Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
7 results
Search Results
Item Thermodynamic simulation of ammonia-water absorption refrigeration system(Serbian Society of Heat Transfer Engineers, 2008) Sathyabhama, A.; Ashok Babu, T.P.The ammonia-water absorption refrigeration system is attracting increasing research interests, since the system can be powered by waste thermal energy, thus reducing demand on electricity supply. The development of this technology demands reliable and effective system simulations. In this work, a thermodynamic simulation of the cycle is carried out to investigate the effects of different operating variables on the performance of the cycle. A computer program in C language is written for the performance analysis of the cycle.Item Experimental investigation in pool boiling heat transfer of ammonia/water mixture and heat transfer correlations(2011) Sathyabhama, A.; Ashok Babu, T.P.A.The nucleate pool boiling heat transfer coefficient of ammonia/water mixture was investigated on a cylindrical heated surface at low pressure of 4-8bar and at low mass fraction of 0NH3<0.3 and at different heat flux. The effect of mass fraction, heat flux and pressure on boiling heat transfer coefficient was studied. The results indicate that the heat transfer coefficient in the mixture decreases with increase in ammonia mass fraction, increases with increase in heat flux and pressure in the investigated range. The measured heat transfer coefficient was compared with existing correlations. The experimental data were predicted with an accuracy of ±20% by the correlation of Calus&Rice, correlation of Stephan-Koorner and Inoue-Monde correlation for ammonia/water mixture in the investigated range of low ammonia mass fraction. The empirical constant of the first two correlations is modified by fitting the correlation to the present experimental data. The modified Calus&Rice correlation predicts the present experimental data with an accuracy of ±18% and the modified Stephan-Koorner correlation with an accuracy of ±16%. © 2011 Elsevier Inc.Item Vapor-liquid equilibrium of ammonia-water-lithium nitrate solutions(2011) Sathyabhama, A.; Ashok Babu, T.P.Experimental results on the pressure-temperature data for the NH3-H2O binary and NH3-H2O-LiNO3 ternary solutions are reported. The pressure was varied between 100 and 800 kPa, while the mass fraction of ammonia was varied in the range 0-0.30. The lithium nitrate concentration of the solution was chosen in the range of 10-50% of mass ratio of lithium nitrate in pure water. An analytical equation for the equilibrium pressure as a function of temperature and concentration was obtained with a good fit to experimental data. © 2011 Wiley Periodicals, Inc.Item Experimental study of nucleate pool boiling heat transfer to ammonia-water-lithium bromide solution(2011) Sathyabhama, A.; Ashok Babu, T.P.Visualization of bubble nucleation during nucleate pool boiling outside a vertical cylindrical heated surface was done for ammonia-water binary and ammonia-water-lithium bromide ternary mixture in order to obtain a descriptive behavior of the boiling which was directly compared with the measured heat transfer coefficient at low pressure of 4-8. bar and at low ammonia mass fraction of 0Item Nucleate pool boiling heat transfer measurement and flow visualization for ammonia-water mixture(2011) Sathyabhama, A.; Ashok Babu, T.P.Visualization of bubble nucleation during nucleate pool boiling outside a vertical cylindrical heated surface was done for ammonia-water binary mixture in order to obtain a descriptive behavior of the boiling, which was directly compared with the measured heat transfer coefficient data at low pressure of 4-8 bar and at low mass fraction of 0 < x < 0.3 and at different heat flux. Still images taken with high speed camera are used to demonstrate the decrease in boiling heat transfer coefficient with increase in ammonia mass fraction. Jensen and Memmel model has better agreement with experimental bubble diameter. Further work is required to obtain quantitative information about bubble nucleation parameters. It is found that both Calus and Rice and Stephan-Koorner correlation can predict the experimental heat transfer coefficient values with a maximum deviation of ±20%. © 2011 American Society of Mechanical Engineers.Item Experimental investigation of pool boiling heat transfer in ammonia-water-lithium nitrate solution(2012) Sathyabhama, A.; Ashok Babu, T.P.The nucleate pool boiling heat transfer coefficient of an NH 3-H 2O-LiNO 3 mixture was investigated on a cylindrical heated surface at low pressure of 4 to 8 bar, low ammonia mass fraction of 0 < xNH 3 < 0.3, and different heat fluxes. The lithium nitrate concentration of the solution was chosen in the range of 10-50% of mass ratio of lithium nitrate in pure water. The effects of concentrations, heat flux, and pressure on boiling heat transfer coefficient was studied. The results indicate that the heat transfer coefficient in the mixture decreases with increase in ammonia mass fraction, increases with the addition of lithium nitrate, and increases with an increase in heat flux and pressure in the investigated range. © 2012 Copyright Taylor and Francis Group, LLC.Item Effect of salt on the performance of ammonia absorption refrigeration cycle: A simulation study(Elsevier Ltd, 2024) Kolapkar, G.; Sathyabhama, A.To overcome the drawbacks associated with conventional binary mixtures (NH3-H2O and H2O-LiBr) in the vapor absorption refrigeration system (VARS), salt is added to the NH3-H2O mixture. The present simulation study analyzes the influence of adding LiBr and LiNO3 salts within a salt mass fraction range of 0 to 35% on the coefficient of performance (COP) of the NH3-H2O cycle. The simulations are conducted using Aspen Plus software. Furthermore, the influence of generator temperature on the COP and evaporator capacity of the ternary NH3-H2O-LiBr and NH3-H2O-LiNO3 cycles are also studied. The simulation results demonstrate that adding LiBr and LiNO3 salts improves the COP and reduces the initial temperature requirement in the generator of the VARS. Specifically, the NH3-H2O-LiBr cycle achieves the highest COP of 0.645 at an NH3 mass fraction of 55% and a LiBr mass fraction of 25%. This represents an 8.81% improvement compared to the COP of the NH3-H2O cycle. Similarly, the NH3-H2O-LiNO3 cycle exhibits the peak COP of 0.603 with the same NH3 mass fraction and LiNO3 mass fraction of 20%, which is 2.2% greater than the COP of the NH3-H2O cycle. Under similar operating conditions, the COP of the NH3-H2O-LiBr cycle is greater than that of the NH3-H2O-LiNO3 cycle. © 2024 Elsevier Ltd