Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
6 results
Search Results
Item The catalytic effect of chromium-doped ceria-praseodymium on soot oxidation activity and its kinetics(Springer, 2024) Patil, S.S.; Prasad Dasari, H.P.Soot generated from the partial combustion of diesel significantly contributes to air pollution, and catalytic oxidation is currently an effective method for removing diesel soot particles. The chromium-doped ceria-praseodymium (Cr-CP) catalyst system is synthesized via solution combustion synthesis and evaluated for soot oxidation activity, with a subsequent kinetics study conducted. The XRD analysis of the catalysts indicated a decrease in crystallite size and increased lattice strain and reactive facet ratios for all Cr-doped CP samples. Raman analysis verified the existence of oxygen vacancy peaks in all chromium-doped CP catalysts. X-ray photoelectron spectroscopy (XPS) revealed the presence of adsorbed H2O or molecular water peaks in the O1s spectra for the 5 Cr-CP catalyst, which also exhibited a high concentration of surface Cr3+ ions. Thermogravimetric analysis (TGA) of soot oxidation indicated that 5 Cr-CP exhibited a superior T50 of 393 ± 2 °C, mostly attributed to the presence of reducible surface Cr3+ ion species. Kinetic analysis was performed on all Cr-doped CP catalysts to assess the kinetic triplets: activation energy, pre-exponential factor, and reaction model. The activation energy was low (87 kJ mol−1, Ozawa method) for 15 Cr-CP, while the pre-exponential factor was higher for 5 Cr-CP (7.39 × 1010 min−1). The Cr-CP catalyst system adhered to a power law, indicating a phase boundary-controlled reaction characterized by nucleation and growth mechanisms. The consistency between experimental and calculated curves confirmed that the developed catalysts adhered to the Avrami-Erofeev equation (Am) or the nucleation and growth model. Graphical Abstract: (Figure presented.) © The Author(s), under exclusive licence to Springer-Verlag GmbH Germany, part of Springer Nature 2024.Item An investigation on copper-loaded ceria-praseodymium catalysts for soot oxidation activity and its kinetics(Springer Science and Business Media Deutschland GmbH, 2024) Patil, S.S.; Prasad Dasari, H.P.The Cu-loaded Ce-Pr catalyst series was successfully developed to study their performance on soot oxidation activity and its kinetic behavior. The doped samples showed a similar trend for cubic fluorite structure except for CuO, which possessed a monoclinic structure from the XRD analysis. Facet ratios [{100}/{111} and {110}/{111}] for the reactive planes were calculated from XRD spectra; the ratio was high for the 5 Cu-CP catalysts. The oxygen vacancy peaks were noticed from Raman spectra for the doped samples. 5 Cu-CP displayed the better catalytic activity of T50 = 402 °C, which may be attributed to high reactive planes and better reducibility. The addition of Cu showed a slight enhancement in catalytic activity compared to CP and pure Ce. The kinetic triplets were evaluated: the activation energy (Ea), pre-exponential factor (A), and the reaction model. Pure Ce displayed the lowest Ea and A values, whereas pure Cu showed high Ea and A values by all the methods. Graphical abstract: (Figure presented.) © The Author(s) under exclusive licence to Associação Brasileira de Engenharia Química 2023.Item Ceria-Terbium-based electrospun nanofiber catalysts for soot oxidation activity and its kinetics(Taiwan Institute of Chemical Engineers, 2024) Patil, S.S.; Kumar, R.; Prasad Dasari, H.P.Background: Ceria-based materials have an excellent potential to be catalysts for catalytic three-way converters in the automobile industry. Developing Ceria-based nanofiber catalysts can be a significant approach for further exploring the application of these materials in automobile industries. Methods: In this study, Ag, Cu, or Co doped Ceria–Terbium nanofibers were synthesized using the electrospinning technique. The obtained nanofiber catalysts were characterized using FE-SEM, XRD, FT-Raman Spectroscopy, and BET-BJH analysis and tested for soot oxidation activity and its kinetics. Significant findings: FE-SEM examination reveals that the obtained nanofibers have a diameter ranging from around 100 to 600 nm. CeTbCo nanofibers exhibited a reduced particle size and enhanced pore formation. The XRD investigation revealed that all the nanofibers displayed a face-centered fluorite structure of CeO2. In Raman spectroscopy analysis, CeTbCo nanofibes showed the emergence of a secondary Co3O4 phase. The CeTbCo nanofiber catalyst showed better SBET (specific surface area) (66 m2/g) and average pore size (12.08 nm) and total pore volume (0.223 cc/g)), better soot oxidation activity (T50 = 347 ℃) than other nanofiber catalysts. The CeTbCo nanofiber catalyst exhibited an activation energy of 132 kJ mol−1 and a pre-exponential factor (ln (A)) of 25.63 min−1. © 2024 Taiwan Institute of Chemical EngineersItem Soot oxidation activity and kinetics of Ce0.9M0.1O2-δ (M = Cs, Mg, Ca) catalysts: Impact of Cs doping in ceria and impact of nanorods on catalytic activity(Institution of Chemical Engineers, 2024) Nayak, A.S.; Patil, S.S.; Prasad Dasari, H.P.; Telaginatot, D.; Rynjah, M.; Cheruku, S.Solution combustion method is used to synthesize Ce0.9M0.1O2-δ (M = Cs, Mg, Ca) catalysts and calcined at 600 °C/5 h. XRD and Raman Spectroscopy Analyses the chemical structure, the phases observed, and the oxygen defects in the synthesized catalysts. A cubic fluorite structure of CeO2 has been noticed for all the catalysts from XRD and Raman Spectroscopy analyses. FE-SEM micrographs are used to analyze the morphology of the Ce0.9M0.1O2-δ (M = Cs, Mg, Ca) catalysts. Ce0.9Cs0.1O2-δ catalyst shows the presence of nanorods (diameter: 63 nm), which are not seen in the other catalysts. The redox and surface properties of the synthesized catalysts are tested by H2-Temperature Programmed Reduction (H2-TPR) and O2-Temperature Programmed Desorption (O2-TPD), respectively. The Ce0.9Cs0.1O2-δ catalyst shows the greatest degree of reducibility from TPR studies and for the Ce0.9Cs0.1O2-δ catalyst, the oxygen species evolved from the O2-TPD studies are also the highest. Thermogravimetric Analysis (TGA) has been used to carry the soot oxidation activity of the developed catalysts. Soot oxidation kinetic studies have been conducted at different heating rates (5, 10, and 15 °C/min) for the catalysts. The kinetic triplets for the developed catalysts have been obtained, and rate plots ([Formula presented] vs. temperature) and Arrhenius plots (ln(k) vs. [Formula presented]) have been developed for the catalysts. From the soot oxidation and kinetic studies for the developed catalysts, Ce0.9Cs0.1O2-δ shows better soot oxidation activity (T50 = 372 °C) than the other two catalysts, while Ce0.9Mg0.1O2-δ (T50 = 556 °C) shows the lowest soot oxidation activity. All the catalysts follow a non-integral exponential model for soot oxidation, and the Ce0.9Cs0.1O2-δ catalyst has the lowest activation energy. © 2024 Institution of Chemical EngineersItem Study of CO oxidation activity of NiO-PDC and NiO-YSZ catalysts coated on alumina wash-coated honeycomb cordierite monolith(Springer Science and Business Media Deutschland GmbH, 2025) Wagay, A.A.; Shourya, A.; Patil, S.S.; Shirasangi, R.; Prasad Dasari, H.P.In this study, the EDTA-Citrate method was employed to synthesize NiO-PDC (NPC) and NiO-YSZ (NYZ) powder catalysts in nanostructured form. Subsequently, the catalysts were slurry dip-coated onto monolith cordierite substrates with alumina, using a one-step coating approach, and their CO oxidation activity was tested. The coating was achieved by first mixing the catalyst with the alumina suspension to prepare a homogeneous slurry, which was then used for dip coating onto the monolith. The adherence test was performed on the coated monolith to evaluate the mechanical stability of the catalyst-alumina composite layer. The coating was visually confirmed through optical imaging. The remaining powders (after coating) were then subjected to BET surface area, XRD, Raman spectroscopy, H2 TPR and O2 TPD analysis for characterization. Raman spectra showed that NPC exhibited higher oxygen vacancies than NYZ. H2 TPR and O2 TPD provided better evidence of the reduction potential and O2 desorption of NPC respectively. NPC/cord demonstrated the highest catalytic activity (T50 = 165 °C) compared to NYZ/cord (T50 = 215 °C) and bare cordierite (T50 = 777 °C), which is attributed to its better redox properties and higher oxygen vacancies. The effect of flow rate and heating rate on CO oxidation was studied on NPC/cord and NYZ/cord. The long-term stability of the NPC/cord and NYZ/cord were tested through 5-h and 50-h isothermal studies. © The Author(s) under exclusive licence to Associação Brasileira de Engenharia Química 2025.Item Diesel soot oxidation over Mn–Pr–Ce oxide catalysts: structural changes and the impact of Mn doping(Royal Society of Chemistry, 2025) Patil, S.S.; Prasad Dasari, H.P.; Shirasangi, R.; Harshini, H.The soot oxidation activity of manganese-doped ceria-praseodymium catalysts, synthesized via solution combustion synthesis, was evaluated. The analyses performed with XRD and Raman spectroscopy indicated that the Mn-doped CP catalysts displayed the typical fluorite structure of CeO2. The addition of Mn to CP led to a reduction in crystallite size from 14 nm to below 10 nm. The F2g Raman active mode of fluorite-structured Ce and the oxygen vacancies resulting from the addition of Mn and Pr (bands B 560 cm–1 to 580 cm–1) were consistently observed across all Mn-doped CP catalysts. 15 and 20 Mn-CP exhibited an additional secondary phase identified as Mn2O3. The analysis of BET surface area and BJH pore size revealed that the Mn-doped CP catalysts exhibited both micro and mesoporous characteristics. The H2-TPR and O2-TPD profiles indicated enhanced reducibility resulting from the incorporation of Mn and Pr into CeO2-doped catalysts. The improved T50 (365 ± 1 1C) for the 5 Mn-CP catalytic system is primarily due to its increased specific surface area of 45 m2 g–1 and the presence of active surface adsorbed oxygen species identified in the XPS and O2-TPD studies. 5 Mn-CP exhibited the lowest activation energy value compared to all other Mn-doped catalysts. © 2025 The Author(s)