Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Investigation of CMOS Based Integration Approach Using DAI Technique for Next Generation Wireless Networks(Springer New York LLC barbara.b.bertram@gsk.com, 2019) Roy, G.M.; Kanuajia, B.K.; Dwari, S.; Kumar, S.; Song, H.This research work investigates a CMOS based low noise amplifier (LNA) using differential active inductor with eight-shaped patch antenna for next generation wireless communication. The proposed work conceded into three different phases. The first phase proposes LNA architecture which includes multistage cascode amplifier with a gate inductor gain peaking technique. The ground approach for this architecture employs active inductor technique that includes two stages of differential amplifier. The proposed novel technique leads to give incremental in inductance by using of common mode feedback resistor and lowers the undesirable parasitic resistance effect. Additionally, this technique offers gain enhanced noise cancellation and achieves a frequency band of around 5.7 GHz. The proposed architecture includes single stage differential AI and enhances the bandwidth up to 6.8 GHz with peak gain of 21 dB at 7.8 GHz. The noise figure and stability factor are achieved which is reasonably good at 1 dB. The proposed architecture is design and optimized on advanced design RF simulator using 0.045 µm CMOS process technology. While in second phase, a narrow band eight-shaped patch antenna is designed which provides operating band range from 5.8 to 6.5 GHz with 6.2 GHz resonating frequency. Highest peak gain of 15 dB and maximum radiation power of 42.5 dBm is succeed by proposed antenna. The final phase provides integration strategy of LNA with antenna and achieves desired gain of nearly 21 dB with minimum NF of 1.2–1.5 dB in the same band. © 2018, Springer Science+Business Media, LLC, part of Springer Nature.Item A 2.71-pA/√Hz ultra-low noise, 70-dB dynamic range CMOS transimpedance amplifier with incorporated microstrip line techniques over extended bandwidth(John Wiley and Sons Ltd, 2023) Gorre, P.; Vignesh, R.; Kumar, S.; Song, H.; Roy, G.M.Recent advancements in the area of telemedicine have focused on remote patient monitoring services as a new frontier in medical applications. The present work reports a 65-nm complementary metal–oxide–semiconductor (CMOS)-based transimpedance amplifier (TIA) in an optical radar system for non-contact patient monitoring. A T-shaped microstrip line (MSL) integrated with variable gain common source TIA using MSL peaking technique and off-chip post-amplification integration is a newly proposed architecture to achieve a ultra-low noise, high dynamic range (DR) and high figure of merit over broadband than a traditional TIAs. First, the integrated T-shaped MSL develops an additional resonant frequency that resonates with a photodiode capacitance improving the bandwidth performance at higher Q values. Second, the shunt MSL peaking technique that introduces an additional conjugate pole-pair that cancels the effect of input capacitance helps to further improve the bandwidth of the TIA. Finally, an active feedback concept achieves a wide linear dynamic range enabling high TIA detectability. The proposed TIA realizes an impedance bandwidth of 770 MHz ranging from 7.12 to 7.89 GHz with a transimpedance gain of 105.1 dBΩ and ultra-low input-referred noise (IRN) density of 2.71 pA/√Hz. A high linear DR of 70 dB is achieved by employing a variable gain control scheme with a low group delay variation of 0.81 ns. The proposed work demonstrates a 1-Gb/s data rate while a bit-error rate less than 10−12 is achieved. The TIA consumes a power of 0.82 mW under the supply voltage of 1.2 V. © 2022 John Wiley & Sons Ltd.