Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
5 results
Search Results
Item Flexible Electromagnetic Shielding Material Using Multi-Walled Carbon Nanotube Coated Cotton Fabric(Institute of Electrical and Electronics Engineers Inc., 2022) Arun Kumar, D.S.; Tharehalli Rajanna, T.R.; Kandasamy, K.; Bhat Panemangalore, P.; Rahman, M.R.The present work focuses on the development of cotton fabric with multi-walled carbon nanotube coating (CMC) through a dip and dry process. The influence of multi-walled carbon nanotubes (MWCNTs) concentration on transmission, reflection, and absorption properties, which leads to an estimation of electromagnetic interference (EMI) shielding, was also studied. The merits of MWCNTs coating on the cotton fabric were evaluated using field-emission scanning electron microscopy (FESEM), thermogravimetric analysis (TGA), and surface resistivity. The Fourier transform infrared (FTIR) spectroscopy result supports the bonding between MWCNTs and cotton fabric. The significant increase of 98.9% of EMI shielding for the highest MWCNTs weight percentage (22.23 wt%) was attributed due to the well-interconnected network of MWCNTs. The shielding mechanism in the high wt% MWCNTs samples is dominated by both reflection and absorption properties. © 2011-2012 IEEE.Item A study on magnetorheological and sedimentation properties of soft magnetic Fe58Ni42 particles(Elsevier B.V., 2022) Aruna, M.N.; Rahman, M.R.; Joladarashi, S.; Kumara, H.; Meena, S.S.; Sarkar, D.; Umesh, C.K.In this study, the samples with two volume fractions (ϕ) of Fe58Ni42 (permalloy) i.e. (ϕ1 = 25 and ϕ2 = 30 %) were used as magnetic particles, silicone oil as a carrier fluid, and aluminium disterate as an additive. As received Fe58Ni42 particles surface morphology and composition of the Fe58Ni42 were investigated using field emission scanning electron microscopy (FESEM) coupled with energy dispersive spectroscopy (EDS), respectively. The X-ray Diffraction (XRD) structural information analysis confirmed Fe58Ni42 particles have a face-centered cubic phase, corresponding with the result of the high resolution transmission electron microscopy (HRTEM) characterization technique. The magnetorheological properties were tested via rotational rheometer at four different magnetic field strengths. The results show that sample PMRF-30 has a maximum shear stress, shear viscosity, and dynamic modulus greater than the PMRF-25 sample. In addition, experimental shear stress flow curves are well fitted with Herschel-Bulkley rather than Bingham and Casson rheological models. The permalloy based magnetorheological fluid (PMRF) samples were prepared with a 25 % volume fraction and a 30 % volume fraction of permalloy particles with a sample abbreviation of PMRF-25 and PMRF-30, respectively. Furthermore, the sedimentation stability of suspensions of both the samples was observed using visual inspection. This method result shows the sedimentation ratio with respect to time of 72 h was 31 % and 29 %, respectively. © 2022 Elsevier B.V.Item Flexible and cost effective CNT coated cotton fabric for CO gas sensing application(Elsevier B.V., 2023) D.s, A.K.; Chauhan, S.S.; Krishnamoorthy, K.; P, D.B.; Bharathi, K.D.; Ravikumar, A.; Rahman, M.R.In this paper, a low-cost and room temperature flexible carbon monoxide (CO) gas sensor is presented using multi-walled carbon nanotubes coated cotton fabric. A dip and drying method is used to fabricate a lightweight, and high-performance fabric based CO gas sensor using different concentrations of multi-walled carbon nanotubes (MWCNTs). Transmission electron microscopy (TEM) is utilized for examining the deagglomeration of MWCNTs in the presence of a sufficient amount of surfactant. The field-emission scanning electron microscopy (FESEM) is used to evaluate the formation of a uniform network of MWCNTs on the cotton fabric. Fourier transform infrared (FTIR) spectroscopy is used to confirm the presence of functional groups which plays an important role in CO gas sensing. The fabricated cotton fabric coated with MWCNTs (CCM) sensors are tested with different concentrations of CO gas ranging from 25 ppm to 100 ppm at room temperature. It is found that in comparison to all other sensors, the CCM sensor coated with the higher concentration of MWCNTs (0.5 mg/ml) shows a maximum response of 9.11 % at 25 ppm and 15.2 % at 100 ppm concentration of CO gas respectively. The CCM 4 sensor shows the fastest response and recovery within 49s for 25–100 ppm of CO gas. Moreover, the fabricated CCM sensor exhibited good repeatability, reproducibility, and selectivity. These sensors are suitable for low-cost smart textile applications. © 2023 Elsevier B.V.Item Investigation of structural, thermal, magnetic, and dielectric properties of Yb+3 doped nickel cobalt ferrite nanomaterial for electro-magnetic applications(Springer, 2024) Patil, S.; Meti, S.; Anandalli, M.; Badiger, H.; Bhajantri, R.F.; Pratheek, L.; Muhiuddin, M.; Rahman, M.R.; Hegde, B.G.Herein, we report the synthesis of ytterbium (Yb) (with concentration x = 0.01, 0.015, 0.02, 0.025 and 0.03) doped in to nickel cobalt ferrite (NCYFO: YbxNi0.5Co0.5Fe2-xO4) nanoparticles at temperature 500 °C with phase pure spinel using solution combustion technique. The phase purity and effect of doping on NCYFO complex oxide on structural, thermal, magnetic and dielectric properties have been determined by various characterization techniques. The FTIR data reveal that strong metal oxide linkages can be observed in the tetrahedral and octahedral sites at wavenumbers 460 to 410 cm−1 and 595 to 540 cm−1. The X-ray diffraction (XRD) studies confirmed the spinel structure. The crystallite sizes and lattice parameters were estimated to be in the range of 31 to 22 nm and 8.32 to 8.35 Å, respectively. The X-ray photoelectron spectroscopy (XPS) study confirmed that the increase in Yb concentration results in accumulation of Yb in the grain boundaries of NCYFO in the form of Yb2O3. The thermal stability of nanoparticles were investigated using TGA/DSC method. Transmission Electron microscopy (TEM) studies and Field emission scanning electron microscopy (FESEM) used to study the particle size distribution and elemental composition within the nanomaterial. In addition, the dielectric properties, such as, dielectric constant and dielectric loss were investigated for all the NCYFO nanomaterial. The saturation magnetization of the NCYFO is determined using vibrating sample magnetometer (VSM) analysis and is maximum for x = 0.03 (Ms = 97.56 emu/g) sample. The high magnetic behaviour and better dielectric properties of the NCYFO nanomaterials are suitable for electro-magnetic applications. © The Author(s), under exclusive licence to Springer Science+Business Media, LLC, part of Springer Nature 2024.Item Synthesis and characterization of N-doped reduced graphene oxide for the supercapacitor application(Springer, 2025) Moodakare, R.; Sahoo, B.; Bharadishettar, N.; Rahman, M.R.; Muhiuddin, M.; Udaya Bhat, K.In this work, N-rGO is synthesized as a material for the electrode of supercapacitors using a single-stage hydrothermal process. Ammonia functions as a nitrogen source and a reducing agent, significantly enhancing its electrochemical properties. X-ray diffractometry (XRD), Raman spectroscopy, field emission gun scanning electron microscopy (FESEM), and FT-IR (Fourier-transform infrared spectroscopy) were employed for characterization of as-prepared N-rGO electrodes. The XRD plot evidences the successful reduction of as-received GO to as-prepared N-rGO. The FESEM micrograph displays the formation of highly porous and multi-layered N-rGO, showcasing significant structural characteristics. The nitrogen atoms are successfully incorporated into the resulting material (N-rGO) and have been verified through EDS and FT-IR spectroscopy studies. The specific capacitance of N-rGO reaches 107 Fg?1 at 0.5 Ag?1 in a 0.5 M H2SO4 aqueous electrolyte solution. The electrodes showed exceptional cyclic performance, maintaining approximately 130% capacitance after 10,000 cycles and delivering steady Coulombic efficiency. The material's porous structure and nitrogen doping create abundant active sites, facilitating electrolyte ion migration and producing exceptional capacitive performance. The electrochemical impedance spectroscopy study revealed that the N-rGO exhibited a distinctive capacitive behavior. The synthesized N-rGO offers excellent potential for an efficient energy storage application due to its simple, cost-effective, and eco-friendly approach. © The Author(s), under exclusive licence to Springer Science+Business Media, LLC, part of Springer Nature 2025.