 composition were studied in acidic aqueous electrolyte (0.5 M H2SO4) solution. We observed that the 15 wt.% of AC-NiV14 hybrid electrode showed remarkable specific energy value (~63.2 Wh kg?1) compared with pristine AC and NiV14 electrodes, separately. Besides, the asymmetric layout (AC//AC-NiV14) increased the potential window up to 1.5 V and enhanced the specific energy and power values (90.1 Whkg?1 and 2400 Wkg?1, respectively), with 98% coulombic efficiency. Meanwhile, the AC-NiV14//NiV14 asymmetric cell possesses a specific capacitance (capacity) of 375 Fg?1 (450 Cg?1) with a maximum power of 3140 Wkg?1 at the high current density of 2 Ag?1. © 2021 Elsevier LtdItem Electrochemical performance of activated carbon-supported vanadomolybdates electrodes for energy conversion(Elsevier Ltd, 2021) Maity, S.; Anandan Vannathan, A.; Kella, T.; Shee, D.; Das, P.P.; Mal, S.Reinforcing polyoxomolybdates (POMs) into the activated carbon (AC) template engenders a nanohybrid electrode material for high-performance supercapacitor applications. Herein, a first-time novel integration of two polyoxometalates ([PVMo11O40]4-, [PV2Mo10O40]5-) with AC has been demonstrated, and their structural and electrochemical performances were analyzed. AC-VMo11 composite displayed an enhanced capacitance of 450 Fg-1 with an improved energy density of 59.7 Whkg-1. Furthermore, the symmetric supercapacitor cell for AC-VMo11 and AC-V2Mo10 showed high cell capacitances of 38.8 and 20.01 mF, respectively, alongside 99.99% capacitance retention of over 5000 cycles. In addition, the influence of ionic liquid as an electrolyte on AC-V2Mo10 based supercapacitor cell was investigated in tetrabutylammonium bromide (TBAB) electrolyte solution. © 2021 Elsevier Ltd and Techna Group S.r.l.Item Vanadomanganate as a synergistic component in high-performance symmetric supercapacitor(Elsevier Ltd, 2022) Maity, S.; Anandan Vannathan, A.A.; Chandewar, P.R.; Shee, D.; Das, P.P.; Mal, S.S.Supercapacitor devices fabricated from capacitive and battery-type hybrid electrodes have been projected as a promising energy storage system because of their ability to produce high specific power and energy simultaneously. In this work, we have demonstrated a facile method of impregnation of faradaic type manganese (III) polyoxovanadate, [MnV14O40]−6 on the high surface area substrate of activated carbon (AC) as well as graphene oxide (GO). Materials and electrochemical characterizations data confirm the successful incorporation of capacitive and faradaic type manganese (III) polyoxovanadate into the nanohybrid electrode material. Furthermore, the synergic effect between the carbonaceous nanostructures (AC/GO) and redox-active oxometalate (MnV14) provides a better pathway for ion transport to the interface resulting in enhancement of the conductivity, diffusion ability of the nanohybrid. Moreover, the battery-type MnV14 clusters disperse in the micro/mesopores of AC, whereas the oxygen-containing functional groups in GO act as active sites for anchoring of MnV14 clusters. Thus, the surface modification with MnV14 clusters enhances the specific capacitance of nanohybrid with remarkable electrical and mechanical stability. The AC/MnV14 nanohybrid exhibits an enhanced specific capacitance of 547 F g−1 with specific energy and power of 76 Wh kg−1 and 1600 W kg−1, respectively, at 0.8 A g−1 current density. Additionally, GO/MnV14 shows a specific capacitance of 330 F g−1 with improved specific energy and power of 30 Wh kg−1 and 1276 W kg−1, respectively, at the same current density. Moreover, both the nanohybrids possess excellent cycle stability by retaining 92% (AC/MnV14) and 90.6% (GO/MnV14) of initial capacitance even after 5000 sweeping cycles. © 2021 Elsevier B.V.Item Polyoxovanadate-Activated Carbon-Based Hybrid Materials for High-Performance Electrochemical Capacitors(Institute of Physics, 2022) Anandan Vannathan, A.; Chandewar, P.R.; Shee, D.; Mal, S.S.Two different polyoxovanadates derivatives, K5MnIVV11O32.10 H2O (MnV11) and K7MnIVV13O38.18 H2O (MnV13), have been studied to evaluate their electrochemical performance. These polyoxovanadates were deposited on activated carbon (AC) to prepare AC-MnV11 and AC-MnV13 composites. The electrochemical performance of the AC-MnV11 electrode exhibits the remarkable specific capacitance of 479.73 F g-1 at a current density of 0.6 A g-1, along with incredible specific power and energy of 960 W kg-1. Likewise, the AC-MnV13 exhibits a specific capacitance of 357.33 F g-1 at the current density of 0.6 A g-1 with a specific energy of 71.46 Wh kg-1. Interestingly, the AC-MnV11 could light up the red and yellow color LED bulbs for a duration of 80 and 60 s, respectively, indicating a considerable specific power of the material. The AC-MnV13 electrode shows significantly less lighting up during the 65 and 30 s period with red and yellow LED bulbs. © 2022 The Electrochemical Society ("ECS"). Published on behalf of ECS by IOP Publishing Limited.Item Phosphomolybdic acid embedded into biomass-derived biochar carbon electrode for supercapacitor applications(Elsevier B.V., 2023) J.e, M.; Chandewar, P.R.; Shee, D.; Mal, S.S.In high-performance, clean, safe, and cost-effective ways, supercapacitors are among the most promising ways to store and release nonfossil energy. In recent years, renewable biomass-derived activated carbon has been explored as a potential option for electrode material. It restricts their specific capacitance despite being environment-friendly and possessing intrinsic mechanical strength. In order to overcome this limitation and preserve all other properties, we are infusing polyoxometalate into the activated carbon; this increases specific capacitance with its fast reversible redox behaviour and preserves the carbon's characteristics. Beside suffusing phosphomolybdic acid (PMA) into biomass waste material, such as orange peel-derived activated carbon (OPAC), a new hybrid material (OPAC-PMA) was developed. The nanohybrid design was revealed by structural and morphological research, which showed high interfacial contact, allowing polyanions to redox rapidly. The novel hybrid electrode material (OPAC-PMA) has a capacitance value of 66% higher than the bare OPAC electrode. A further study showed that OPAC-PMA composite showed 88.23% cycle stability in 0.5 M H2SO4 electrolyte at 6 A g−1 for 4000 cycles. © 2023 Elsevier B.V.Item High-performance hybrid supercapacitor-immobilized Wells-Dawson polyoxometalates on activated carbon electrodes(Royal Society of Chemistry, 2023) Madhusree, J.E.; Chandewar, P.R.; Shee, D.; Mal, S.S.The nanofabrication of electroactive hybrid materials for next-generation energy storage devices is becoming increasingly significant as supercapacitor (SC) technology develops rapidly. The present study utilizes activated carbon (AC) templates reinforced with Wells-Dawson polyoxotungstates (POMs) to produce nanohybrid electrodes for high-performance supercapacitors. This study analyzes Wells-Dawson polyoxotungstates (P2W18) for the first time integrated with AC, and its structural and electrochemical performances are discussed. First, the electrochemical performances of symmetric supercapacitors were characterized in an acidic aqueous electrolyte (0.5 M H2SO4). It was observed that a supercapacitor cell containing the 5 wt% AC-P2W18 hybrid symmetric displayed a noteworthy specific capacitance of 289 F g−1 and a remarkable energy density of 40 W h kg−1. Moreover, 5% AC-P2W18 symmetric supercapacitor cells showed 89% cyclic stability over 4000 cycles. Three LED lights were charged onto the electrode. The LEDs continued to illuminate continuously for red until 160 seconds, yellow until 20 seconds, and blue until 10 seconds after removing the electrode from the electrochemical workstation, demonstrating the device's power and energy density. © 2023 The Royal Society of Chemistry.Item High-performance electrochemical supercapacitors based on polyoxometalate integrated into polyaniline and activated carbon nanohybrid(Springer Science and Business Media Deutschland GmbH, 2023) Anandan Vannathan, A.A.; Kella, T.; Shee, D.; Mal, S.S.Polyaniline (PANI) and carbonaceous materials and metallic compounds have played a significant role in energy storage and conversion devices. PANI has demonstrated tremendous potential in the supercapacitor industry due to its high specific capacitance, high flexibility, and economical price. The CPs damage the hierarchical structure during the charging and discharging process and start swelling. Thus, incorporating polyoxometalates (POMs) into the conducting polymer matrix increases the stability of the electrode material. Here, we have demonstrated a comparative study of two newly synthesized composite materials consisting of K5H2[PV4W8O40] ·11H2O, (PV4W8) POM incorporated into two different supports, such as pseudocapacitive polyaniline (PANI) and EDLC activated carbon (AC) matrix. It was observed that the PANI-PV4W8 composite exhibited excellent capacitance nature at 0.5 M H2SO4 electrolyte solution than AC-PV4W8. The PANI-PV4W8 composite demonstrated the specific capacitance of 584 F g−1 at 0.8 A g−1. The composite also exhibited energy and power density of 81Wh kg−1 and 1598 W kg−1, respectively. Besides, the composite shows 93.13% capacity retention after 4500 cycles by cyclic voltammetry measurement at a 500 mV s−1 scan rate. Furthermore, the AC-PV4W8 showed a specific capacitance of 62 F g−1 at the current density of 0.6 A g−1. Interestingly, The PANI-PV4W8 composite could glow up the red and yellow LED bulb for more than a minute, suggesting a promising electrode material for practical supercapacitor purposes. © 2023, The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature.Item Fabrication of supercapacitor electrode material using carbon derived from waste printer cartridge(Springer Science and Business Media Deutschland GmbH, 2024) Biradar, B.R.; Maity, S.; Chandewar, P.R.; Shee, D.; Das, P.P.; Mal, S.S.Transforming recyclable materials into a suitable product is an important area of research nowadays. This report demonstrates that carbon material derived from waste printer cartridges can be exploited to fabricate electrochemical cells—particularly supercapacitors (SCs). SCs are electrochemical energy storage devices currently attracting much attention in the research community due to their salient features, such as cost-effectiveness, extended cycle stability, and durability. Here, we report the results of thoroughly examining the effects of acidic, basic, and neutral aqueous electrolytes on printer waste carbon electrode material in SC efficiency. In our work, the waste carbon collected from used printer cartridges shows a specific capacitance of 178.4 F/g with energy and power density of 24.77 Wh/kg and 999.68 W/kg, respectively, at 0.5 A/g current density in acidic (1 M H2SO4) electrolyte medium. Moreover, it exhibited very promising capacitance of 135.04 F/g and 87.04 F/g in basic (1 M LiOH) and neutral (1 M NaCl) electrolyte medium, respectively, at 0.8 A/g current density with considerably better cycle stability. In an acidic medium, printer waste carbon drives a DC motor for 1 min with a three-cell series arrangement. The properties of that waste carbon (extracted from the cartridges) are similar to high-rate activated carbon available commercially. Graphical Abstract: (Figure presented.). © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2024.