Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
3 results
Search Results
Item Hydrodynamic performance of wave energy converter integrated with pile restrained floating structure near a partially reflecting seawall(Elsevier Ltd, 2023) Patil, S.B.; Karmakar, D.The integration of a Wave Energy Converter (WEC) with a Pile-Restrained Rectangular Floating Breakwater (PRFB) in the presence of a partially reflecting vertical seawall is analysed to enhance the hydrodynamic performance and WEC efficiency of the integrated breakwater-WEC device based on small amplitude wave theory using the Boundary Element Method (BEM). The rectangular floating breakwater is designed to have heave motion with a pile-restrained floating structure placed in a position to attenuate the incoming wave in the transmitted region and the linear power take-off (PTO) damping is employed to calculate the absorbed power. The study is performed to understand the effectiveness of wave energy conversion and its hydrodynamic performance due to changes in the seawall's porosity, relative structural width, relative structural draft, wave energy conversion power take-off damping coefficients, and the relative gap of the WEC integrated with PRFB from the seawall. The study demonstrated that in the presence of a fully reflecting seawall, the wave energy extraction is enhanced for the integrated WEC system without compromising the defined threshold wave reflection coefficient but at the expense of a constrained range of wavenumbers that correspond near the system's fundamental natural frequency. Moreover, the capture width ratio is noted to be higher for relatively smaller structural drafts, while the wave reflection coefficient shows precisely the reverse trend. However, under such circumstances, the integrated WEC system operates as a motion-trapping structure, especially when the reflection coefficient of the seawall, CR≥0.75. Thus, the present study will assist the designer in determining the appropriate degrees of efficiency of the WEC device without sacrificing hydrodynamic performance by fine-tuning the hybrid floating breakwater system's geometrical parameters. © 2023 Elsevier LtdItem Hydrodynamic performance of pile restrained U-shaped OWC device using boundary element method(Elsevier Ltd, 2024) Muduli, R.; Patil, S.B.; Karmakar, D.The hydrodynamic performance of a pile-restrained U-shaped Oscillating Water Column (U-OWC) device under the action of normal incident waves is analysed using the Boundary Element Method (BEM). The hydrodynamic parameters, such as the radiation susceptance and conductance coefficients and hydrodynamic efficiency, are analysed for various cases of different structural parameters of U-OWC. It is observed that the theoretical maximum efficiency can be achieved for a wide range of wavenumbers by appropriate tweaking and optimisation of the device geometry. The resonance enables the device to reach the maximum possible efficiency and the phenomenon of obtaining the maximum efficiency of the final optimised geometry is achieved. The shorter length of draft of the device is chosen over longer draft considering the high construction cost as well as efficiency enhancement of the device, even though the longer draft is observed to perform marginally better in a narrow wave number range. The numerical investigation of the theoretical maximum efficiency is observed to be 100% whenever the μ (dimensionless radiation susceptance coefficient) crosses the zero mark. Consequently, the maximum theoretical efficiency is observed close to maximum whenever μ is close to zero. The final optimised geometry consisting of an inward inclined top wall configuration performs best but could be challenging in actual construction. Further, on inclining the bottom wall in the inwards or outward direction does not result in better performance than inclining only the top wall. The present study explores a novel concept of pile-restrained U-OWC kept near the surface and will be helpful in determining the best-performing geometry for the device. © 2023 Elsevier LtdItem Hydrodynamic performance of a hybrid floating breakwater-wave energy conversion system(SAGE Publications Ltd, 2025) Patil, S.B.; Karmakar, D.The study presents the hydrodynamic performance and wave energy conversion of a hybrid floating breakwater under the framework of small amplitude linear wave theory. The hybrid floating breakwater is composed of a partially liquid-filled rectangular-box type tank with built-in buoys connected to a Power Take-Off (PTO) (linear inductance generator) and is excited under regular wave conditions for (a) constrained roll motion, and (b) constrained surge, heave, and roll motion. The Boundary Element Method (BEM) is employed with the assumption of modest sloshing in the tank of the hybrid floating breakwater to estimate the hydrodynamic efficiency of the hybrid floating breakwater. Further, the experimental investigation on the Wave Energy Converter (WEC) capabilities and the hydrodynamic coefficients (wave reflection and transmission coefficients) are estimated for the excitation frequencies corresponding to nondimensional wavenumber. The present study reveals that the hybrid concept improves wave attenuation performance by 20%–35% compared to conventional floating breakwaters by increasing wave attenuation, damping and stabilizing the wave transmission coefficient (Formula presented) within (Formula presented). The experimental investigation shows that hybrid floating breakwater attaints its floating stability for the depth 15 – 25% of partially filled fluid for which the proposed design as floating breakwater as well as WEC system is achieved for a wide range of excitation frequencies. Furthermore, the hybrid floating breakwater functions as a barrier which is noted to be capable of significantly attenuating incoming progressive waves below the predetermined threshold values of wave attenuation characteristics, in addition to converting wave energy. © IMechE 2025. This article is distributed under the terms of the Creative Commons Attribution 4.0 License (https://creativecommons.org/licenses/by/4.0/) which permits any use, reproduction and distribution of the work without further permission provided the original work is attributed as specified on the SAGE and Open Access page (https://us.sagepub.com/en-us/nam/open-access-at-sage).