Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Author: search.filters.author.Reddy, R.P.Subject: search.filters.subject.Engines

Search Results

Now showing 1 - 5 of 5
  • No Thumbnail Available
    Item
    6BTA 5.9 G2-1 Cummins engine performance and emission tests using methyl ester mahua (Madhuca indica) oil/diesel blends
    (2009) Godiganur, S.; Suryanarayana Murthy, C.H.; Reddy, R.P.
    Neat mahua oil poses some problems when subjected to prolonged usage in CI engine. The transesterification of mahua oil can reduce these problems. The use of biodiesel fuel as substitute for conventional petroleum fuel in heavy-duty diesel engine is receiving an increasing amount of attention. This interest is based on the properties of bio-diesel including the fact that it is produced from a renewable resource, its biodegradability and potential to exhaust emissions. A Cummins 6BTA 5.9 G2- 1, 158 HP rated power, turbocharged, DI, water cooled diesel engine was run on diesel, methyl ester of mahua oil and its blends at constant speed of 1500 rpm under variable load conditions. The volumetric blending ratios of biodiesel with conventional diesel fuel were set at 0, 20, 40, 60, and 100. Engine performance (brake specific fuel consumption, brake specific energy consumption, thermal efficiency and exhaust gas temperature) and emissions (CO, HC and NOx) were measured to evaluate and compute the behavior of the diesel engine running on biodiesel. The results indicate that with the increase of biodiesel in the blends CO, HC reduces significantly, fuel consumption and NOx emission of biodiesel increases slightly compared with diesel. Brake specific energy consumption decreases and thermal efficiency of engine slightly increases when operating on 20% biodiesel than that operating on diesel. © 2008 Elsevier Ltd. All rights reserved.
  • No Thumbnail Available
    Item
    Characterization and effect of using Mahua oil biodiesel as fuel in compression ignition engine
    (2009) Kapilan, N.; Ashok Babu, T.P.; Reddy, R.P.
    There is an increasing interest in India, to search for suitable alternative fuels that are environment friendly. This led to the choice of Mahua Oil (MO) as one of the main alternative fuels to diesel. In this investigation, Mahua Oil Biodiesel (MOB) and its blend with diesel were used as fuel in a single cylinder, direct injection and compression ignition engine. The MOB was prepared from MO by transesterification using methanol and potassium hydroxide. The fuel properties of MOB are close to the diesel and confirm to the ASTM standards. From the engine test analysis, it was observed that the MOB, B5 and B20 blend results in lower CO, HC and smoke emissions as compared to diesel. But the B5 and B20 blends results in higher efficiency as compared to MOB. Hence MOB or blends of MOB and diesel (B5 or B20) can be used as a substitute for diesel in diesel engines used in transportation as well as in the agriculture sector. © 2009 Science Press, Institute of Engineering Thermophysics, CAS and Springer Berlin Heidelberg.
  • No Thumbnail Available
    Item
    Effect of using Mahua as an alternative fuel in diesel engine
    (2009) Kapilan, N.; Ashok Babu, T.P.A.; Reddy, R.P.
    There is an increasing interest in India, to search for suitable alternative fuels that are environment friendly. This led to the choice of non-edible Mahua Oil (MO) as one of the main alternative fuels to diesel oil in India. The objective of the present work is to use MO as a partial renewable alternative substitute for diesel in the agricultural diesel engine. Since the viscosity of the MO is high, it was blended with conventional diesel oil in various proportions (M5, M10, M15 and M20 on volume basis) and fuel properties of the blends were determined and compared with the diesel. Engine tests were carried out on a single cylinder diesel engine at varying loads (0%, 25%, 50%, 75% and 100%), without making any modification in the fuel injection system and the results were compared with the diesel. The M5 and M10 blends resulted in performance and emission characteristics comparable to diesel operation and also emits lower carbon monoxide, hydrocarbon and smoke emissions as compared to other blends. From the analysis, it is concluded that the MO can be partially substituted for diesel oil in the diesel engine, without making any modification in the hardware of the engine.
  • No Thumbnail Available
    Item
    Performance and emission characteristics of a Kirloskar HA394 diesel engine operated on fish oil methyl esters
    (2010) Godiganur, S.; Suryanarayana Murthy, Ch.; Reddy, R.P.
    The high viscosity of fish oil leads to problem in pumping and spray characteristics. The inefficient mixing of fish oil with air leads to incomplete combustion. The best way to use fish oil as fuel in compression ignition (CI) engines is to convert it into biodiesel. It can be used in CI engines with very little or no engine modifications. This is because it has properties similar to mineral diesel. Combustion tests for methyl ester of fish oil and its blends with diesel fuel were performed in a kirloskar H394 DI diesel engine, to evaluate fish biodiesel as an alternative fuel for diesel engine, at constant speed of 1500 rpm under variable load conditions. The tests showed no major deviations in diesel engine's combustion as well as no significant changes in the engine performance and reduction of main noxious emissions with the exception on NOx. Overall fish biodiesel showed good combustion properties and environmental benefits. © 2009 Elsevier Ltd. All rights reserved.
  • No Thumbnail Available
    Item
    Performance and emission characteristics of double cylinder CI engine operated with cardanol bio fuel blends
    (2012) Mallikappa, D.N.; Reddy, R.P.; Murthy, C.S.N.
    India imports more than seventy percent of the oil it uses and is looking for alternative fuel to reduce its dependence on imports. In India, bio fuels derived from non-edible oils is considered as a renewable alternative to the fossil diesel. The cost of the biodiesel is higher than diesel and hence in this work, cardanol was used as an alternative renewable fuel for the diesel engine. The engine tests were conducted on a double cylinder, direct injection, compression ignition engine. From the engine tests, it is observed that the brake power increases (by 70% approximately) as load increases. Brake specific energy conversion decreases (by 25-30% approximately) with increase in brake power. Brake thermal efficiency increases with higher brake power and emission levels (HC, CO, NOX) were nominal up to 20% blends. © 2011 Elsevier Ltd.