Faculty Publications

Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736

Publications by NITK Faculty

Browse

Filters

20232

Settings

Author: search.filters.author.Prasad, C.D.Subject: search.filters.subject.Air jet

Search Results

Now showing 1 - 2 of 2
  • No Thumbnail Available
    Item
    High temperature erosion performance of NiCrAlY/Cr2O3/YSZ plasma spray coatings
    (Taylor and Francis Ltd., 2023) Reddy, G.M.S.; Prasad, C.D.; Patil, P.; Shetty, G.; Naresh, N.; Ramesh, M.R.
    The current investigation's objective was to assess the air jet erosion tester's ability to measure the erosive behaviour of plasma sprayed coatings on titanium-15 alloy. 65% NiCrAlY, 30% Cr2O3, and 5% YSZ make up the coating's chemical composition. A study of microstructure and phases was carried out. Microhardness and adhesive strength have both been measured in this work. With impact angles of 30° and 90° at 300°C, 500°C, and 700°C, Al2O3 erodent was utilised in a solid particle erosion test. An optical profilometer was used to calculate the erosion volume loss. The coating erosion resistance was found to be higher than the substrate sample for the test temperature that was employed, and this was more obvious at higher impact angles and higher temperatures The ductile character of the coating is seen in the contour of the deteriorated coating surface. © 2023 Institute of Materials Finishing Published by Taylor & Francis on behalf of the Institute.
  • No Thumbnail Available
    Item
    Investigation of the effect of NiCrAlY/Cr2O3/YSZ plasma coatings on erosion performance of MDN 420 steel at high temperature
    (Inderscience Publishers, 2023) Reddy, G.M.S.; Prasad, C.D.; Patil, P.; Shetty, G.K.; Kakur, N.; Ramesh, M.R.
    The purpose of the current study was to use an air jet erosion tester to examine the erosive behaviour of plasma sprayed coatings on MDN-420 that were composed of 70% NiCrAlY, 25% Cr2O3, and 5% YSZ. Microstructure and phase studies were performed. Measurements were made on the microhardness and adhesion strength. Al2O3 erodent was used in a solid particle erosion test with impact angles of 30° and 90° at 300°C, 500°C, and 700°C. The erosion volume loss was measured using an optical profilometer. For the test temperature used, it was found that the coating’s erosion resistance was greater than that of the substrate and that it was more pronounced at higher impact angles and higher temperatures. The shape of the degraded coating surface reflects the coating’s ductile nature. © © 2023 Inderscience Enterprises Ltd.