Cu-44Ni-5Cr alloy has been subjected to thermomechanical treatment which consisted of plastic deformation of as-quenched material by 50, 65 and 80% reduction in thickness followed by ageing in the interval of 500 to 650 °C for various durations of time. Progress in age-hardening was studied by means of hardness measurement and X-ray diffraction studies. The wavelength of composition modulation and strain amplitude were measured. It was found that age-hardening was a result of interaction between spinodal decomposition and recovery processes. Prior deformation was found to enhance the kinetics of both spinodal decomposition and coarsening. It was concluded that this resulted from increased vacancy concentration and increased coherency strain in the cold-worked material. © 1994 Chapman & Hall.
(Kluwer Academic Publishers, Effect of thermomechanical treatment on the phase transformation in Cu-44Ni-5Cr alloy) Raghavendra Bhat, R.; Prasad Rao, P.
1994
Progress in spinodal decomposition of a Cu-32Ni-2Cr alloy subjected to quench?age and quench?work?age treatments have been studied through hardness measurements as well as by X-ray diffraction techniques. It is found that recovery processes occur during early stages of aging which are interpreted in terms of the migration of matrix dislocations to interfaces. The kinetics of spinodal decomposition is found to be enhanced by prior deformation. Thermomechanical treatment results in a substantial increase in strength.
(Publ by Carl Hanser Verlag GmbH & Co, Thermomechanical treatment of spinodal Cu-32Ni-2Cr alloy) Bhat, R.Raghavendra; Prasad Rao, P.
1994
Rotating bending fatigue tests were carried out on austempered ductile iron containing 1.5 wt% nickel and 0.3 wt% molybdenum. The ductile iron was austenitized at 900 or 1050 °C and then austempered at 280 or 400 °C for different lengths of time to obtain different microstructures. The fatigue strength was correlated with the amount of retained austenite and its carbon content, which were both determined by X-ray diffraction technique. While the tensile strength decreased with increasing retained austenite content, the fatigue strength was found to increase. Carbide precipitation was found to be detrimental to fatigue strength. Lower austenitizing temperature resulted in better fatigue strength. © 1994 Chapman & Hall.
(Kluwer Academic Publishers, Effect of microstructure on the fatigue strength of an austempered ductile iron) Shanmugam, P.; Prasad Rao, P.; Rajendra Udupa, K.; Venkataraman, N.
1994
An investigation was carried out to examine the influence of chromium content on the plane strain fracture toughness of austempered ductile iron (ADI). ADIs containing 0, 0.3 and 0.5 wt.% chromium were austempered over a range of temperatures to produce different microstructures. The microstructures were characterized by optical microscopy and X-ray diffraction. Plane strain fracture toughness of all these materials was determined and correlated with microstructure and chromium content. The chromium content was found to influence the fracture toughness through its influence on the processing window. Since the chromium addition shifts the processing window to shorter durations, the higher chromium alloys at higher austempering temperatures tend to fall outside of the processing window, resulting in less than optimum microstructure and inferior fracture toughness. A small chromium addition of 0.3 wt.% was found to be beneficial for the fracture toughness of ADI. © 2002 Elsevier Science B.V. All rights reserved.
(Elsevier BV, Investigations on the fracture toughness of austempered ductile iron alloyed with chromium) Prasad Rao, P.; Putatunda, S.K.
2003

Privacy policy
End User Agreement
Send Feedback

COAR Notify