Faculty Publications
Permanent URI for this communityhttps://idr.nitk.ac.in/handle/123456789/18736
Publications by NITK Faculty
Browse
9 results
Search Results
Item Synthesis and desalination performance of Ar+-N+ irradiated polysulfone based new NF membrane(2011) Hegde, C.; Isloor, A.M.; Padaki, M.; Wanichapichart, P.; Liangdeng, Y.In the last few years, membrane technology has gained more attention from polymer chemists throughout the globe. Nowadays, surface modification of membrane is very useful in biotechnology and food science. In the present investigation, we have synthesized polysulfone based composite nanofiltration (NF) membranes, and characterized these membranes by FT-IR, SEM and membrane performance studies. Surface plasma treatment was carried out by irradiation with argon and nitrogen beams in suitable conditions. It was observed that nitrogen beam caused surface roughness that was more severe than the Ar beam. After irradiation, water contact angle was slightly increased. For pure water permeability, flux increased linearly with the operating pressure. However, for the salt solution, the flux was decreased marginally and salt rejection increased after irradiation due to surface modification. The modification effect was characterized in terms of contact angle, AFM employed roughness measurement and dielectric property. It revealed that irradiated NF membranes showed higher salt rejection and lower flux as compared to the nonmodified membranes. Accordingly, the roughness of the membrane surface intensively affected the performance of RO membrane. © 2010 Elsevier B.V.Item Conversion of microfiltration membrane into nanofiltration membrane by vapour phase deposition of aluminium for desalination application(2011) Padaki, M.; Isloor, A.M.; Nagaraja, K.K.; Nagaraja, H.S.; Pattabi, M.Preparation and modification of NF membrane are challenging aspects in research. In the present work, we have synthesised Polysulfone (PSf) microfiltration membrane and reduced the pore size to nano level by physical vapour deposition (PVD) of aluminium metal. Membrane pore size was reduced from micro pore to nano pore, which rejected 42.22% of NaCl from the solution with 164L/m2h. And also water permeation decreases from 1.10324-10-10 to the 9.141-10-12. The SEM and AFM pictures showed the surface modification and metal deposition in the pores. The performance of the membrane was studied by dead end flow cell using 3.5% of NaCl solution, in which PVD membrane showed 42.22% of rejection with 16.4L/m2h flux. Thermal analysis from DSC showed Tg of 265°C. Contact angle measurement, and water uptake were also reported. © 2011 Elsevier B.V.Item New polypropylene supported chitosan NF-membrane for desalination application(2011) Padaki, M.; Isloor, A.M.; Fernandes, J.; Prabhu, K.N.In the present study, a new NF membrane was prepared by coating chitosan on polypropylene fiber support, by the dissolution of chitosan in 2% acetic acid solution. The resulting membrane was characterized by thermo gravimetric analysis, water absorption, contact angle measurement and scanning electron microscopy. Prepared membrane showed two Tg peaks, one at ~90 °C that was due to chitosan and the other peak at ~170 °C that was corresponding to the supporting polypropylene membrane. The membrane showed a low swelling ratio at pH 7, 9, and 11 as compared with pH 5. The performance of the membrane was assessed out using dead end cell. Water flux was studied at different pressures. The salt rejection study was done using NaCl solution and the effect of pH on performance of the membrane was also examined. Newly prepared membrane showed improved water flux, and % of rejection is highest in acidic pH and lowest in basic pH. Hydrulic permeability coefficient and the dielectric constant confirms that the prepared membrane is nanofiltration membrane. © 2011 Elsevier B.V.Item Synthesis, characterization and desalination study of novel PSAB and mPSAB blend membranes with Polysulfone (PSf)(2012) Padaki, M.; Isloor, A.M.; A.F., A.F.; Abdullah, M.S.The present paper describes the synthesis of poly sulphonyl amino benzamide (PSAB) and methyalated poly sulphonyl amino benzamide (mPSAB) polymer, using terephthalic acid chloride and substituted 4-amino-1-benzensulphonmide in N-methyl-. 2-pyrrolidone. Polymers were characterized by FT-IR, NMR and GPC. Polysulfone composite membranes were prepared using these novel poymers by DIPS (Diffusion Induced Phase Seperation) method. These composite membranes are useful for water purification with special emphasis on sea water desalination. Newly prepared membranes were studied for salt rejection, water flux, molecular weight cut off by PEG solution, effect of the pH on water swelling and salt rejection and flux decline was also studied. 30 to 70% of the salt rejection was observed in all membranes. Effect of the dilution on salt rejection was studied using different concentration of NaCl solution varying from 1000. ppm to 3500. ppm. All the membranes showed 80% rejection for PEG having 1000. Da molecular weight. Contact angle and water swelling was measured to determine hydrophilicity of the membrane. Water swelling and salt rejection in different pH was also studied. © 2012 Elsevier B.V.Item Preparation and characterization of sulfonated polysulfone and N-phthloyl chitosan blend composite cation-exchange membrane for desalination(2012) Padaki, M.; Isloor, A.M.; Wanichapichart, P.; A.F., A.F.Sulfonated polysulfone (sPSf) was prepared and used as a polymer matrix for cation-exchange membranes (CEM). The sulfonation reaction was carried out at room temperature and the degree of sulfonation was calculated by titration method. Blend composite membranes were prepared using different ratios of sPSf and modified chitosan (CS). Membrane properties were studied in terms of water flux, water swelling ratio, molecular weight cut off (MWCO), ion-exchange capacity (IEC) and contact angle measurement. Charge on the membrane was confirmed by ionic diffusion potential (DP). It was observed that, DP increased with the increase in the concentration of sPSf. The membrane sPSf:CS 60:40 showed 1000Da MWCO, 14.6mV diffusion potential (DP) and 0.083mM/g of IEC. Similarly sPSf:CS 90:10 showed 10,000Da MWCO, 71.7mV diffusion potential (DP) and 0.176mM/g of IEC. Moreover, membrane sPSf:CS 60:40 showed 93%, 89% and 69% for MgSO 4, Na 2SO 4 and NaCl rejection respectively. © 2012 Elsevier B.V.Item Preparation and characterization of polysulfone and modified poly isobutylene-alt-maleic anhydride blend NF membrane(2012) Ganesh, B.M.; Isloor, A.M.; Padaki, M.Recently nanofiltration (NF) is gaining more importance for water treatment. It is replacing the conventional method of water treatment due to advantages of NF membranes over RO system. In this work, we are discussing the preparation of NF membrane for desalination of sea water. We herein report the synthesis of polymer, by the reaction of p-amino benzoic acid (PABA) and poly isobutylene-alt-maleic anhydride (PIAM) and its blend membrane preparation with polysulfone (PSf). The new membranes were characterized by SEM images, surface wettability to investigate the hydrophilic nature of the membrane, water swelling, pure water flux, molecular weight cut-off and salt rejection of the membranes. The membranes showed nano size (<50nm) pores in SEM image, and the contact angle data revealed that membrane surface is moderately hydrophilic. Membrane with 70:30 (PSf:modified PIAM) composition has shown good salt rejection of 96% at 200kPa for 3500ppm of NaCl solution with a pure water flux of 38.36Lm -2h -1. © 2011 Elsevier B.V.Item Synthesis, characterization and desalination study of composite NF membranes of novel Poly[(4-aminophenyl)sulfonyl]butanediamide (PASB) and methyalated Poly[(4-aminophenyl)sulfonyl]butanediamide (mPASB) with Polysulfone (PSf)(2013) Padaki, M.; Isloor, A.M.; Kumar, R.; A.F., A.F.; Matsuura, T.In the present investigation, Poly [(4-aminophenyl)sulfonyl]butanediamide (PASB) and methylated Poly[(4-aminophenyl)sulfonyl] butanediamide (mPASB) polymers were synthesized, using succinyl chloride and substituted 4-amino-1-benzenesulphonamide. Polysulfone composite membranes were prepared by blending these novel polymers by Diffusion Induced Phase Separation (DIPS) method. The performance of the membrane was studied in terms of salt rejection, water flux and molecular weight cutoff. The prepared membranes were hydrophilic in nature, which was confirmed by water uptake studies and contact angle measurement. All the membranes showed 1000. Da molecular weight cutoff. A maximum NaCl rejection of 52% was observed in some of the membranes. The effect of feed NaCl concentration on the NaCl rejection was also studied. The resistance of the membranes in a wide pH range was studied by water uptake measurement. Antifouling properties of the membranes were also performed using Bovine Serum Albumin (BSA) solution. © 2012 Elsevier B.V.Item Poly(ionic liquid)-Based charge and size selective loose nanofiltration membrane for molecular separation(Elsevier B.V., 2021) Naik, N.S.; Padaki, M.; Isloor, A.M.; Nagaraja, K.K.; Vishnumurthy, K.A.Separation of chemicals using membranes in smaller size regimes is a much-complicated process. An ideal membrane for molecular separation should be more hydrophilic with well-defined pore sizes for ensuring the selectivity to give a maximum solvent flux. Here, we report a poly(itaconic acid-co-styrene-co-sulfobetaine vinylimidazole) (PIL)/PSf blend selective filtration membrane with nanochannels for superior molecular separation. FESEM images showed asymmetrical membrane structure with a dense upper layer on the hallow spherical sphere, though contact angle measurements reported improved membrane hydrophilicity. Newly developed loose nanofiltration membranes showed a superior removal performance of synthetic dyes based on their size and charge, such as congo red (2.5 × 0.7 nm2 size, 99%) and Eriochrome Black T (1.5 × 0.8 nm2 sizes, 99%). The passage of methyl orange (1.1 × 0.4 nm2) demonstrating an excellent molecular separation capability due to their stable networks of interconnected nanochannel and thin selective layer. The overall results are promising and paving the way for environmental friendly and energy-efficient separation of chemicals through membranes in industrial applications. © 2021Item The efficacy of Fe-doped ZrO2 nanoparticles as a supplement in polysulfone membranes for toxic dye removal(Institution of Chemical Engineers, 2024) Manikanta, P.; Naik, N.S.; Isloor, A.M.; Padaki, M.; Nagaraja, B.M.; Déon, S.ZrO2 nanoparticles fine-tuned with iron doping (5%Fe-ZrO2) were incorporated by the phase inversion method as a supplement in polysulfone (PSf) membrane medium for dye rejection. The prepared nanocomposite membranes were examined using a variety of characterisation techniques. The findings showed that adding 5%Fe-ZrO2 nanoparticles into the membrane matrix improved its permeability by reducing the contact angle and increasing hydrophilicity. The PSf nanocomposite membrane containing 1 wt% of 5%Fe-ZrO2 (M2) was found to exhibit a dye rejection efficiency of 99% for Eriochrome black-T (EBT) and 98% for Methylene blue (MB), with a flux of 10.2 ±1 LMH. The manufactured membranes can reject dyes and offer commendable productivity and selectivity, making them a popular choice for membrane applications. © 2024 The Institution of Chemical Engineers