Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
9 results
Search Results
Item Comparison of performance of biodiesels of mahua oil and gingili oil in dual fuel engine(Serbian Society of Heat Transfer Engineers, 2008) Nadar, K.N.; Reddy, R.P.; Anjuri, E.R.In this work, an experimental work was carried out to compare the performance of biodiesels made from non edible mahua oil and edible gingili oil in dual fuel engine. A single cylinder diesel engine was modified to work in dual fuel mode and liquefied petroleum gas was used as primary fuel. Biodiesel was prepared by transesterification process and mahua oil methyl ester (MOME) and gingili oil methyl ester (GOME) were used as pilot fuels. The viscosity of MOME is slightly higher than GOME. The dualfuel engine runs smoothly with MOME and GOME. The test results show that the performance of the MOME is close to GOME, at the pilot fuel quantity of 0.45 kg/h and at the advanced injection timing of 30 deg bTDC. Also it is observed that the smoke, carbon monoxide and unburnt hydro carbon emissions of GOME lower than the MOME. But the GOME results in slightly higher NOx emissions. From the experimental results it is concluded that the biodiesel made from mahua oil can be used as a substitute for diesel in dual fuel engine.Item Combustion and emission characteristics of a dual fuel engine operated with mahua oil and liquefied petroleum gas(Serbian Society of Heat Transfer Engineers, 2008) Nadar, K.N.; Reddy, R.P.For the present work, a single cylinder diesel engine was modified to work in dual fuel mode. To study the feasibility of using methyl ester of mahua oil as pilot fuel, it was used as pilot fuel and liquefied petroleum gas was used as primary fuel. In dual fuel mode, pilot fuel quantity and injector opening pressure are the few variables, which affect the performance and emission of dual fuel engine. Hence, in the present work pilot fuel quantity and injector opening pressure were varied. From the test results, it was observed that the pilot fuel quantity of 5 mg per cycle and injector opening pressure of 200 bar results in higher brake thermal efficiency. Also the exhaust emissions such as smoke, unburnt hydrocarbon and carbon monoxide are lower than other pressures and pilot fuel quantities. The higher injection pressure and proper pilot fuel quantity might have resulted in better atomization, penetration of methyl ester of mahua oil and better combustion of fuel.Item Experimental investigation of esters of mahua oil as an alternative fuel for dual fuel engine(2008) Reddy, P.B.; Kapilan, N.; Reddy, R.P.In the present work, an attempt was made to use methyl ester of mahua oil (MEMO) as substitute for dieselin dual fuel engine. A four stroke single cylinder engine was modified to work in dual fuel mode. From the test results, it was observed that the MEMO could be used as pilot fuel in dual fuel engine. At lower loads, diesel gave higher brake thermal efficiency. But at higher loads, biodiesel resulted in brake thermal efficiency comparable with diesel and lower smoke and oxides of nitrogen emissions. From the test results, it was concluded that MEMO could be used as a substitute for diesel in dual fuel engine.Item Characterization and effect of using Mahua oil biodiesel as fuel in compression ignition engine(2009) Kapilan, N.; Ashok Babu, T.P.; Reddy, R.P.There is an increasing interest in India, to search for suitable alternative fuels that are environment friendly. This led to the choice of Mahua Oil (MO) as one of the main alternative fuels to diesel. In this investigation, Mahua Oil Biodiesel (MOB) and its blend with diesel were used as fuel in a single cylinder, direct injection and compression ignition engine. The MOB was prepared from MO by transesterification using methanol and potassium hydroxide. The fuel properties of MOB are close to the diesel and confirm to the ASTM standards. From the engine test analysis, it was observed that the MOB, B5 and B20 blend results in lower CO, HC and smoke emissions as compared to diesel. But the B5 and B20 blends results in higher efficiency as compared to MOB. Hence MOB or blends of MOB and diesel (B5 or B20) can be used as a substitute for diesel in diesel engines used in transportation as well as in the agriculture sector. © 2009 Science Press, Institute of Engineering Thermophysics, CAS and Springer Berlin Heidelberg.Item Effect of using Mahua as an alternative fuel in diesel engine(2009) Kapilan, N.; Ashok Babu, T.P.A.; Reddy, R.P.There is an increasing interest in India, to search for suitable alternative fuels that are environment friendly. This led to the choice of non-edible Mahua Oil (MO) as one of the main alternative fuels to diesel oil in India. The objective of the present work is to use MO as a partial renewable alternative substitute for diesel in the agricultural diesel engine. Since the viscosity of the MO is high, it was blended with conventional diesel oil in various proportions (M5, M10, M15 and M20 on volume basis) and fuel properties of the blends were determined and compared with the diesel. Engine tests were carried out on a single cylinder diesel engine at varying loads (0%, 25%, 50%, 75% and 100%), without making any modification in the fuel injection system and the results were compared with the diesel. The M5 and M10 blends resulted in performance and emission characteristics comparable to diesel operation and also emits lower carbon monoxide, hydrocarbon and smoke emissions as compared to other blends. From the analysis, it is concluded that the MO can be partially substituted for diesel oil in the diesel engine, without making any modification in the hardware of the engine.Item The effect of karanja oil methyl ester on Kirloskar HA394DI diesel engine performance and exhaust emissions(Serbian Society of Heat Transfer Engineers, 2010) Godiganur, S.; Suryanarayana Murthy, Ch.; Reddy, R.P.Biofuels are being investigated as potential substitutes for current high pollutant fuels obtained from the conventional sources. The primary problem associated with using straight vegetable oil as fuel in a compression ignition engine is caused by viscosity. The process of transesterifiction of vegetable oil with methyl alcohol provides a significant reduction in viscosity, thereby enhancing the physical properties of vegetable oil. The Kirloskar HA394 compression ignition, multi cylinder diesel engine does not require any modification to replace diesel by karanja methyl ester. Biodiesel can be used in its pure form or can be blended with diesel to form different blends. The purpose of this research was to evaluate the potential of karanja oil methyl ester and its blend with diesel from 20% to 80% by volume. Engine performance and exhaust emissions were investigated and compared with the ordinary diesel fuel in a diesel engine. The experimental results show that the engine power of the mixture is closed to the values obtained from diesel fuel and the amounts of exhaust emissions are lower than those of diesel fuel. Hence, it is seen that the blend of karanja ester and diesel fuel can be used as an alternative successfully in a diesel engine without any modification and in terms of emission parameters; it is an environmental friendly fuel.Item Performance characteristics of a dual fuel engine operated with Mahua biodiesel and liquefied petroleum gas(ASTM International, 2011) Kapilan, N.; Ashok Babu, T.P.; Reddy, R.P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed the interest of the scientific community to look for alternative fuels of bio-origin such as vegetable oils and ethanol. India is looking at biodiesel derived from Mahua oil (MO), as one of the renewable alternative fuels for compression ignition (CI) engine. Although MO biodiesel (MOB) has several advantages over fossil diesel, in the present scenario, the use of biodiesel is restricted due to its high cost. In India, liquefied petroleum gas (LPG) is easily available and is one of the cheapest gaseous fuels. Hence, use of LPG to fuel a CI engine along with MOB seems to be an option for substitution of fossil diesel. In the present work, LPG, which was fumigated along with the air and biodiesel was admitted into the engine cylinder through conventional fueling device as an igniter. A single cylinder CI engine was modified to work in dual fuel mode and engine tests were carried out at rated speed under variable load conditions. The performance of the engine in dual fuel mode was compared with the diesel. The dual fuel operation results in thermal efficiency close to the diesel and also reduces the NOx and smoke emissions significantly. From the experimental results, we concluded that biodiesel in dual fuel mode with cheaper gaseous fuel induction is an option for reducing the operating cost of the biodiesel fuelled CI engine. Copyright ©2011 by ASTM International, 100 Barr Harbor Drive, PO Box C700, West Conshohocken, PA 19428-2959.Item Performance characteristics of a dual fuel engine operatedwith mahua biodiesel and liquefied petroleum gas(2011) Kapilan, N.; Ashok Babu, T.P.A.; Reddy, R.P.Fuel crisis because of dramatic increase in vehicular population and environmental concerns have renewed the interest of the scientific community to look for alternative fuels of bio-origin such as vegetable oils and ethanol. India is looking at biodiesel derived from Mahua oil (MO), as one of the renewable alternative fuels for compression ignition (CI) engine. Although MO biodiesel (MOB) has several advantages over fossil diesel, in the present scenario, the use of biodiesel is restricted due to its high cost. In India, liquefied petroleum gas (LPG) is easily available and is one of the cheapest gaseous fuels. Hence, use of LPG to fuel a CI engine along with MOB seems to be an option for substitution of fossil diesel. In the present work, LPG, which was fumigated along with the air and biodiesel was admitted into the engine cylinder through conventional fueling device as an igniter. A single cylinder CI engine was modified to work in dual fuel mode and engine tests were carried out at rated speed under variable load conditions. The performance of the engine in dual fuel mode was compared with the diesel. The dual fuel operation results in thermal efficiency close to the diesel and also reduces the NOx and smoke emissions significantly. From the experimental results, we concluded that biodiesel in dual fuel mode with cheaper gaseous fuel induction is an option for reducing the operating cost of the biodiesel fuelled CI engine. Copyright © 2011 by ASTM International.Item Performance and emission characteristics of double cylinder CI engine operated with cardanol bio fuel blends(2012) Mallikappa, D.N.; Reddy, R.P.; Murthy, C.S.N.India imports more than seventy percent of the oil it uses and is looking for alternative fuel to reduce its dependence on imports. In India, bio fuels derived from non-edible oils is considered as a renewable alternative to the fossil diesel. The cost of the biodiesel is higher than diesel and hence in this work, cardanol was used as an alternative renewable fuel for the diesel engine. The engine tests were conducted on a double cylinder, direct injection, compression ignition engine. From the engine tests, it is observed that the brake power increases (by 70% approximately) as load increases. Brake specific energy conversion decreases (by 25-30% approximately) with increase in brake power. Brake thermal efficiency increases with higher brake power and emission levels (HC, CO, NOX) were nominal up to 20% blends. © 2011 Elsevier Ltd.