Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
8 results
Search Results
Item Synthesis, characterization & impedance studies of some new nano filtration membranes(Trans Tech Publications Ltd ttp@transtec.ch, 2010) Padaki, M.; Hegde, C.; Isloor, A.M.In the recent years membrane technology has gained significant attention from polymer chemists all around the world due to their attractive features such as efficiency, low costs, low energy costs and as effective solutions to longstanding problems in the chemical industries. Membrane technologies have been widely applied in the separation of liquids and even gases. Many separation problems can be solved economically by nanofiltration alone or in combination with other separation processes. This study aimed to synthesize polysulfone based nanofiltration membranes using DIPS (diffusion induced phase separation) technique. Newly synthesized polymer membranes were subjected to Infra red spectral and water uptake studies. Membranes were also characterized using electrochemical spectroscopy for their proton conducting property. Their surface morphology is visualized by SEM. © (2010) Trans Tech Publications.Item Synthesis and desalination performance of Ar+-N+ irradiated polysulfone based new NF membrane(2011) Hegde, C.; Isloor, A.M.; Padaki, M.; Wanichapichart, P.; Liangdeng, Y.In the last few years, membrane technology has gained more attention from polymer chemists throughout the globe. Nowadays, surface modification of membrane is very useful in biotechnology and food science. In the present investigation, we have synthesized polysulfone based composite nanofiltration (NF) membranes, and characterized these membranes by FT-IR, SEM and membrane performance studies. Surface plasma treatment was carried out by irradiation with argon and nitrogen beams in suitable conditions. It was observed that nitrogen beam caused surface roughness that was more severe than the Ar beam. After irradiation, water contact angle was slightly increased. For pure water permeability, flux increased linearly with the operating pressure. However, for the salt solution, the flux was decreased marginally and salt rejection increased after irradiation due to surface modification. The modification effect was characterized in terms of contact angle, AFM employed roughness measurement and dielectric property. It revealed that irradiated NF membranes showed higher salt rejection and lower flux as compared to the nonmodified membranes. Accordingly, the roughness of the membrane surface intensively affected the performance of RO membrane. © 2010 Elsevier B.V.Item Conversion of microfiltration membrane into nanofiltration membrane by vapour phase deposition of aluminium for desalination application(2011) Padaki, M.; Isloor, A.M.; Nagaraja, K.K.; Nagaraja, H.S.; Pattabi, M.Preparation and modification of NF membrane are challenging aspects in research. In the present work, we have synthesised Polysulfone (PSf) microfiltration membrane and reduced the pore size to nano level by physical vapour deposition (PVD) of aluminium metal. Membrane pore size was reduced from micro pore to nano pore, which rejected 42.22% of NaCl from the solution with 164L/m2h. And also water permeation decreases from 1.10324-10-10 to the 9.141-10-12. The SEM and AFM pictures showed the surface modification and metal deposition in the pores. The performance of the membrane was studied by dead end flow cell using 3.5% of NaCl solution, in which PVD membrane showed 42.22% of rejection with 16.4L/m2h flux. Thermal analysis from DSC showed Tg of 265°C. Contact angle measurement, and water uptake were also reported. © 2011 Elsevier B.V.Item New polypropylene supported chitosan NF-membrane for desalination application(2011) Padaki, M.; Isloor, A.M.; Fernandes, J.; Prabhu, K.N.In the present study, a new NF membrane was prepared by coating chitosan on polypropylene fiber support, by the dissolution of chitosan in 2% acetic acid solution. The resulting membrane was characterized by thermo gravimetric analysis, water absorption, contact angle measurement and scanning electron microscopy. Prepared membrane showed two Tg peaks, one at ~90 °C that was due to chitosan and the other peak at ~170 °C that was corresponding to the supporting polypropylene membrane. The membrane showed a low swelling ratio at pH 7, 9, and 11 as compared with pH 5. The performance of the membrane was assessed out using dead end cell. Water flux was studied at different pressures. The salt rejection study was done using NaCl solution and the effect of pH on performance of the membrane was also examined. Newly prepared membrane showed improved water flux, and % of rejection is highest in acidic pH and lowest in basic pH. Hydrulic permeability coefficient and the dielectric constant confirms that the prepared membrane is nanofiltration membrane. © 2011 Elsevier B.V.Item New CPS-PPEES blend membranes for CaCl2 and NaCl rejection(Techno Press technop2@chollian.net, 2012) Hegde, C.; Isloor, A.M.; Padaki, M.; A.F., A.F.; Lau, L.W.Carboxylated polysulfone (CPS), poly (1,4-phenylene ether ethersulfone) (PPEES), membranes were prepared and used for the separation of NaCl and CaCl2 in efficient way with less energy consumption. In this work, nanofiltration and reverse osmosis membranes were employed to the salt rejection behavior of the different salt solutions. The influence of applied pressure (1-12 bar), on the membrane performance was assessed. In CM series of membranes, CM1 showed maximum of 97% water uptake and 36% water swelling, whereas, CM4 showed 75% water uptake and 28% water swelling. In RCM series, RCM1 showed 85% water uptake and 32% water swelling whereas, in RCM4 it was 68% for water uptake and 20% for water swelling. Conclusively reverse osmosis membranes gave better rejection whereas nanofiltration membrane showed enhanced flux. CM1 showed 58% of rejection with 12L/(m2h) flux and RCM1 showed 55% of rejection with 15L/(m2h) flux for 0.1wt.% NaCl solution. Whereas, in 0.1wt.% CaCl22 solution, membrane CM11 showed 78% of rejection with 12L/(m2h) flux and RCM1 showed 63% rejection with flux of 9L/(m2h).Item Preparation and characterization of polysulfone and modified poly isobutylene-alt-maleic anhydride blend NF membrane(2012) Ganesh, B.M.; Isloor, A.M.; Padaki, M.Recently nanofiltration (NF) is gaining more importance for water treatment. It is replacing the conventional method of water treatment due to advantages of NF membranes over RO system. In this work, we are discussing the preparation of NF membrane for desalination of sea water. We herein report the synthesis of polymer, by the reaction of p-amino benzoic acid (PABA) and poly isobutylene-alt-maleic anhydride (PIAM) and its blend membrane preparation with polysulfone (PSf). The new membranes were characterized by SEM images, surface wettability to investigate the hydrophilic nature of the membrane, water swelling, pure water flux, molecular weight cut-off and salt rejection of the membranes. The membranes showed nano size (<50nm) pores in SEM image, and the contact angle data revealed that membrane surface is moderately hydrophilic. Membrane with 70:30 (PSf:modified PIAM) composition has shown good salt rejection of 96% at 200kPa for 3500ppm of NaCl solution with a pure water flux of 38.36Lm -2h -1. © 2011 Elsevier B.V.Item Favorable influence of mPIAM on PSf blend membranes for ion rejection(Elsevier B.V., 2017) Jyothi, M.S.; Soontarapa, K.; Padaki, M.; Balakrishna, R.G.; Isloor, A.M.The study reports the use of a novel membrane for heavy metal removal and salt rejection. Poly isobutylene alt maleic anhydride (PIAM) modified by sulfanilic acid is blended with polysulfone (PSf) in different concentrations. This induces surface charge and hydrophillicity in the otherwise hydrophobic PSf membranes. The so modified polymers and their blends are characterized by spectroscopic and microscopic techniques. Blend membranes show drastically enhanced performance with respect to water flux, water uptake and ion exchange capacity. SEM micrographs indicate the hydrophilic domains, –SO3H groups in the polymer to have formed cavities during phase inversion process, thus enhancing permeability. 100% rejection of PEG 2000 and 59% of NaCl rejection substantiated the nature of the membrane to be nanofiltration (NF) type. The prepared membranes were further evaluated for Cr (VI) removal, with removal efficiency reaching above 92%. The electronic coupling that occurs between SO3H? and Na+ and the electrostatic interaction between metal ions and the charge on membrane facilitates NaCl and Cr (VI) rejection respectively. The study gains significance in use of such modified PIAM as blend material with any other polymer to enhance the native properties of the blend membrane. © 2017 Elsevier B.V.Item Poly(ionic liquid)-Based charge and size selective loose nanofiltration membrane for molecular separation(Elsevier B.V., 2021) Naik, N.S.; Padaki, M.; Isloor, A.M.; Nagaraja, K.K.; Vishnumurthy, K.A.Separation of chemicals using membranes in smaller size regimes is a much-complicated process. An ideal membrane for molecular separation should be more hydrophilic with well-defined pore sizes for ensuring the selectivity to give a maximum solvent flux. Here, we report a poly(itaconic acid-co-styrene-co-sulfobetaine vinylimidazole) (PIL)/PSf blend selective filtration membrane with nanochannels for superior molecular separation. FESEM images showed asymmetrical membrane structure with a dense upper layer on the hallow spherical sphere, though contact angle measurements reported improved membrane hydrophilicity. Newly developed loose nanofiltration membranes showed a superior removal performance of synthetic dyes based on their size and charge, such as congo red (2.5 × 0.7 nm2 size, 99%) and Eriochrome Black T (1.5 × 0.8 nm2 sizes, 99%). The passage of methyl orange (1.1 × 0.4 nm2) demonstrating an excellent molecular separation capability due to their stable networks of interconnected nanochannel and thin selective layer. The overall results are promising and paving the way for environmental friendly and energy-efficient separation of chemicals through membranes in industrial applications. © 2021