Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
7 results
Search Results
Item Synthesis and desalination performance of Ar+-N+ irradiated polysulfone based new NF membrane(2011) Hegde, C.; Isloor, A.M.; Padaki, M.; Wanichapichart, P.; Liangdeng, Y.In the last few years, membrane technology has gained more attention from polymer chemists throughout the globe. Nowadays, surface modification of membrane is very useful in biotechnology and food science. In the present investigation, we have synthesized polysulfone based composite nanofiltration (NF) membranes, and characterized these membranes by FT-IR, SEM and membrane performance studies. Surface plasma treatment was carried out by irradiation with argon and nitrogen beams in suitable conditions. It was observed that nitrogen beam caused surface roughness that was more severe than the Ar beam. After irradiation, water contact angle was slightly increased. For pure water permeability, flux increased linearly with the operating pressure. However, for the salt solution, the flux was decreased marginally and salt rejection increased after irradiation due to surface modification. The modification effect was characterized in terms of contact angle, AFM employed roughness measurement and dielectric property. It revealed that irradiated NF membranes showed higher salt rejection and lower flux as compared to the nonmodified membranes. Accordingly, the roughness of the membrane surface intensively affected the performance of RO membrane. © 2010 Elsevier B.V.Item Polysulfone/N-phthaloylchitosan novel composite membranes for salt rejection application(2011) Padaki, M.; Isloor, A.M.; Wanichapichart, P.N-phthaloylchitosan (CS) was synthesized by the reaction of chitosan with phthalic anhydride in dimethyl formamide. Different compositions of polysulfone (PSf) and N-phthaloylchitosan were used to prepare novel polysulfone/N-phthaloylchitosan (PSf/CS) composite membranes by phase inversion method. The composition ratios between the former and the latter were 80:20, 85:15, 90:10, and 95:5. Water flux results revealed that, PSf:CS 80:20 membrane is found to have greatest effective pore area while PSf:CS 95:05 membrane has the smallest value. The pore area is found to be larger with the increase in CS composition. In addition, its water swelling property increases with the increase of CS composition. Water flux results are in consistent with dielectric constant value. Use of known molecular weight of polyethylene glycol rejection study, revealed that, PSf:CS 95:05 membrane possessed the smallest pore size among these membranes. In conclusion, change of ratio between PSf and CS, considerably affects membrane pore size and hydrophilicity. For salt filtration, membrane PSf:CS 95:05 showed 93%, 76.11% and 70.12% rejection of MgSO4, Na2SO4, and NaCl, respectively. © 2011 Elsevier B.V.Item New polypropylene supported chitosan NF-membrane for desalination application(2011) Padaki, M.; Isloor, A.M.; Fernandes, J.; Prabhu, K.N.In the present study, a new NF membrane was prepared by coating chitosan on polypropylene fiber support, by the dissolution of chitosan in 2% acetic acid solution. The resulting membrane was characterized by thermo gravimetric analysis, water absorption, contact angle measurement and scanning electron microscopy. Prepared membrane showed two Tg peaks, one at ~90 °C that was due to chitosan and the other peak at ~170 °C that was corresponding to the supporting polypropylene membrane. The membrane showed a low swelling ratio at pH 7, 9, and 11 as compared with pH 5. The performance of the membrane was assessed out using dead end cell. Water flux was studied at different pressures. The salt rejection study was done using NaCl solution and the effect of pH on performance of the membrane was also examined. Newly prepared membrane showed improved water flux, and % of rejection is highest in acidic pH and lowest in basic pH. Hydrulic permeability coefficient and the dielectric constant confirms that the prepared membrane is nanofiltration membrane. © 2011 Elsevier B.V.Item New CPS-PPEES blend membranes for CaCl2 and NaCl rejection(Techno Press technop2@chollian.net, 2012) Hegde, C.; Isloor, A.M.; Padaki, M.; A.F., A.F.; Lau, L.W.Carboxylated polysulfone (CPS), poly (1,4-phenylene ether ethersulfone) (PPEES), membranes were prepared and used for the separation of NaCl and CaCl2 in efficient way with less energy consumption. In this work, nanofiltration and reverse osmosis membranes were employed to the salt rejection behavior of the different salt solutions. The influence of applied pressure (1-12 bar), on the membrane performance was assessed. In CM series of membranes, CM1 showed maximum of 97% water uptake and 36% water swelling, whereas, CM4 showed 75% water uptake and 28% water swelling. In RCM series, RCM1 showed 85% water uptake and 32% water swelling whereas, in RCM4 it was 68% for water uptake and 20% for water swelling. Conclusively reverse osmosis membranes gave better rejection whereas nanofiltration membrane showed enhanced flux. CM1 showed 58% of rejection with 12L/(m2h) flux and RCM1 showed 55% of rejection with 15L/(m2h) flux for 0.1wt.% NaCl solution. Whereas, in 0.1wt.% CaCl22 solution, membrane CM11 showed 78% of rejection with 12L/(m2h) flux and RCM1 showed 63% rejection with flux of 9L/(m2h).Item Synthesis, characterization and desalination study of novel PSAB and mPSAB blend membranes with Polysulfone (PSf)(2012) Padaki, M.; Isloor, A.M.; A.F., A.F.; Abdullah, M.S.The present paper describes the synthesis of poly sulphonyl amino benzamide (PSAB) and methyalated poly sulphonyl amino benzamide (mPSAB) polymer, using terephthalic acid chloride and substituted 4-amino-1-benzensulphonmide in N-methyl-. 2-pyrrolidone. Polymers were characterized by FT-IR, NMR and GPC. Polysulfone composite membranes were prepared using these novel poymers by DIPS (Diffusion Induced Phase Seperation) method. These composite membranes are useful for water purification with special emphasis on sea water desalination. Newly prepared membranes were studied for salt rejection, water flux, molecular weight cut off by PEG solution, effect of the pH on water swelling and salt rejection and flux decline was also studied. 30 to 70% of the salt rejection was observed in all membranes. Effect of the dilution on salt rejection was studied using different concentration of NaCl solution varying from 1000. ppm to 3500. ppm. All the membranes showed 80% rejection for PEG having 1000. Da molecular weight. Contact angle and water swelling was measured to determine hydrophilicity of the membrane. Water swelling and salt rejection in different pH was also studied. © 2012 Elsevier B.V.Item Preparation and characterization of polysulfone and modified poly isobutylene-alt-maleic anhydride blend NF membrane(2012) Ganesh, B.M.; Isloor, A.M.; Padaki, M.Recently nanofiltration (NF) is gaining more importance for water treatment. It is replacing the conventional method of water treatment due to advantages of NF membranes over RO system. In this work, we are discussing the preparation of NF membrane for desalination of sea water. We herein report the synthesis of polymer, by the reaction of p-amino benzoic acid (PABA) and poly isobutylene-alt-maleic anhydride (PIAM) and its blend membrane preparation with polysulfone (PSf). The new membranes were characterized by SEM images, surface wettability to investigate the hydrophilic nature of the membrane, water swelling, pure water flux, molecular weight cut-off and salt rejection of the membranes. The membranes showed nano size (<50nm) pores in SEM image, and the contact angle data revealed that membrane surface is moderately hydrophilic. Membrane with 70:30 (PSf:modified PIAM) composition has shown good salt rejection of 96% at 200kPa for 3500ppm of NaCl solution with a pure water flux of 38.36Lm -2h -1. © 2011 Elsevier B.V.Item Synthesis and performance characterization of PS-PPEES nanoporous membranes with nonwoven porous support(2013) Hegde, C.; Isloor, A.M.; Padaki, M.; Fun, H.-K.The present work describes about the synthesis and characterization of Polysulfone blend nanoporous membrane with nonwoven support. This Nonwoven support provides mechanical strength to membrane while filtration process and minimizes membrane fouling. Hence it helps in better membrane performance in terms of salt rejection, improved flux, thermal stability and fairly increases in proton conductivity. In this work we have used K.C.270 nonwoven material consisting of fine polyester fibers and has a thickness of below 110. ?m. © 2011.