Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Diluted magnetism in Mn-doped SrZnO2 single crystals(American Institute of Physics Inc., 2013) Rahman, M.R.; Koteswararao, B.; Huang, S.H.; Kim, K.; Chou, F.C.We have investigated the magnetic properties of Mn- and Cu-substituted SrZnO2 single crystals (SrZn1-xMnxO2 and SrZn1-xCuxO2). We observed signatures of weak ferromagnetism as a sharp increase of magnetic susceptibility below 5 K even in the low-percentage (x = 0.01) of Mn-substituted single crystals. Magnetic susceptibility data measured parallel or perpendicular to the ab-plane yield anisotropic behavior with Curie-Weiss temperature of about -320 K and -410 K, respectively, suggesting the presence of strong antiferromagnetic couplings among Mn at high temperatures, similar to the Mn-doped ZnO and Fe-doped BaTiO3. In contrast, the SrZn0.99Cu0.01O 2 crystal shows paramagnetic behavior down to 2 K. © 2013 AIP Publishing LLC.Item Synthesis and characterization of zinc oxide incorporated iron borate glass-ceramic(Elsevier Ltd, 2019) Ramteke, R.; Kumari, K.; Bhattacharya, S.; Rahman, M.R.Here, zinc oxide (ZnO) incorporated iron borate (Fe3BO6) glass-ceramics have been synthesized using the traditional melt-quenching technique, and the role of ZnO has been investigated. X-ray diffraction (XRD) and scanning electron microscopy (SEM) reveals that the prepared samples have a single crystalline phase and crystalline nanostructures, respectively. The orthorhombic crystal structure has been retained without the formation of a new crystalline phase. The addition of ZnO is found to distort the Fe3BO6 lattice by substituting Zn2+ in the Fe3+ sites, with the formation of ZnO6 structural units as revealed by Fourier transform infrared spectroscopy (FTIR). FTIR and Raman spectroscopy conducted to study the structure of glass-ceramic, have also revealed the formation of other structural units like ZnO4, BO3, BO4, and FeO6 in the system. Surface analysis conducted by X-ray photoelectron spectroscopy (XPS) reveals that the addition of ZnO diminishes the formation of surface B2O3 layer which forms over the Fe3BO6 phase in the Fe3BO6 iron borate glass-ceramic system. ZnO addition has also shown a remarkable difference in the volume of the crystallization in the system, thereby paving the way for controlled crystallization in the iron borate glass-ceramic system. The controlled crystallization was achieved through additive content, retaining the iron borate (Fe3BO6) glass-ceramic system without the evolution of any secondary phases even with large additive concentrations up to 10 mol%. © 2019 Elsevier B.V.Item Impedance spectroscopy study of zinc oxide incorporated iron borate glass-ceramic(Elsevier B.V., 2021) Ramteke, R.; Kumari, K.; Bhattacharya, S.; Sharma, S.K.; Rahman, M.R.Here, the effects of zinc oxide (ZnO) on impedance and dielectric properties of the ZnO incorporated iron borate (Fe3BO6) glass-ceramics were studied using impedance spectroscopy in a wide range of frequency (1 Hz – 1 MHz) and temperature (25 °C–250 °C). With ZnO addition, the ?? and tan? values were reduced significantly, the strength of the relaxation process also decreased, along with a decrease in conductivity. Activation energies associated with modulus and conductivity plots suggest that similar type of charge carriers was responsible for the relaxation and conduction processes. The analysis of both complex impedance and conductivity show the negative temperature coefficient of resistance (NTCR) behavior of the samples. The thermistor constant B-values of 5ZnO and 10ZnO were found to be 7223 and 7088 respectively. The study of the NTCR properties suggests a potential candidate for thermistor applications. © 2021 Korean Physical SocietyItem A study on solubility of bismuth cations in nickel cobalt ferrite nanoparticles and their influence on dielectric and magnetic properties(Elsevier Ltd, 2023) Patil, S.; Meti, S.; Kanavi, P.S.; Bhajantri, R.F.; Anandalli, M.; Mondal, R.; Karmakar, S.; Muhiuddin, M.; Rahman, M.R.; Kumar, B.C.; Hegde, B.G.In this work, a low temperature (∼600 °C) solution combustion technique is employed for the synthesis of Ni0.5Co0.5BixFe2-xO4 (NCBFO, where x = 0.0, 0.05, 0.1, 0.15, & 0.2) nanoparticles with crystallite size variation of 17–22 nm. The X-ray diffraction (XRD) technique is used to confirm the formation of cubic spinel phase of Bi3+ doped (for x ≤ 0.05 samples) nickel–cobalt ferrite (NCFO) nanoparticles. The increase in bismuth substitution (x > 0.05) results in the formation of the Bi2O3 along with the NCFO structure, which results in the reduction of binding energy and is confirmed by the XRD and X-ray photoelectron spectroscopy (XPS) techniques. From the Raman spectra, the change in the intensities of the peaks is observed due to the variation of Bi3+ in NCFO matrix. Due to increasing cation concentration and electronegativity, the FTIR absorption band shifts toward the lower wave numbers. Dielectric measurements were carried out to examine the charge transport behavior and electric conduction mechanism. The FESEM images shows the non-magnetic bismuth atoms are diffused into the NCFO nanoparticles. From the vibrating sample magnetometer (VSM) analysis, it is observed that saturation magnetization, remanent magnetization, coercivity and squareness ratio are found to be maximum for x = 0.15 NCBFO sample. The high coercivity (Hc = 916.8 Oe) for the x = 0.15 sample indicates the hard ferromagnetic behaviour of the samples. © 2023 Elsevier B.V.Item Effect of temperature on wear and friction performance of WC-Co and Cr3C2 reinforced with 17-4PH Fe-based composite coatings(Springer Science and Business Media Deutschland GmbH, 2024) Chandramouli, T.V.; Joladarashi, S.; Ramesh, M.R.; Rahman, M.R.Surface protection is crucial in industrial equipment and tools to prevent wear and friction in harsh environments, particularly at high temperatures, where anti-friction coatings are essential for optimal performance. The present research investigates the tribological properties of high-velocity oxy-fuel sprayed coatings of 17-4PH stainless steel reinforced with tungsten carbide and chromium carbide powders. The coatings are deposited onto a maraging steel substrate. A dry sliding wear test was performed using an alumina ball as a counter body under various test temperatures (25 °C, 300 °C, and 600 °C) and loads (10 N and 30 N). The coating is characterized by employing SEM, XRD, micro-hardness tester, particle analyzer, and bond strength tester, and the mechanism of wear reduction was discussed. The post-wear analysis was carried out on the wear track using SEM/EDS and 3D non-contact optical profilometers. The micro-hardness and bond strength of both (17-4PH-30%WC-Co and 17-4PH-30%Cr3C2) coatings are compared. The test results revealed that at all temperatures and loads, 17-4PH-30%WC-Co coating shows better wear resistance and lower friction coefficient than the 17-4PH-30%Cr3C2 coating. The significant influence of the tribo-oxide layer at high temperatures, which contributed to decreasing wear rate and coefficient of friction, was premeditated. © 2023, International Institute of Welding.