Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
2 results
Search Results
Item Influence of rotational speed during centrifugal casting on sliding wear behaviour of the Al-2Si alloy(2009) Mukunda, P.G.; Rao, S.; Rao, S.S.The microstructures and dry sliding wear behaviour of an Al-2Si alloy cast centrifugally are studied. Results indicate that at optimum speed the cast has a microstructure consisting of uniformly distributed ?-Al grains and fine eutectic silicon grains. The cast exhibited better wear resistance compared to the same cast prepared at different rpms. This paper attempts to investigate the influence of the microstructural changes in the Al-2Si alloy by varying the rotational speed of the mould and its combined action on the dry sliding wear behaviour. © Higher Education Press and Springer-Verlag 2009.Item Understanding Melt Flow Behavior for Al-Si Alloys Processed Through Vertical Centrifugal Casting(Taylor and Francis Inc. 325 Chestnut St, Suite 800 Philadelphia PA 19106, 2015) Rao, R.A.; Tattimani, M.S.; Rao, S.S.The objective of this article is to investigate the appearance, microstructure, and hardness of Al-Si alloys Al-12Si and Al-17Si in vertical centrifugal casting process. During rotation of the mold, molten metal flow affects the formation of uniform cylinder. In this study, flow of molten metal for Al-Si alloys at different rotational speeds is focused. It is found that for Al-17Si alloy a uniform cast tube is observed for 1000 rpm, whereas for Al-12Si it is at 1200 rpm; above and below these speeds, irregular cast tubes are formed. Finally, fine structured grain size with high hardness value is found in a uniform cast tube in comparison with others. © 2015 Taylor & Francis Group, LLC.