Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Synthesis and characterization of zinc oxide incorporated iron borate glass-ceramic(Elsevier Ltd, 2019) Ramteke, R.; Kumari, K.; Bhattacharya, S.; Rahman, M.R.Here, zinc oxide (ZnO) incorporated iron borate (Fe3BO6) glass-ceramics have been synthesized using the traditional melt-quenching technique, and the role of ZnO has been investigated. X-ray diffraction (XRD) and scanning electron microscopy (SEM) reveals that the prepared samples have a single crystalline phase and crystalline nanostructures, respectively. The orthorhombic crystal structure has been retained without the formation of a new crystalline phase. The addition of ZnO is found to distort the Fe3BO6 lattice by substituting Zn2+ in the Fe3+ sites, with the formation of ZnO6 structural units as revealed by Fourier transform infrared spectroscopy (FTIR). FTIR and Raman spectroscopy conducted to study the structure of glass-ceramic, have also revealed the formation of other structural units like ZnO4, BO3, BO4, and FeO6 in the system. Surface analysis conducted by X-ray photoelectron spectroscopy (XPS) reveals that the addition of ZnO diminishes the formation of surface B2O3 layer which forms over the Fe3BO6 phase in the Fe3BO6 iron borate glass-ceramic system. ZnO addition has also shown a remarkable difference in the volume of the crystallization in the system, thereby paving the way for controlled crystallization in the iron borate glass-ceramic system. The controlled crystallization was achieved through additive content, retaining the iron borate (Fe3BO6) glass-ceramic system without the evolution of any secondary phases even with large additive concentrations up to 10 mol%. © 2019 Elsevier B.V.Item Flexible Electromagnetic Shielding Material Using Multi-Walled Carbon Nanotube Coated Cotton Fabric(Institute of Electrical and Electronics Engineers Inc., 2022) Arun Kumar, D.S.; Tharehalli Rajanna, T.R.; Kandasamy, K.; Bhat Panemangalore, P.; Rahman, M.R.The present work focuses on the development of cotton fabric with multi-walled carbon nanotube coating (CMC) through a dip and dry process. The influence of multi-walled carbon nanotubes (MWCNTs) concentration on transmission, reflection, and absorption properties, which leads to an estimation of electromagnetic interference (EMI) shielding, was also studied. The merits of MWCNTs coating on the cotton fabric were evaluated using field-emission scanning electron microscopy (FESEM), thermogravimetric analysis (TGA), and surface resistivity. The Fourier transform infrared (FTIR) spectroscopy result supports the bonding between MWCNTs and cotton fabric. The significant increase of 98.9% of EMI shielding for the highest MWCNTs weight percentage (22.23 wt%) was attributed due to the well-interconnected network of MWCNTs. The shielding mechanism in the high wt% MWCNTs samples is dominated by both reflection and absorption properties. © 2011-2012 IEEE.Item A study on solubility of bismuth cations in nickel cobalt ferrite nanoparticles and their influence on dielectric and magnetic properties(Elsevier Ltd, 2023) Patil, S.; Meti, S.; Kanavi, P.S.; Bhajantri, R.F.; Anandalli, M.; Mondal, R.; Karmakar, S.; Muhiuddin, M.; Rahman, M.R.; Kumar, B.C.; Hegde, B.G.In this work, a low temperature (∼600 °C) solution combustion technique is employed for the synthesis of Ni0.5Co0.5BixFe2-xO4 (NCBFO, where x = 0.0, 0.05, 0.1, 0.15, & 0.2) nanoparticles with crystallite size variation of 17–22 nm. The X-ray diffraction (XRD) technique is used to confirm the formation of cubic spinel phase of Bi3+ doped (for x ≤ 0.05 samples) nickel–cobalt ferrite (NCFO) nanoparticles. The increase in bismuth substitution (x > 0.05) results in the formation of the Bi2O3 along with the NCFO structure, which results in the reduction of binding energy and is confirmed by the XRD and X-ray photoelectron spectroscopy (XPS) techniques. From the Raman spectra, the change in the intensities of the peaks is observed due to the variation of Bi3+ in NCFO matrix. Due to increasing cation concentration and electronegativity, the FTIR absorption band shifts toward the lower wave numbers. Dielectric measurements were carried out to examine the charge transport behavior and electric conduction mechanism. The FESEM images shows the non-magnetic bismuth atoms are diffused into the NCFO nanoparticles. From the vibrating sample magnetometer (VSM) analysis, it is observed that saturation magnetization, remanent magnetization, coercivity and squareness ratio are found to be maximum for x = 0.15 NCBFO sample. The high coercivity (Hc = 916.8 Oe) for the x = 0.15 sample indicates the hard ferromagnetic behaviour of the samples. © 2023 Elsevier B.V.Item Flexible and cost effective CNT coated cotton fabric for CO gas sensing application(Elsevier B.V., 2023) D.s, A.K.; Chauhan, S.S.; Krishnamoorthy, K.; P, D.B.; Bharathi, K.D.; Ravikumar, A.; Rahman, M.R.In this paper, a low-cost and room temperature flexible carbon monoxide (CO) gas sensor is presented using multi-walled carbon nanotubes coated cotton fabric. A dip and drying method is used to fabricate a lightweight, and high-performance fabric based CO gas sensor using different concentrations of multi-walled carbon nanotubes (MWCNTs). Transmission electron microscopy (TEM) is utilized for examining the deagglomeration of MWCNTs in the presence of a sufficient amount of surfactant. The field-emission scanning electron microscopy (FESEM) is used to evaluate the formation of a uniform network of MWCNTs on the cotton fabric. Fourier transform infrared (FTIR) spectroscopy is used to confirm the presence of functional groups which plays an important role in CO gas sensing. The fabricated cotton fabric coated with MWCNTs (CCM) sensors are tested with different concentrations of CO gas ranging from 25 ppm to 100 ppm at room temperature. It is found that in comparison to all other sensors, the CCM sensor coated with the higher concentration of MWCNTs (0.5 mg/ml) shows a maximum response of 9.11 % at 25 ppm and 15.2 % at 100 ppm concentration of CO gas respectively. The CCM 4 sensor shows the fastest response and recovery within 49s for 25–100 ppm of CO gas. Moreover, the fabricated CCM sensor exhibited good repeatability, reproducibility, and selectivity. These sensors are suitable for low-cost smart textile applications. © 2023 Elsevier B.V.Item Synthesis and characterization of N-doped reduced graphene oxide for the supercapacitor application(Springer, 2025) Moodakare, R.; Sahoo, B.; Bharadishettar, N.; Rahman, M.R.; Muhiuddin, M.; Udaya Bhat, K.In this work, N-rGO is synthesized as a material for the electrode of supercapacitors using a single-stage hydrothermal process. Ammonia functions as a nitrogen source and a reducing agent, significantly enhancing its electrochemical properties. X-ray diffractometry (XRD), Raman spectroscopy, field emission gun scanning electron microscopy (FESEM), and FT-IR (Fourier-transform infrared spectroscopy) were employed for characterization of as-prepared N-rGO electrodes. The XRD plot evidences the successful reduction of as-received GO to as-prepared N-rGO. The FESEM micrograph displays the formation of highly porous and multi-layered N-rGO, showcasing significant structural characteristics. The nitrogen atoms are successfully incorporated into the resulting material (N-rGO) and have been verified through EDS and FT-IR spectroscopy studies. The specific capacitance of N-rGO reaches 107 Fg?1 at 0.5 Ag?1 in a 0.5 M H2SO4 aqueous electrolyte solution. The electrodes showed exceptional cyclic performance, maintaining approximately 130% capacitance after 10,000 cycles and delivering steady Coulombic efficiency. The material's porous structure and nitrogen doping create abundant active sites, facilitating electrolyte ion migration and producing exceptional capacitive performance. The electrochemical impedance spectroscopy study revealed that the N-rGO exhibited a distinctive capacitive behavior. The synthesized N-rGO offers excellent potential for an efficient energy storage application due to its simple, cost-effective, and eco-friendly approach. © The Author(s), under exclusive licence to Springer Science+Business Media, LLC, part of Springer Nature 2025.