Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item Structural, optical and mechanical properties of ternary CaO-CaF2-P2O5 glasses(Tsinghua University, 2014) Venkateswara Rao, G.V.; Shashikala, H.D.The ternary phosphate glass series (50?x)CaO-xCaF2-50P2O5 (x = 0–20 mol%) were synthesized using melt quench technique. Structural, optical and mechanical properties were investigated with increase in CaF2 content. Using X-ray diffraction (XRD), synthesized glasses were confirmed to be amorphous in nature. Replacement of oxygen ions by fluorine ions increased the values of density. Decrease in refractive index due to the low polarizability of fluorine ions in the glass matrix was observed. In Fourier transform infrared (FTIR) spectra, the slight variation in ?as (PO2) band position and intensity could be attributed to replacement of fluorine ions for oxygen ions in phosphate glass structure. These data were well supported by Raman spectra. Optical band gap energy increased from 3.44 eV to 3.64 eV with increase in CaF2 content, and Urbach energy decreased suggesting that the fluorine ions reduced the tail energy states in the band gap compared to the oxygen ions. Mechanical parameters such as Vickers hardness, fracture toughness and brittleness were evaluated from the Vickers micro indentation measurements. Increase in Vickers hardness, decrease in fracture toughness and increase in brittleness were observed with increase in CaF2 content. © 2014, The Author(s).Item Thermal and optical properties of BaO-CaF2-P2O5 glasses(Elsevier B.V., 2015) Narayanan, M.K.; Shashikala, H.D.Thermal and optical properties of ternary phosphate glasses prepared by conventional melt-quenching technique, belonging to the series (50 - X)BaO-XCaF2-50P2O5 (X = 0 to 10 mol%) were investigated with increase in CaF2 content. Thermal stability and glass forming ability studied using differential thermal analysis (DTA) were found to increase with the increase in CaF2 content. Powder X-ray diffraction (XRD) analysis of heat treated samples also revealed that CaF2 addition improves the thermal stability against crystallization. Increase in both glass transition temperature and onset crystallization temperature with the increase in CaF2 content can be attributed to the partial substitution of Ba2 + ion with Ca2 + ion, which is having larger field strength. The observed decrease in the melting temperature of glass batch with the increase in CaF2 content indicates that CaF2 acts as a flux and reduces the viscosity of the glass melt. The decrease in refractive index of the glasses with the increase in CaF2 content can be attributed to replacement of lower field strength Ba2 + by Ca2 + or the partial substitution of more polarizable oxygen ion by fluorine. Optical band gap energy slightly increased and Urbach energy marginally reduced with the increase in CaF2 content. Increase in optical band gap energy was further confirmed by calculating theoretical optical basicity of glasses. Average anion polarizability (?O/F) of (50 - X)BaO-XCaF2-50P2O5 glasses calculated from refractivity data using Lorentz-Lorentz relation was correlated with its theoretical optical basicity (?th) using the previously established correlation for oxyfluoro phosphate glasses. © 2015 Elsevier B.V. All rights reserved.Item Ion dynamics of a laser produced aluminium plasma at different ambient pressures(Springer Verlag service@springer.de, 2018) Sankar, P.; Shashikala, H.D.; Philip, R.Plasma is generated by pulsed laser ablation of an Aluminium target using 1064 nm, 7 ns Nd:YAG laser pulses. The spatial and temporal evolution of the whole plasma plume, as well as that of the ionic (Al2+) component present in the plume, are investigated using spectrally resolved time-gated imaging. The influence of ambient gas pressure on the expansion dynamics of Al2+ is studied in particular. In vacuum (10?5 Torr, 10?2 Torr) the whole plume expands adiabatically and diffuses into the ambient. For higher pressures in the range of 1–10 Torr plume expansion is in accordance with the shock wave model, while at 760 Torr the expansion follows the drag model. On the other hand, the expansion dynamics of the Al2+ component, measured by introducing a band pass optical filter in the detection system, fits to the shock wave model for the entire pressure range of 10?2 Torr to 760 Torr. The expansion velocities of the whole plume and the Al2+ component have been measured in vacuum. These dynamics studies are of potential importance for applications such as laser-driven plasma accelerators, ion acceleration, pulsed laser deposition, micromachining, laser-assisted mass spectrometry, ion implantation, and light source generation. © 2017, Springer-Verlag GmbH Germany, part of Springer Nature.Item Corrosion resistance and in-vitro bioactivity of BaO containing Na2O-CaO-P2O5 phosphate glass-ceramic coating prepared on 316 L, duplex stainless steel 2205 and Ti6Al4V(Institute of Physics Publishing helen.craven@iop.org, 2018) Edathazhe, A.B.; Shashikala, H.D.The phosphate glass with composition 11Na2O-15BaO-29CaO-45P2O5 was coated on biomedical implant materials such as stainless steel 316 L, duplex stainless steel (DSS) 2205 and Ti6Al4V alloy by thermal enamelling method. The structural properties and composition of glass coated substrates were studied by x-ray diffraction (XRD), Scanning electron microscopy (SEM) and Energy dispersive x-ray spectroscopy (EDS) analysis. The coatings were partially crystalline in nature with porous structure and pore size varied from micro to nanometer range. The polarization curve was obtained for uncoated and coated substrates from electrochemical corrosion test which was conducted at 37 °C in Hank's balanced salt solution (HBSS). The corrosion resistance of 316 L substrate increased after coating, whereas it decreased in case of DSS 2205 and Ti6Al4V. The XRD and SEM/EDS studies indicated the bioactive hydroxyapatite (HAp) layer formation on all the coated surfaces after electrochemical corrosion test, which improved the corrosion resistance. The observed electrochemical corrosion behavior can be explained based on protective HAp layer formation, composition and diffusion of ions on glass coated surfaces. The in-vitro bioactivity test was carried out at 37 °C in HBS solution for 14 days under static conditions for uncoated and coated substrates. pH and ion release rate measurements from the coated samples were conducted to substantiate the electrochemical corrosion test. The lower ion release rates of Na+ and Ca2+ from coated 316 L supported its higher electrochemical corrosion resistance among coated samples. Among the uncoated substrates, DSS showed higher electrochemical corrosion resistance. Amorphous calcium-phosphate (ACP) layer formation on all the coated substrates after in-vitro bioactivity test was confirmed by XRD, SEM/EDS and ion release measurements. The present work is a comparative study of corrosion resistance and bioactivity of glass coated and uncoated biomedical implants such as 316 L, DSS and Ti6Al4V. © 2018 IOP Publishing Ltd.Item Effect of laser beam size on the dynamics of ultrashort laser-produced aluminum plasma in vacuum(American Institute of Physics Inc. subs@aip.org, 2019) Sankar, P.; Shashikala, H.D.; Philip, R.In laser-produced plasma experiments, the diameter of the irradiating laser beam on the target surface is a major parameter that influences the ablation mechanisms, plasma emission intensity, charged particle ejection, and plume morphology. In this work, the expansion dynamics of an ultrashort laser-produced aluminum plasma is investigated as a function of the laser beam size on the target, using a combination of diagnostic tools, viz., optical emission spectroscopy, fast gated time-resolved imaging, and ion current measurements. A Ti:sapphire laser delivering 100 fs, 6 mJ pulses at 800 nm is used for producing plasma from a pure Al target placed in vacuum (10 -5 Torr) at different positions with respect to the geometrical focus of the beam. Optical emission spectroscopic analysis of the plasma shows that higher emission intensities and ion populations are obtained for smaller beam sizes. Time-resolved Intensified Charge Coupled Device (ICCD) imaging of the expanding plasma shows a spherical morphology for plumes produced by smaller beam sizes and a cylindrical morphology for those produced by larger beam sizes. Temporal profiles of ion emission measured using a Faraday cup are in agreement with ICCD data, featuring a dual peak structure for larger beam sizes indicating distinct slow and fast ionic species, arising from changes in the ablation mechanism for varying laser fluences. Plume expansion is modelled by free expansion for the fast species and by shock wave propagation for the slow species. Ion flux and velocities are relatively high for smaller beam sizes. These studies can be of potential importance for laser processing applications, including laser welding, drilling, and micromachining. © 2019 Author(s).Item Influence of low concentrations of vanadium and titanium ions on the structural and optical properties of borophosphate glasses(Elsevier B.V., 2025) Rashmi, I.; Raghuvanshi, V.; Ingle, A.; Shashikala, H.D.; Nagaraja, H.S.A series of P2O5–B2O3–BaO glass system containing various V2O5 and TiO2 content (from 0.25 to 0.75 mol%) were synthesized using the melt-quenching method to examine their structural, EPR, and optical characteristics. EPR analysis confirmed VO2+ hyperfine splitting and the presence of Ti3+ ions in a tetragonally compressed octahedral structure. The local structures of VO2+ and Ti3+ centers were explored through spin Hamiltonian parameters (g??e) and optical transition energies. UV–visible spectroscopy revealed multiple oxidation states of vanadium (V3+, VO2+ and V5+) and titanium (Ti3+, Ti4+), which significantly influenced the optical characteristics. Photoluminescence (PL) studies indicated the presence of oxygen vacancies and intrinsic defects in the glass matrix, with [VO4]3- groups and Ti3+ ions significantly enhancing emission properties. The enhanced luminescence was observed for glasses with 0.75 mol% TiO2 and 0.75 mol% V2O5. Notably, the 0.75 mol% V2O5-doped glass, exhibited CIE chromaticity coordinates (x = 0.26, y = 0.31), closely aligning with standard white light. The tunability of optical properties through transition metal oxide doping highlights the potential of these glasses for advanced photonic applications, including optical filters and display technologies. © 2025 Elsevier B.V.